1967 66 Dodge Charger 383 440 Hemi Mopar Clone 100% Rust Free Straight Body on 2040-cars

Auto blog

Common Dodge Ram 1500 vs. Chevrolet Silverado breakdowns

These two trucks are famous for their ability to get the job done. Still, even the toughest vehicle can have mechanical problems at some time. What if we match the Dodge Ram 1500 and Chevrolet Silverado head to head? Let's find out more about common repairs for each model. Also, learn some tricks to pay for car repairs. Clunky Steering Both Dodge and the Chevy owners sometimes notice bumping and clunking when steering. This might be more noticeable when driving over bumps. The cause is usually different in each truck though. In the Dodge Ram, clunky steering is more likely due to a defective lower ball joint. Replacement costs around $300 - $400, parts and labor. Clunky Chevy Silverado steering is probably a steering rack failure. This problem appears more often in trucks with over 90,000 miles. Silverado steering rack repair will run you up to $1,000 or more. Starting Woes For the Chevy Silverado with over 130,000 miles, you might notice trouble starting. This problem may appear occasionally at first, but it typically gets worse. Excluding a weak battery, the culprit is usually the starter. Replacement will cost you around $330 - $500. Of the total cost, $90 is for labor only. Now the Dodge Ram might make a ticking sound when starting, especially on models with over 94,500 miles. The noise often disappears after the engine warms up. These symptoms may indicate a broken exhaust manifold. Repair costs range from $800 - $900. Burning Oil & Gas Gauge On The Blink Sometimes, the Dodge Ram burns oil much faster than normal. In models with over 125,000 miles, this often points towards a leaky intake manifold gasket. A knocking sound may also appear with acceleration along with possible engine misfire. The cost to repair is around $200 - $300. The Chevy Silverado has its own surprises, especially when you've filled the gas tank but the gauge still reads low. Or the needle fluctuates widely from low to full while driving. In trucks with over 120,000 miles, it's likely due to a faulty fuel sensor. You might need a full fuel pump replacement, which can cost you up to $820, parts and labor. Water Inside And Poor Heat The Ram 1500 rear window has been known to leak. You might notice the back seat and floor wet after a rainstorm. This is more common in trucks with over 65,000 miles. Resealing the Ram 1500 rear window costs around $150 - $250.

We're pretty sure the Challenger SRT Demon won't have 1,121 horsepower, but what if?

Dodge's slow rollout of the upcoming Demon continues, and with it comes endless speculation about what it all means. Every video, every image, and every press release contains some clue that points towards the Demon's final specs. We don't think any of it is random or arbitrary. This week cryptic image, a small plate with a name and two numbers, shows us a little more than last week's license plate. Unfortunately, Dodge will neither confirm or deny anything, meaning we have no way of knowing which rabbit hole to go down. Don't expect to see official horsepower, a quarter-mile time, or an MSRP until the New York Auto Show. The plate is attached to the crate of goodies that comes along with every Dodge Demon. This particular one is labeled with three things: Tom Coddington, serial number 0757, and VIN 001121. The name is simple enough. According to Hot Rod, Coddington was one of the original Ramchargers, a group of engineers in the early 1960s that helped Dodge get involved in drag racing. He was a fuel system specialist, motor consultant, and a rotating garage manager. All of that could be clues. While a name is easy enough to Google, the two numbers can't be broken down so easily. The crazier theory is that the car makes 1,121 horsepower and will do the quarter-mile in 7.57 seconds. Frankly, those numbers are about as likely as the Demon actually being powered by a Rolls-Royce turbofan engine from a Boeing 757 or packing a carburetor with 1,121 CFM. The Demon is going to be street legal, and the costs associated with making a 1,121-hp car meet emissions standards alone are assuredly astronomical. As our friends from Road & Track pointed out, the more likely theory is that 757 is actually the horsepower rating. This seems totally plausible, but it means we still don't know what 1,121 means. Surely it's not a drag strip time, as the standard Hellcat will do 1/4 mile in 11.2 seconds. Like before, if you have any ideas, post them in the comments. Until April, we'll keep trying to solve Dodge's demonic puzzle. Related Video: This content is hosted by a third party. To view it, please update your privacy preferences. Manage Settings. News Source: Road & Track, Hot RodImage Credit: FCA New York Auto Show Dodge Coupe Performance dodge demon dodge hellcat

2015 Dodge Challenger SRT Hellcat revving is sonic bacon

This is the Dodge Challenger SRT Hellcat, and we're sure that by now, you know its stats, including over 600 horsepower from its 6.2-liter, supercharged V8. What, pray tell, does that blown engine sound like, though?
At least judging on the sonic strength of this video, it's very, very dirty. Honestly, it sounds unlike anything that's come out of the Chrysler Group in a long time, if ever. It's loud, almost brutally so, with a bark that few road-going V8s can match.
Of course, you should be the final judge here. Take a look and a listen at the two videos below, one of which comes from our friends at Cars.com that provides a nice look under the hood, and then let us know what you think of the Hellcat's singing voice in Comments.