2009 Dodge Challenger Se on 2040-cars

Auto blog

Chrysler recalling 2009-2010 Ram 1500, Dodge Dakota pickups over axle pinion nut

Chrysler is issuing a recall for the 2009 and 2010 Ram 1500 and Dodge Dakota pickup trucks due to improper installation of the rear axle pinion nut. According to the National Highway Traffic Safety Administration, a total of 44,300 trucks are affected by the recall, and there have been 12 confirmed incidents including one crash.
The issue on both trucks is that the pinion nut is loosening on some trucks due to a lack of thread adhesive, and it is causing the rear axle to lock up resulting in loss of vehicle control. NHTSA's recall notice says that eight incidents occurred at speeds over 35 miles per hour and most also exhibited driveshaft failures as well since the loss of the pinion nut would cause the gear to separate from the driveshaft. In one complaint, the driveshaft separated from the rear axle and punctured the gas tank.
Chrysler will begin sending out recall notices to affected owners in November, but scroll down to see the official NHTSA notice.

Dodge bringing revamped Challenger, Charger to Big Apple

The 2014 New York Auto Show will be a big one for Dodge, as the brand has announced that refreshed versions of the 2015 Challenger and 2015 Charger will debut at the show. This is a particularly big deal for the two-door Challenger which, visually, has remained unchanged since is burst back onto the scene in 2008 and helped reignite the muscle car wars.
As a sort of hint, this announcement was accompanied by the picture you see above - the Super Bee logo in the Challenger's new instrument cluster. According to Dodge, the New York debut of a new "powertrain combination" - possibly with the high-output Hellcat V8 - will leave enthusiasts "abuzz."
As for the Charger, Dodge is promising a full redesign that should be a significant departure from the blunt, angry looks of the current model. At this point, there's no indication that the Challenger's new powertrain could be fitted to the Charger, although considering how mechanically similar these two vehicles have been, it doesn't seem outside the realm of possibility.

Dodge Charger Hellcat hitting 60 in 2.9 seconds on drag radials?

The Dodge boys and their cousins from SRT have shoehorned the same 707-horsepower, 6.2-liter supercharged V8 into both the Dodge Challenger and Charger. The former being a two-door, it's lighter than the latter four-door sedan. So it would stand to reason that the Dodge Challenger SRT Hellcat would be the quicker of the two, right?
Only that's not necessarily proving to be the case. On stock rubber, yes, the coupe beats the sedan: Dodge quotes a 0-60 time of 3.7 seconds for the Charger SRT Hellcat and 3.5 for the Challenger. Same gap across the quarter-mile: 11 seconds flat for the Charger versus 10.8 seconds for the Challenger. But according to recent reports, the story changes when you put both on drag radials.
While visiting Chrysler HQ in Auburn Hills, MI, TorqueNews.com caught wind of performance figures for the Charger Hellcat on drag tires: 0-60 in a mind-blowing 2.9 seconds and a quarter-mile in just 10.7. The latter figure just barely pips the Hellcat-powered Challenger's NHRA-certified figure of 10.8, making the Charger not only the fastest sedan on the market, but also the fastest muscle car. What isn't immediately clear, however, is whether the drag radials in question have any tread on them and are street-legal, or if they're pure slicks confined to a closed strip.