We Finance 2004 Chevrolet Suburban 1500 Lt 4wd 1sm Cleancarfax Bose Mroof Towpkg on 2040-cars
Cleveland, Ohio, United States
Body Type:SUV
Vehicle Title:Clear
Engine:8
Fuel Type:Gas
For Sale By:Dealer
Make: Chevrolet
Model: Suburban
Mileage: 107,014
Sub Model: LT 4WD w/1SM/CLEAN CARFAX
Disability Equipped: No
Exterior Color: Blue
Doors: 4
Interior Color: Tan
Drivetrain: Four Wheel Drive
Chevrolet Suburban for Sale
- Lt tv/dvd/xm leather onstar remote start 3rd row sun roof bluetooth aux input(US $35,888.00)
- 1997 chevy suburban
- Nice lifted 1970 chevy suburban truck 4x4 - 350 / at *rare* 67 68 69 71 72 c10
- 2008 chevrolet suburban 1500 ltz sport utility 4-door 5.3l - fully loaded !!!
- 1979 k20 chevrolet suburban 3 / 4 ton 4x4
- 1997 chevy suburban 4x4
Auto Services in Ohio
Weber Road Auto Service ★★★★★
Twinsburg Brake & Tire ★★★★★
Trost`s Service ★★★★★
TransColonial Auto Service ★★★★★
Top Tech Auto ★★★★★
Tire Discounters ★★★★★
Auto blog
Next-gen Chevy Silverado and GMC Sierra may use carbon fiber
Thu, Dec 7 2017It's been generally accepted that the next generation of full-size GM trucks will use some sort of strong, lightweight material for the beds while retaining steel for the cab. While aluminum seems like the most obvious choice, according to Automotive News, the Chevy Silverado and GMC Sierra will incorporate both aluminum and carbon fiber in their beds. The publication cites sources from within GM, though it seems the introduction of this comparatively exotic material mix is still a few years off. While carbon fiber is both stronger and lighter than steel and aluminum, it takes significantly more time and money to produce, essentially relegating the material to small-volume cars. The main benefit for trucks is the resulting reduction in weight to improve fuel economy without sacrificing the tough, rugged capabilities truck buyers expect. The Ford F-150 made the switch to aluminum for the 2015 model year and it's proved highly successful. It seemed like it was only a matter of time before the competition followed suit. Automotive News says that the next-gen trucks will launch with aluminum beds and that it will take a couple of years before we'll see any carbon fiber incorporated into the design. Even then, only look for the composite material on higher-trim models, with a trickle down to lower-spec trucks possible further in the future. In 2011, GM announced it was working with Japan-based Teijin Limited on a carbon fiber reinforced thermoplastic. There's a good chance that material's introduction will be on trucks. Related Video: News Source: Automotive News Plants/Manufacturing Rumormill Chevrolet GM GMC Truck
GM recalls 3,300 pickups and SUVs for new ignition-switch issue [UPDATE]
Mon, Oct 19 2015UPDATE: A statement from GM about the recall has been added below. The exact total of vehicles affected is 3,296, including 3,073 of them in the US. General Motors isn't letting an ignition-switch problem grow into a massive scandal again. The automaker is recalling about 3,300 North American trucks and SUVs. They are: the 2014 Chevrolet Silverado and GMC Sierra and the 2015 Chevy Suburban and Chevy Tahoe, as well as 2015 model heavy-duty pickups, the Detroit News reports, citing an Associated Press story. The issue appears to have been caught fairly quickly. In this case, the keys can get stuck in the "start" position and then slip to "accessory" if bumped. This is because the ignition lock gears have an outer diameter that's larger than the specifications allow. When that happens the engine shuts off, and the driver loses assistance to the steering and brakes. The airbags might also be affected. The vehicles get a new ignition-lock housing to fix the problem. According to the Detroit News, an employee who experienced the problem with the switch discovered the issue, and this person then let officials at the automaker know as part of the Speak Up for Safety program. A total of five reports of the fault were discovered. However, there are no cases of injuries or crashes. The claims to the automaker's resolution program eventually tallied that GM's previous ignition switch problem included 124 deaths and 275 injuries. The company also had to recall millions of vehicles and pay significant fines to the US government. GM Statement General Motors is recalling 3,073 full-size trucks from the 2014 and 2015 model years in the U.S. Some of these vehicles may have an ignition lock actuator gear with an outer diameter that exceeds specifications, which may make turning the ignition key difficult. The ignition key could get stuck in the "start" position. This may be more likely at higher interior ambient temperatures. If the vehicle is driven with the key stuck in the "start" position, and the vehicle experiences a significant jarring event or the vehicle's interior temperature cools, the ignition lock cylinder could move out of the "start" position, rotate past the "run" position, and move into the "accessory" position, leading to loss of power steering assist, power brakes and potentially air bag deployment in certain crashes. Dealers will replace the ignition lock housing.
Chevrolet To Oversee Restoring Sinkhole Corvettes
Fri, Feb 14 2014What Mother Earth devoured, Chevrolet plans to resurrect. The carmaker said Thursday it will oversee restoration of the classic cars swallowed by a huge sinkhole beneath the National Corvette Museum in Kentucky. General Motors Design in Warren, Mich., will manage the painstaking work to repair the eight prize vehicles, the automaker said Thursday. The cars were consumed when the earth opened up early Wednesday beneath a display area when the museum in Bowling Green, Ky., was closed. No injuries were reported. The museum was open Thursday except for the area where the sinkhole occurred. Mark Reuss, GM's head of global product development, said the damaged vehicles rank as "some of the most significant in automotive history." "There can only be one 1-millionth Corvette ever built," he said, referring to one of the damaged cars. "We want to ensure as many of the damaged cars are restored as possible so fans from around the world can enjoy them." Just how the cars will be pulled out of the ground remains to be seen, said museum executive director Wendell Strode. The local fire department estimated the hole is about 40 feet across and 25 to 30 feet deep. The hole opened beneath part of the museum's domed section. "We feel pretty confident that most of the cars can be extracted," Strode said Thursday. "And we hope and believe that with just a little bit of luck, that all eight cars can be extracted and be part of the restoration." Chevrolet spokesman Monte Doran said some of the cars look to be in good shape, while others are buried in rubble. "It will likely be several weeks until we can get the cars out and assessed," he said. The GM Design team has helped restore other historic cars, but the Corvette project looks to be its biggest, he said. "These Corvettes are part of our history, and they want them restored properly," Strode said. "We're thrilled they're doing this." The cars looked like toys as they plunged into the hole, piled in a heap amid dirt and concrete fragments. The museum owns six of the cars while two - a 1993 ZR-1 Spyder and a 2009 ZR1 Blue Devil - are on loan from General Motors. The other cars damaged were a 1962 black Corvette, a 1984 PPG Pace Car, a 1992 White 1 Millionth Corvette, a 1993 Ruby Red 40th Anniversary Corvette, a 2001 Mallett Hammer Z06 Corvette and a 2009 white 1.5 Millionth Corvette. Pictures of the sinkhole showed a collapsed section of floor with multiple cars visible inside the hole.