2008 Chevrolet Silverado 2500 Hd Lt Crew Cab Pickup 4-door 6.0l 4x4 on 2040-cars

Auto blog

Next-gen Chevy Silverado and GMC Sierra may use carbon fiber

It's been generally accepted that the next generation of full-size GM trucks will use some sort of strong, lightweight material for the beds while retaining steel for the cab. While aluminum seems like the most obvious choice, according to Automotive News, the Chevy Silverado and GMC Sierra will incorporate both aluminum and carbon fiber in their beds. The publication cites sources from within GM, though it seems the introduction of this comparatively exotic material mix is still a few years off. While carbon fiber is both stronger and lighter than steel and aluminum, it takes significantly more time and money to produce, essentially relegating the material to small-volume cars. The main benefit for trucks is the resulting reduction in weight to improve fuel economy without sacrificing the tough, rugged capabilities truck buyers expect. The Ford F-150 made the switch to aluminum for the 2015 model year and it's proved highly successful. It seemed like it was only a matter of time before the competition followed suit. Automotive News says that the next-gen trucks will launch with aluminum beds and that it will take a couple of years before we'll see any carbon fiber incorporated into the design. Even then, only look for the composite material on higher-trim models, with a trickle down to lower-spec trucks possible further in the future. In 2011, GM announced it was working with Japan-based Teijin Limited on a carbon fiber reinforced thermoplastic. There's a good chance that material's introduction will be on trucks. Related Video: News Source: Automotive News Plants/Manufacturing Rumormill Chevrolet GM GMC Truck

GM recalling 15k midsize pickups over leaky brakes

General Motors has announced a recall in coordination with the National Highway Traffic Safety Administration related to the brakes on the 2015 Chevy Colorado and GMC Canyon. In the 14,838 units in the United States estimated to be affected, the front brake calipers may be leaking fluid. Needless to say, that could make them less effective, which could hinder the vehicle's ability to stop in time to avoid a collision. The affected units were all manufactured between January 6 and December 24, 2014. The fix seems simple and straightforward enough, with dealers being instructed to inspect the front brake calipers, and replace them if necessary. See below for all the details from NHTSA. RECALL Subject : Brake Fluid Leak Report Receipt Date: MAY 12, 2015 NHTSA Campaign Number: 15V278000 Component(s): SERVICE BRAKES, HYDRAULIC Potential Number of Units Affected: 14,838 Manufacturer: General Motors LLC SUMMARY: General Motors LLC (GM) is recalling certain model year 2015 Chevrolet Colorado, and GMC Canyon trucks manufactured January 6, 2014, to December 24, 2014. The affected vehicles may experience the front brake calipers leaking brake fluid. This is due to air pockets, an imperfection in the metal caliper body. CONSEQUENCE: If the vehicle experiences a brake fluid leak it can increase the stopping distance, increasing the risk of a vehicle crash. REMEDY: GM will notify owners, and dealers will inspect and replace the front-brake calipers if necessary, free of charge. The recall is expected to begin July 10, 2015. Owners may contact GM customer service at 1-800-222-1020 (Chevrolet), or 1-800-462-8782 (GMC). GM's number for this recall is 14888. NOTES: Owners may also contact the National Highway Traffic Safety Administration Vehicle Safety Hotline at 1-888-327-4236 (TTY 1-800-424-9153), or go to www.safercar.gov. Related Video: Featured Gallery 2015 Chevrolet Colorado: First Drive View 38 Photos News Source: National Highway Traffic Safety AdministrationImage Credit: Copyright 2015 Seyth Miersma / AOL Recalls Chevrolet GMC Truck gmc canyon brakes

Recharge Wrap-up: U of M wins Solar Challenge, family attempts record-breaking e-bike ride

The University of Michigan Solar Car Team has won the 2014 American Solar Challenge. It is the team's eighth national championship, its fifth in a row, and its first using Siemens' product lifecycle management (PLM) software. The race took place over 1,722 miles and seven days traveling across eight states. The team's car, called "Quantum," outpaced the nearest competitor by four hours. Looking forward, Michigan Solar Car Project Manager Pavan Naik says, "The switch to Siemens tools will give us the ability to model and simulate everything and truly allow us to optimize the performance of our new vehicle. As we start on our quest to win the World Solar Challenge in 2015, we'll be leveraging a full complement of PLM solutions." Read more in the press release below. The EcoCar3 competition, in which teams will convert Chevrolet Camaros into hybrid electric cars, begins in September. The various college teams will have four years to lessen the car's environmental impact as much as possible while maintaining performance and, of course, that cool Camaro design. EcoCar3, which is put on by the US Department of Energy and General Motors, kicks off with a workshop in Novi, Michigan from September 16 - 18. Read more at the DOE website at the dedicated EcoCar3 site or watch the announcement video at our previous post. Zap and Jonway Auto are shifting to a high rate of EV production. Zap already has two lines creating the Urbee EV to met demand, and is switching over a third to make electric minivans and SUVs. The company aims to produce 30,000 EVs by 2015 for the Chinese market. Zap says it has a backlog of 25,000 Urbee orders. Read more in the press release below. A family of four hopes to make a world record-breaking, 6,000-mile electric bike journey this fall. The family, which recently drove from Argentina to Montana in a pickup with a camper, will ride from Montana to Maine, then down the East Coast to Florida in an attempt to break the record for longest electric bicycle ride. They'll use two bikes. The Father, Thomas, will ride one of the bikes carrying one of the children, while the rest of the family rides in a support vehicle, with the mother, Dylan, riding the second bike when they can find others to drive. They have started a crowdfunding campaign for some of the equipment needed to document the trip. See the video below or read more at Treehugger.