2014 Chevrolet Silverado 1500 Work Truck on 2040-cars

Auto blog

Driving Granatelli's turbine-powered 1978 Chevy Corvette [w/video]

With its curvy snout and feminine haunches, the third-gen Chevrolet Corvette looks like a dreamy – if dated – exemplar of Sports Car Fantasy 101 when viewed through modern eyes. This particular specimen circa '78, clad in silver and black paint with red pinstripes, appears to be a well-preserved example from the era. Apart from its low-profile Pirellis, slightly raised and slotted hood, spacious stance and a certain hand-painted descriptor alongside its crossed flag logos, you'd never guess there's a Space-Age propulsion unit powering this Coke bottle-bodied ride. Climb inside, and you're presented with aircraft gauges and big, colorful square buttons in the center panel. It takes a push of the "Ignitor" button, a tap of the starter button, and a slide of a T-handle for this nearly 40-year-old sports car to start sounding like Gulfstream G650 ready for takeoff. Yep, you're sitting in an 880-horsepower, turbine-powered Corvette, the only one of its kind in the world. Welcome to the whoosh. What The...? Built by Vince Granatelli, son of Indy 500 guru Andy Granatelli, this curious Corvette came into being by cramming a Pratt & Whitney ST6N-74 gas turbine engine into the donor car's lengthy front end. The same type of Jet A-burning mill powered Granatelli Senior's STP-sponsored racecar at the 1967 Indianapolis 500, where it famously led most of the 198 of 200 laps until a $6 transmission bearing failed, knocking it out of the race. The idea of turbine power usurping internal combustion was so threatening that Indy's governing body restricted turbine performance into obsolescence thereafter. A turbine-powered Corvette sounds excessive because it is. But there are also things about this 880-horsepower, 1,161-pound-feet monster that might surprise you. While it smacks of futurist exoticism and cost a then-dizzying $37,000 in 1967, the Canadian-built powerplant uses 80 percent fewer parts than an internal combustion V8 and will run on virtually anything combustible – whiskey, diesel, even Chanel No. 5. Though it's triple the length of a V8, the Pratt & Whitney beast weighs only 285 pounds. It's also one hell of a robust workhorse, typically serving as an auxiliary power unit for commercial aircraft or a generator in oil fields, where it can run for tens of thousands of consecutive hours before needing an overhaul. To adapt the Chevrolet for jet duty, the nose section was gutted and a sub-frame was built to compensate for the loosey-goosey front end.

Cadillac Celestiq, Lyriq, Hummer, other future GM electric cars: Here's everything we saw at ‘EV Day’

WARREN, Mich. — Today, General Motors held an “EV Day” event at its Warren, Michigan, campus to present its new “Ultium” battery technology, modular electric vehicle architecture and soon-to-come electric vehicles. Unfortunately, we were forbidden from bringing cameras into the event, so while we canÂ’t show you what we saw, we can tell you more about it. While we saw the previously teased Cadillac EV (which we now know to be called the Lyriq) and the GMC Hummer pickup teased during the Super Bowl, there were a number of other future cars at the event, which GM President Mark Reuss assured us are all real vehicles in the works. The biggest surprise came at the end of the event, though, in the Cadillac Celestiq electric sedan, which Reuss described as a future flagship that would be hand-built “very locally.” It had been hiding under a dark sheet all morning, with the front and rear illuminated Cadillac emblems shining from underneath. When the wraps came off, we saw a long, white, four-seat fastback sedan. The 23-inch wheels were pushed out to the very corners of the car, giving it what appeared to be a very long wheelbase. The model on the stage had no side mirrors or visible door handles. The grille mirrored that of the Lyriq crossover next to it, with integrated lighting in lieu of the usual mesh or slats youÂ’d see in an internal combustion car. The entire roof, all the way until it tapered to the tail of the vehicle, was tinted glass. In back, vertical tail lighting ran down the C-pillar before turning rearward across the top of the trunk. Inside, everything below the beltline of the windows — essentially all but the headrests and top portion of the steering wheel, was hidden from view. Behind the Celestiq, a large digital display showed a rendering of its interior. The dash consists of a pillar-to-pillar curved LED display serving as both instrument panel and infotainment system. Protruding forward between the front seats was another touchscreen that appeared to house some more controls, with open area, probably for storage, below it. The rear seats had the same sort of touchscreen between them. Built into the back of the front seats were a pair of rear-seat entertainment screens, much like we saw in the Lyriq. The door panels blended wood, metal and animated lighting to give character and a sense of opulence. GM interior design manager Tristan Murphy was on hand to tell us a bit more about the Celestiq.

Who sold the most heavy-duty pickups in 2012? PickupTrucks.com investigates

Domestic manufacturers enjoyed a good year for heavy-duty pickup sales in 2012. PickupTrucks.com has taken a close look at exactly how those sales broke down between each manufacturer and between three-quarter and one-ton pickups. Ford sold some 67,786 F-250 Super Duty models last year with the Chevrolet Silverado 2500 HD falling just behind at 56,359 units. The Ram 2500 HD came in third at 41,918, while the GMC Sierra 2500 HD earned itself fourth place with 27,616 deliveries. While Ford held onto the top spot in the one-ton market, Ram easily nailed down second place by selling more 3500 HD models last year than General Motors sold Silverado 3500 HD and Sierra 3500 HD trucks combined.
So, did GM manage to sell more trucks than Ford with its two brands? Very nearly. Ford sold a total of 119,338 heavy-duty pickups to GM's 111,555. Ram, meanwhile, moved a distant 77,583. But perhaps more interesting is the diesel take rate in this segment. PickupTrucks.com says 80 percent of all domestic one-ton trucks roll from the dealer lot with a turbo-diesel under the hood. Head over to the site for a closer look at the breakdown.