2014 Chevrolet Silverado 1500 on 2040-cars

Auto blog

Common Dodge Ram 1500 vs. Chevrolet Silverado breakdowns

These two trucks are famous for their ability to get the job done. Still, even the toughest vehicle can have mechanical problems at some time. What if we match the Dodge Ram 1500 and Chevrolet Silverado head to head? Let's find out more about common repairs for each model. Also, learn some tricks to pay for car repairs. Clunky Steering Both Dodge and the Chevy owners sometimes notice bumping and clunking when steering. This might be more noticeable when driving over bumps. The cause is usually different in each truck though. In the Dodge Ram, clunky steering is more likely due to a defective lower ball joint. Replacement costs around $300 - $400, parts and labor. Clunky Chevy Silverado steering is probably a steering rack failure. This problem appears more often in trucks with over 90,000 miles. Silverado steering rack repair will run you up to $1,000 or more. Starting Woes For the Chevy Silverado with over 130,000 miles, you might notice trouble starting. This problem may appear occasionally at first, but it typically gets worse. Excluding a weak battery, the culprit is usually the starter. Replacement will cost you around $330 - $500. Of the total cost, $90 is for labor only. Now the Dodge Ram might make a ticking sound when starting, especially on models with over 94,500 miles. The noise often disappears after the engine warms up. These symptoms may indicate a broken exhaust manifold. Repair costs range from $800 - $900. Burning Oil & Gas Gauge On The Blink Sometimes, the Dodge Ram burns oil much faster than normal. In models with over 125,000 miles, this often points towards a leaky intake manifold gasket. A knocking sound may also appear with acceleration along with possible engine misfire. The cost to repair is around $200 - $300. The Chevy Silverado has its own surprises, especially when you've filled the gas tank but the gauge still reads low. Or the needle fluctuates widely from low to full while driving. In trucks with over 120,000 miles, it's likely due to a faulty fuel sensor. You might need a full fuel pump replacement, which can cost you up to $820, parts and labor. Water Inside And Poor Heat The Ram 1500 rear window has been known to leak. You might notice the back seat and floor wet after a rainstorm. This is more common in trucks with over 65,000 miles. Resealing the Ram 1500 rear window costs around $150 - $250.

Dodge vs. Chevy tug-of-war taken to the extreme

They say "idle hands are the devil's playground," but said playgrounds grow to Disney-sized proportions when a pair of jacked-up trucks, two egos, a chain and an empty mall parking lot are involved. Proof of this is the video below, which shows a Cummins-powered Dodge Ram circa 2006 to 2008 chained tail-to-tail with what looks to be a gasoline-powered Chevrolet Silverado from the late 1990s or early 2000s.
We don't necessarily have to tell you who wins this battle, but we'll let you see for yourself the lengths the "winning" driver goes to prove his point. There's plenty of foul language in the video below, so beware that this might be Not Safe For Work, and not that we should have to tell you, but please, do not try this at home.

GM to invest $150 million in Flint to boost heavy-duty pickup production

FLINT, Mich. — General Motors President Mark Reuss said on Wednesday that the automaker is investing about $150 million at its Flint Assembly plant in Michigan to boost production of heavy duty trucks by another 40,000 vehicles a year. Reuss announced the investment at the Flint truck assembly plant wearing a United Auto Workers pin. The Detroit automaker had announced back in February it was adding 1,000 jobs in Flint to build a new generation of heavy-duty pickup trucks. GM did not say that the latest investment would add more jobs at the plant, but Reuss said there could be opportunities to add workers as the launch of the automaker's new trucks progresses. GM has been under pressure from President Donald Trump and lawmakers of both parties to add jobs in the United States after it said last November it would idle the Chevy Cruze assembly plant in Lordstown, Ohio, and likewise had no new products for three other U.S. manufacturing plants. The Flint investment will include upgrades to the plant's conveyors and other new tooling, and will be completed in the first half of 2020. GM has invested more than $1.6 billion in the plant since 2013. Last month, GM said it would invest $24 million to increase truck production at its assembly plant in Fort Wayne, Indiana, which makes Chevrolet Silverado and GMC Sierra models. Sales of heavy-duty pickups in the United States have grown to more than 600,000 vehicles a year, up more than 20 percent since 2013, according to industry data. Prices for luxury models can easily top $70,000. GM's Chevrolet and GMC brands have long trailed Ford's F-series heavy duty trucks in the lucrative segment. The new Chevrolet and GMC heavy duty trucks have been re-engineered to tow heavier trailers, and keep pace in what has become an arms race among the Detroit Three automakers to claim superior torque and towing capability. Related: Silverado HD vs. 2019 Ram, Ford heavy duty trucks: How they compare on paper