Government Work Truck 2.2 4 Cyl. Auto 24-29 Mpg Ice Cold Ac Drive It Anywhere $ on 2040-cars

Auto blog

How GM engineers are using diaper 'snow' to keep you warm

Testing how snow affects General Motors' vehicles isn't really a problem right now for the company's engineers, but in the dog days of summer the process isn't exactly easy. The only real option is for them to book time at the automaker's climatic wind tunnel. However, a flash of brilliance from an engineer allows snow to be simulated regardless of the temperature outside, and the discovery is all because of his daughter's wet diaper. The realization came to GM Thermal Systems engineer Nicholas Jahn while he was swimming with his daughter and noticed how her diaper ballooned in size in the water. He found out the substance that makes this possible is called sodium polyacrylate. When the material gets wet it grows and forms fluffy flakes that are a close imitation of snow. Best of all, the stuff can be prepared easily any time of the year, and it's reusable. The engineering team uses the material to test the effectiveness of the heating systems of GM's vehicles. They spread the sodium polyacrylate over the inlets at the base of the windshield to obstruct the airflow and then crank the heater. After some time, they can see how much is being sucked into the system and design more efficient systems in the future. See how the process works in the video above and read about the diaper discovery in GM's press release below. Diapers Change Chevy Cruze Winter Warm-up Time GM validation engineer uses diaper material "snow" to reduce frigid drives 2015-01-06 DETROIT – An item commonly found on an infant's changing table is helping General Motors' engineers simulate snow year round, ensuring heating systems in cars like the 2015 Chevrolet Cruze can quickly and efficiently warm its interior. Packed snow can prevent air from entering the inlet panel at the bottom of the windshield, obstructing the flow of air into the heating system and reducing the amount of air it can push out. This can lead to less efficient warming of the car's interior and windshield defrosting. "The last thing anyone wants to do when it's freezing cold out is scrape their windshield," said Nicholas Jahn, GM Vehicle Thermal Systems engineer. "The testing we perform on the Chevrolet Cruze with the diaper material allows us to maximize the car's heating capabilities." Ironically, Jahn stumbled upon his diaper-based testing method in the middle of summer. During a swim with his daughter, he noticed her diaper multiplied in size when it came into contact with water.

Final C6 Corvette built in Bowling Green

With all of the attention given to the 2014 Chevrolet Corvette Stingray lately, you could be forgiven for thinking that it's already well along in production, yet tooling up for the new C7 has only just begun. In fact, production of the outgoing C6 generation in Bowling Green, Kentucky just halted on Thursday.
As the C6 has aged, production numbers have predictably ebbed along with demand, but this year, the addition of the 427 and 60th anniversary models resulted in an uptick in vehicles built - this, despite a model year shortened by around 25 percent to accomodate the new model changeover. The final C6 Corvette ever, No. 13,466 built this year, was a white 427 Convertible destined for the General Motors Heritage Center museum. The car's 7.0-liter V8 heart was assembled by Corvette chief engineer Tadge Juechter himself.
In total, Bowling Green pushed out 215,100 C6 Corvettes over nine years. If you're still a C6 fan at heart and are hoping to get a good deal on a phase-out model, step lively - Chevrolet reportedly had about 6,100 unsold units, which Autoweek suggests is good for around five and a half months of supply at the model's current sales rates. Given that demand will likely slacken even further as the C7 draws closer, that should be a big enough stockpile to keep dealers satisfied until 2014 Stingrays begin showing up on their forecourts in December.

Chevy Volt has worst sales month since August 2011, Nissan Leaf also down

January is traditionally a time when new car shoppers take a break. For the last few years, if we isolate our focus to just the first two major plug-in cars in the US market, we see that the first month of the year was lower – often dramatically lower – than the 11 that followed. So, when you see the Chevy Volt dropped and Nissan Leaf sales figures for January 2015, don't be too surprised. The Volt sold only 542 units last month, that model's lowest since August 2011. That also represents a 41 percent drop from January 2014, and it reinforces the thought that if anyone out there is interested in a new Volt, they're going to be waiting for the new model to drop later this year. While we do expect sales to climb in February and into spring, we won't be surprised if the general Volt trend remains quiet until the second-generation arrives. On the Leaf side of the ledger, January's low sales numbers were still about twice as high as the Volt's – the Leaf sold 1,070 units last month, the lowest since February 2013 – but it did break a streak for the Japanese automaker. Usually, each month represents at least an increase over the same month a year ago, but that wasn't the case this time. In January 2014, Nissan sold 1,252 Leafs. Still, Brendan Jones, Nissan's director of electric vehicle sales and infrastructure, issued an upbeat statement: "We saw a significant increase in demand in December from Nissan Leaf customers looking to take advantage of federal and state incentives at the end of the tax year, which pulled some sales ahead. We're confident that EV sales will continue to rise over time due to increasing emission regulations and other reasons for purchase of EVs such as lower operating costs, reducing dependence on foreign energy sources, environmental concerns and a great driving experience." The numbers will tell us soon enough. News Source: General Motors, Nissan Green Chevrolet Nissan Electric Hybrid ev sales brendan jones