1957 Chevy Truck 3200 on 2040-cars
Shingle Springs, California, United States
No Reserve Auction! 1957 Chevy Truck 3200 1/2 Ton (123 1/4 wheel base) 283 V8, Automatic Trans, 2wd, manufactured in Oakland Ca. Purchased as a project to put body on a newer 4x4 chassis. It was too nice to chop up so I used another truck, now I don't need this one. No major rust or alignment issues, front panel of bed was replaced with a new one, transmission has been upgraded, truck runs and drives enough to load for transportation but not to drive across country. Started stripping fenders, metal is nice and clean, will primer bare metal before shipping. Perfect candidate for restoration, a true The Good: Truck is straight and unmolested, floor pans and running boards solid. Front windshield is nice and clean, drip rails un-rusted, grille is not rotted out, frame has not been cut. The Bad: Driver door needs a new skin due to damage, no rear bumper, radio hole in dash needs some attention, ignition sticks, needs new wood in bed. I reserve the right to end the auction at any time as the vehicle was listed for sale locally and is subject to prior sale. Vehicle is being sold as is, where is, without warranty, please come check out the vehicle and verify info listed above. Truck will be sold with bill of sale only. Attn
|
Chevrolet Other Pickups for Sale
- 1957 chevrolet big window shortbox
- 53 chevy rat rod pickup truck(US $22,000.00)
- 1956 chevy blown pro touring pick up truck/chevrolet blower hot rod drag
- Frame off restored 1947 chevrolet 3100(US $29,900.00)
- 1950 chevrolet 3100 shortbed pick up - las vegas - gorgeous body off restoration
- 1955 chevy pickup truck 3100 3200 3600 apache 55
Auto Services in California
Zip Auto Glass Repair ★★★★★
Woodland Motors Chevrolet Buick Cadillac GMC ★★★★★
Willy`s Auto Repair Shop ★★★★★
Westside Body & Paint ★★★★★
Westcoast Autobahn ★★★★★
Westcoast Auto Sales ★★★★★
Auto blog
The Opel GT is the concept General Motors should build for the US
Sat, Feb 27 2016Now is the time. General Motors should double-down on performance cars and build the Opel GT concept that's set to debut next week at the Geneva Motor Show. Better yet, sell it in the United States as the Chevy GT. Consumers are showing a thirst for performance cars not seen in decades. Ford has them coming in waves, with everything from the F-150 Raptor to a hotted-up Fusion. FCA US is unrepentantly building loads of Hellcats. GM should respond. The General's cupboard is hardly bare. With the Corvette, Camaro, and Cadillac's V-Series, GM has more than enough to compete with its crosstown rivals and anything Europe or Japan can throw at it. But there's also an opportunity. There's not many front-mid-engine, rear-wheel-drive, two-seat sports cars out there like the Opel GT concept. A Chevy GT that used that layout and captured some of the concept car's proportions and curves would ignite a different kind of passion in enthusiasts. It would be Miata-like. With Chevy branding, this sports car would be the everyday exotic. The concept has a turbocharged 1.0-liter three-cylinder engine, which makes about 143 horsepower to motivate a structure that weighs less than 2,200 pounds. It can hit 60 miles per hour in less than eight seconds. All of those numbers are within the front-engined Miata's territory. This new Opel is inspired by two great mid-1960s concepts that helped put its design studio, and that of its sister brand, the British Vauxhall, on the map. (The GT concept is also technically a Vauxhall, as the brands are linked in GM's European strategy.) One of them, the '66 Vauxhall XVR remained a concept. The '65 Opel Experimental GT was on the road by 1968. That shows this is doable. There's precedent. The Saturn Sky and Pontiac Solstice shared a chassis with a modern GT during that trio's brief run. If GM ever makes this concept, Opel and Vauxhall should get their versions. But Chevy is the one that could make this car a global icon. Chevrolet GT. Make it happen. News & Analysis News: The potential return of the Ford Bronco is generating a ton of attention. Analysis: That's not news, per se. But when the Bronco6G.com fan site did a rendering of a next-generation Bronco, it almost broke the Internet. Everyone from Automotive News to Jalopnik picked up the illustrations. Our own post has drawn a lot of traffic and passionate responses. People are clamoring for the Bronco's return.
Our favorite mid-engine Corvette theories and rumors
Tue, Sep 13 2016The mid-engine Corvette! We just saw blurry photos through the foliage, and are hearts are all aflutter because it means that this car is real. And it's the most " never before" Corvette since 1984. Which leads us to all kinds of wacky theories and speculation. Everybody knows something or heard from a guy. None of those guys (or gals) from GM are talking to Autoblog, to be clear. But that won't stop us from stirring the pot. Let's go over a few point-by-point. The pushrod engine will be replaced by an overhead-cam V8 Car and Driver has repeatedly reported that an overhead-cam engine will come after the mid-engine Corvette's debut with an old-school pushrod. We've heard the same thing firsthand, albeit from a source with no connection to the development of the Corvette or powertrain. "At some point two valves can't pass future emissions regulations," said the guy we know. While the pushrod engine is compact, the design makes it difficult - if not impossible - for sophisticated variable valve timing (and lift) systems that control combustion with more precision. Hasty conclusion: The pushrod engine has a finite life in front of it. This one's a lock, it's a just a matter of when. Bowling Green's new paint shop is really the mid-engine assembly line Credit to Reddit for this one. Like we said, everybody knows a guy. But let's look deeper. The new paint facility costs $439 million dollars and adds 450,000 square feet, almost half the size of the existing plant. Plus GM announced another $290 million in upgrades at Bowling Green Assembly. That sure sounds like a lot of money, but you can actually spend that much on a paint booth. Porsche spent 500 million Euros (about $561 million dollars) to add the Macan assembly to its Leipzig, Germany plant in 2014. Chrysler shelled out $850 million for a paint shop in Sterling Heights, Michigan. GM spent $600 million for a new paint shop at the Fairfax (Kansas City) plant. Honda, on the other hand, is working on a thrifty $210 million project in Marysville, Ohio that includes a 300,000 square foot expansion, and the low-volume Acura NSX facility only cost $70 million. Hasty conclusion: The square footage and cost could easily mean a new assembly line instead of (or in addition to) a paint line. And if the NSX plant was really that cheap, GM could have hidden a similar sum in its existing announcements.
GM admits goal of 500,000 EVs by 2017 won't be met
Sat, May 9 2015After a little over four years of Chevy Volt sales, General Motors has a better handle on how many people it expects will buy cars with plugs. And it's less than the company thought back in 2012, when then-senior vice president of global product development, Mary Barra, said that GM expected to sell 500,000 "vehicles with electrification" by 2017. In a sustainability report released this week, GM says that half-million vehicle target will not be met but that it still, "believes the future is electric." In the report, GM says that, "For our commitment to electrification, our forecasted outlook currently projects us, along with the broader automotive industry, falling short of expectations for 2017. ... We continue to aspire to our stated goal." GM's electric lineup includes the Volt, the recently popular Spark EV, the slow-selling Cadillac ELR and upcoming Malibu Hybrid, CT6 plug-in hybrid and eAssist technology in the Buick LaCrosse and Regal. GM says it has 180,834 electrified vehicles on the road in the US today. In 2013, it had 153,034; 95,578 in 2012, and 39,843 in 2011. The company's next big plug-in vehicle will be the second-gen Chevy Volt, which is coming to market later this year, followed by the 200-mile Bolt EV coming, we think, in 2017. GM Employees on Mission to Transform Transportation Sustainability report outlines vehicle and manufacturing progress; sets new targets 2015-05-07 DETROIT – General Motors' just-released sustainability report chronicles efforts by the company's 216,000 employees to live out GM's newly defined purpose and values by earning customer loyalty, applying meaningful technology advances and improving the communities where it does business. These actions – led by CEO Mary Barra – further drive sustainability into the company's culture through building safer and smarter vehicles with less environmental impact. "GM will take a leading role in the auto industry's transformation as it undergoes an unprecedented period of change," said Bob Ferguson, senior vice president, GM Global Public Policy. "From GM's labs to its assembly lines, our people are driving the world to a better place through improved mobility." The company believes the future is electric, with billions of investment to support an all-in-house approach to the development and manufacturing of electrified vehicles. It now counts 180,834 on the road in the U.S – up from 153,034 in 2013.