1955 Chevrolet 3100 First Series on 2040-cars
Eustis, Florida, United States
Body Type:Pickup Truck
Engine:235 Straight Six
Vehicle Title:Clear
Fuel Type:Gasoline
For Sale By:Private Seller
Interior Color: Black
Make: Chevrolet
Number of Cylinders: 6
Model: Other Pickups
Trim: chrome
Drive Type: Rear 2WD
Mileage: 22,086
Sub Model: 1/2 Ton
Number of Doors: 2
Exterior Color: Red
Warranty: Unspecified
Chevrolet Other Pickups for Sale
Auto Services in Florida
Xtreme Car Installation ★★★★★
White Ford Company Inc ★★★★★
Wheel Innovations & Wheel Repair ★★★★★
West Orange Automotive ★★★★★
Wally`s Garage ★★★★★
VIP Car Wash ★★★★★
Auto blog
GM recalls 3,300 pickups and SUVs for new ignition-switch issue [UPDATE]
Mon, Oct 19 2015UPDATE: A statement from GM about the recall has been added below. The exact total of vehicles affected is 3,296, including 3,073 of them in the US. General Motors isn't letting an ignition-switch problem grow into a massive scandal again. The automaker is recalling about 3,300 North American trucks and SUVs. They are: the 2014 Chevrolet Silverado and GMC Sierra and the 2015 Chevy Suburban and Chevy Tahoe, as well as 2015 model heavy-duty pickups, the Detroit News reports, citing an Associated Press story. The issue appears to have been caught fairly quickly. In this case, the keys can get stuck in the "start" position and then slip to "accessory" if bumped. This is because the ignition lock gears have an outer diameter that's larger than the specifications allow. When that happens the engine shuts off, and the driver loses assistance to the steering and brakes. The airbags might also be affected. The vehicles get a new ignition-lock housing to fix the problem. According to the Detroit News, an employee who experienced the problem with the switch discovered the issue, and this person then let officials at the automaker know as part of the Speak Up for Safety program. A total of five reports of the fault were discovered. However, there are no cases of injuries or crashes. The claims to the automaker's resolution program eventually tallied that GM's previous ignition switch problem included 124 deaths and 275 injuries. The company also had to recall millions of vehicles and pay significant fines to the US government. GM Statement General Motors is recalling 3,073 full-size trucks from the 2014 and 2015 model years in the U.S. Some of these vehicles may have an ignition lock actuator gear with an outer diameter that exceeds specifications, which may make turning the ignition key difficult. The ignition key could get stuck in the "start" position. This may be more likely at higher interior ambient temperatures. If the vehicle is driven with the key stuck in the "start" position, and the vehicle experiences a significant jarring event or the vehicle's interior temperature cools, the ignition lock cylinder could move out of the "start" position, rotate past the "run" position, and move into the "accessory" position, leading to loss of power steering assist, power brakes and potentially air bag deployment in certain crashes. Dealers will replace the ignition lock housing.
Camaro spy shots show subtly different grille, front fascia
Sun, 03 Feb 2013It looks like there some changes in store for the Chevrolet Camaro - the only thing is that we just don't know what Chevy has up its sleeve. Looking at these spy shots, we'd initially be inclined to think that there is just a minor facelift or a new special edition, but upon closer inspection, there are a few oddities about this car that definitely have us intrigued.
The most obvious difference on this prototype is the slightly restyled front fascia with a smaller lower air inlet and the two-bar grille. Then we get to some of the car's mysterious details. For starters, this fascia has the SS vent above the grille, but it looks to be blocked off. Granted this could just be a one-off piece used for testing. What really piqued our interest was at the rear of the car where it has quad exhaust outlets that are used on the ZL1. Could this be the LS7-powered Camaro that we reported on back in December?
At this point, your guess is as good as ours as to what we're looking at here, so let us know in the comments what you think this could be.
This is how GM is hiding new Chevy Volt in public
Wed, Oct 1 2014General Motors is letting the public know that, well, it's not about to let the public know anything else about the next-generation Chevrolet Volt. But the automaker is willing to talk about its camouflaging process for upcoming versions of the extended-range plug-in. So it's a half-hearted secret, at best. GM actually has a "camouflage engineer" charged with creating ways to disguise the styling of new vehicles. In the Volt's case, the company is applying black and white swirly color patterns on top of the materials, such as plastics, vinyl and foam, that are used liberally across the body. It's all part of a teaser campaign that started last month with pictures of part the 2016 Volt. Earlier this month, GM said it was keeping track of Volt drivers' habits as it works on the next-gen model. The company noted that more than four out of five trips are being made in all-electric driving mode, and that 60 percent of Volt owners use a plain-old 100-volt outlet to recharge their cars. The car is slated to make its global debut at Detroit's North American International Auto Show next January, and the early word is that performance and all-electric range will be improved (we should hope so). The car will also be sleeker. By how much, we can't tell yet, because of those darn swirly patterns. GM's got more non-details in its press release below. Engineers charged with hiding styling while vehicle testing proceeds in public DETROIT – The styling of the next-generation Chevrolet Volt is one of the automotive world's best-kept secrets. Keeping customers and media eager to see the successor to the groundbreaking original at bay until the new Volt debuts at the North American International Auto Show in Detroit in January is tricky business. First, it is engineers, not designers, who are charged with creating camouflage that balances styling secrecy with the need to validate the Volt and its systems in public. "If it were up to me it would be a shoebox driving down the road," said Lionel Perkins, GM camouflage engineer. "The design team wants us to cover more of the vehicle and the engineering team needs to have enough of the vehicle's weight and aero exposed so that the tests in the development process are consistent with the product that will come to market." The engineers responsible for the "cool" designs covering the car might deserve style points but their efforts are intended strictly to hide the metal beneath.