1946 Chevy Panel Truck on 2040-cars
Orlando, Florida, United States
Body Type:panel truck
Engine:350
Vehicle Title:Clear
Mileage: 99,999
Make: Chevrolet
Sub Model: panel truck
Model: Other Pickups
Trim: panel truck
Drive Type: RWD
Chevrolet Other Pickups for Sale
- 1951 chevy 4x4 truck
- Modified updated 1980 chevy short bed truck
- Rat rod gasser hot rod drag car pro street pick-up truck
- 1933 chevrolet truck canopy express chevy rare jalopy pickup hot rat rod 32 31
- 1948 to 1954 chevy truck 3100 1/2 ton chassis(US $3,500.00)
- 1970 chevy k10 shortbed 4x4 pick up(US $19,000.00)
Auto Services in Florida
Y & F Auto Repair Specialists ★★★★★
X-quisite Auto Refinishing ★★★★★
Wilt Engine Services ★★★★★
White Ford Company Inc ★★★★★
Wheels R US ★★★★★
Volkswagen Service By Full Throttle ★★★★★
Auto blog
Common Dodge Ram 1500 vs. Chevrolet Silverado breakdowns
Wed, May 4 2016These two trucks are famous for their ability to get the job done. Still, even the toughest vehicle can have mechanical problems at some time. What if we match the Dodge Ram 1500 and Chevrolet Silverado head to head? Let's find out more about common repairs for each model. Also, learn some tricks to pay for car repairs. Clunky Steering Both Dodge and the Chevy owners sometimes notice bumping and clunking when steering. This might be more noticeable when driving over bumps. The cause is usually different in each truck though. In the Dodge Ram, clunky steering is more likely due to a defective lower ball joint. Replacement costs around $300 - $400, parts and labor. Clunky Chevy Silverado steering is probably a steering rack failure. This problem appears more often in trucks with over 90,000 miles. Silverado steering rack repair will run you up to $1,000 or more. Starting Woes For the Chevy Silverado with over 130,000 miles, you might notice trouble starting. This problem may appear occasionally at first, but it typically gets worse. Excluding a weak battery, the culprit is usually the starter. Replacement will cost you around $330 - $500. Of the total cost, $90 is for labor only. Now the Dodge Ram might make a ticking sound when starting, especially on models with over 94,500 miles. The noise often disappears after the engine warms up. These symptoms may indicate a broken exhaust manifold. Repair costs range from $800 - $900. Burning Oil & Gas Gauge On The Blink Sometimes, the Dodge Ram burns oil much faster than normal. In models with over 125,000 miles, this often points towards a leaky intake manifold gasket. A knocking sound may also appear with acceleration along with possible engine misfire. The cost to repair is around $200 - $300. The Chevy Silverado has its own surprises, especially when you've filled the gas tank but the gauge still reads low. Or the needle fluctuates widely from low to full while driving. In trucks with over 120,000 miles, it's likely due to a faulty fuel sensor. You might need a full fuel pump replacement, which can cost you up to $820, parts and labor. Water Inside And Poor Heat The Ram 1500 rear window has been known to leak. You might notice the back seat and floor wet after a rainstorm. This is more common in trucks with over 65,000 miles. Resealing the Ram 1500 rear window costs around $150 - $250.
First privately owned Corvette Stingray blitzes 1/4 mile in 12.23 at 114.88 mph
Tue, 01 Oct 2013Chevrolet's latest road rocket, the Corvette Stingray, is a very quick car. If one needs further proof of that, we recommend they take a look at this video from Hennessey of what is claimed to be the first privately owned C7 Corvette to make a pass down the quarter mile. Not just any quarter mile, mind, this black C7 blitzed its way down the tuner's primary testing dragstrip. The Chevrolet ran the quarter in just 12.23 seconds at 114.88 miles per hour. That is a very quick time for a stock car.
Equipped with the Z51 package and a six-speed automatic transmission, not only does the C7 run a solid time, but it does so with little to no drama. That won't last though, as Hennessey will likely return it to its owner with far more power - we just hope they show a drag run of the completed product. Take a look below to watch the C7's 12.23-second run on video.
GM won't really kill off the Chevy Volt and Cadillac CT6, will it?
Fri, Jul 21 2017General Motors is apparently considering killing off six slow-selling models by 2020, according to Reuters. But is that really likely? The news is mentioned in a story where UAW president Dennis Williams notes that slumping US car sales could threaten jobs at low-volume factories. Still, we're skeptical that GM is really serious about killing those cars. Reuters specifically calls out the Buick LaCrosse, Cadillac CT6, Cadillac XTS, Chevrolet Impala, Chevrolet Sonic, and the Chevrolet Volt. Most of these have been redesigned or refreshed within the past few model years. Four - the LaCrosse, Impala, CT6, and Volt - are built in the Hamtramck factory in Detroit. That plant has made only 35,000 cars this year - down 32 percent from 2016. A typical GM plant builds 200,000-300,000 vehicles a year. Of all the cars Williams listed, killing the XTS, Impala, and Sonic make the most sense. They're older and don't sell particularly well. On the other hand, axing the other three seems like an odd move. It would leave Buick and Cadillac without flagship sedans, at least until the rumored Cadillac CT8 arrives. The CT6 was a big investment for GM and backing out after just a few years would be a huge loss. It also uses GM's latest and best materials and technology, making us even more skeptical. The Volt is a hugely important car for Chevrolet, and supplementing it with a crossover makes more sense than replacing it with one. Offering one model with a range of powertrain variants like the Hyundai Ioniq and Toyota Prius might be another route GM could take. All six of these vehicles are sedans, Yes, crossover sales are booming, but there's still a huge market for cars. Backing away from these would be essentially giving up sales to competitors from around the globe. The UAW might simply be publicly pushing GM to move crossover production to Hamtramck to avoid closing the plant and laying off workers. Sales of passenger cars are down across both GM and the industry. Consolidating production in other plants and closing Hamtramck rather than having a single facility focus on sedans might make more sense from a business perspective. GM is also trying to reduce its unsold inventory, meaning current production may be slowed or halted while current cars move into customer hands. There's a lot of politics that goes into building a car. GM wants to do what makes the most sense from a business perspective, while the UAW doesn't workers to lose their jobs when a factory closes.