2014 Chevrolet Malibu 1lt on 2040-cars

Auto blog

Next-gen Chevy Silverado and GMC Sierra may use carbon fiber

It's been generally accepted that the next generation of full-size GM trucks will use some sort of strong, lightweight material for the beds while retaining steel for the cab. While aluminum seems like the most obvious choice, according to Automotive News, the Chevy Silverado and GMC Sierra will incorporate both aluminum and carbon fiber in their beds. The publication cites sources from within GM, though it seems the introduction of this comparatively exotic material mix is still a few years off. While carbon fiber is both stronger and lighter than steel and aluminum, it takes significantly more time and money to produce, essentially relegating the material to small-volume cars. The main benefit for trucks is the resulting reduction in weight to improve fuel economy without sacrificing the tough, rugged capabilities truck buyers expect. The Ford F-150 made the switch to aluminum for the 2015 model year and it's proved highly successful. It seemed like it was only a matter of time before the competition followed suit. Automotive News says that the next-gen trucks will launch with aluminum beds and that it will take a couple of years before we'll see any carbon fiber incorporated into the design. Even then, only look for the composite material on higher-trim models, with a trickle down to lower-spec trucks possible further in the future. In 2011, GM announced it was working with Japan-based Teijin Limited on a carbon fiber reinforced thermoplastic. There's a good chance that material's introduction will be on trucks. Related Video: News Source: Automotive News Plants/Manufacturing Rumormill Chevrolet GM GMC Truck

Camaro-based Trans Am SE Bandit Edition borrows Burt Reynolds

For some reason, modifying modern Chevrolet Camaros into the lurching, reincarnated shells of the Pontiac brand is still a thing. If you're the perverse sort that likes this kind of thing, you should check out the latest product from the Trans Am Depot, which comes complete with an endorsement from the star of Smokey and the Bandit, Burt Reynolds. Yes, the new Trans Am SE Bandit Edition has been signed and endorsed by the man himself, but what's important here is not the signature on the dash, it's the bits of Camaro that have been modified. Aesthetically, that means a Bandit-and-Frog-approved set of T-tops, a front-opening hood with a very large, prominent shaker scoop, an equally large and prominent screaming chicken, and Trans Am-inspired front and rear fascias. And naturally, Burt Reynolds' signature adorns the dash. There are plenty of reminders in the cabin about this car's Hollywood inspiration, too. Bandit decals can be found on the front headrests and center console lid, there are chicken wings on the Camaro-spec plastic door inserts, and the black-and-tan color scheme matches nicely with the exterior look. And power? Well, Sheriff Buford T. Justice would have a lot more trouble keeping up with this Trans Am than he did with the original. The 7.4-liter LSX V8 has been paired with a 2.9-liter supercharger which is good for 840 horsepower. It's fast and loud, and even if you can't get behind the look (we can't), at least this Camaro-in-Trans Am's clothing can impress with its performance. The Bandit Edition is limited to just 77 units with prices starting around $115,000. You can check out the official video from Trans Am Depot, which comes with a decent helping of Burt Reynolds, up top. Related Video:

GM finds steering flaw, decides it doesn't warrant a recall

Guess what? General Motors is back in the spotlight for not recalling something. This time, though, not only does the company have an argument against a recall campaign, but its position is supported by the National Highway Traffic Safety Administration. According to The New York Times, over 50 owners of GM vehicles have reported instances of stuck or seized steering after driving long distances without moving the wheel. One owner complained to NHTSA that the "locked" steering of their 2013 Buick Verano caused a collision with a concrete barrier in a construction zone. Along with the 2013 to 2014 model year Verano sedans, Chevrolet Cruze and Malibu sedans are also affected. Considering the popularity of those models, GM needs to have a reason for not issuing a recall, right? "Based on a very low rate of occurrence – ranging from less than one half to less than two incidents per thousand vehicles – and the fact that the condition is remedied when the wheel is turned, GM determined this was not a safety issue," spokesman Alan Adler told The Times. The company has, however, issued a technical service bulletin for owners that complain of the problem. The fix is nothing more than a software update that is covered for 10 years or 150,000 miles from new. NHTSA cited GM's actions, along with descriptions of the problems from customers, in its decision not to issue a recall, with spokeswoman Catherine Howden saying, "the symptoms described would be a brief, perceptible change in steering feel that has little to no effect on the driver's ability to safely steer the vehicle." "When terms like 'notchy,' 'stick,' 'slip' or 'feel' are used, it does not indicate a meaningful increase in steering effort," Howden told The Times via email. What do you think? Is GM in the wrong here? Should there be a recall, or is the issue so limited as to not warrant one? Have your say in Comments. Featured Gallery 2013 Buick Verano Turbo: Review View 20 Photos Related Gallery 2014 Chevrolet Malibu: First Drive View 36 Photos Related Gallery 2014 Chevrolet Cruze Turbo Diesel: Quick Spin View 14 Photos News Source: The New York TimesImage Credit: Copyright 2015 Steven J. Ewing, Seyth Miersma / AOL Government/Legal Recalls Buick Chevrolet GM Safety Sedan buick verano