1997 Chevrolet Lumina Base Sedan 4-door 3.1l on 2040-cars

Auto blog

Next-gen Chevy Silverado and GMC Sierra may use carbon fiber

It's been generally accepted that the next generation of full-size GM trucks will use some sort of strong, lightweight material for the beds while retaining steel for the cab. While aluminum seems like the most obvious choice, according to Automotive News, the Chevy Silverado and GMC Sierra will incorporate both aluminum and carbon fiber in their beds. The publication cites sources from within GM, though it seems the introduction of this comparatively exotic material mix is still a few years off. While carbon fiber is both stronger and lighter than steel and aluminum, it takes significantly more time and money to produce, essentially relegating the material to small-volume cars. The main benefit for trucks is the resulting reduction in weight to improve fuel economy without sacrificing the tough, rugged capabilities truck buyers expect. The Ford F-150 made the switch to aluminum for the 2015 model year and it's proved highly successful. It seemed like it was only a matter of time before the competition followed suit. Automotive News says that the next-gen trucks will launch with aluminum beds and that it will take a couple of years before we'll see any carbon fiber incorporated into the design. Even then, only look for the composite material on higher-trim models, with a trickle down to lower-spec trucks possible further in the future. In 2011, GM announced it was working with Japan-based Teijin Limited on a carbon fiber reinforced thermoplastic. There's a good chance that material's introduction will be on trucks. Related Video: News Source: Automotive News Plants/Manufacturing Rumormill Chevrolet GM GMC Truck

Jay Leno gets pulled over while roaring in a Corvette Z06 convertible

No one is above the law, even if that person is a certain silver-haired auto enthusiast with a popular weekly video series about the cars in his garage. This week, Jay Leno experiences the 2015 Chevrolet Corvette Stingray Z06, but he also gets to have a meeting with some of California's Finest immediately after a high-speed blast. As opposed to the full-bore Z06 coupe with the seven-speed manual, Leno gets behind the wheel of the slightly heavier convertible version with the eight-speed auto. Being a droptop doesn't bother him too much, but Leno makes it obvious he wishes that he could be shifting for himself. Even if the auto is technically quicker, Leno says that swapping gears gives him something to do while driving. Of course, one of the major advantages of the convertible is the ability to listen to the Z06's thumping V8 unimpeded. With 650 horsepower and 650 pound-feet of torque from 6.2-liters of supercharged muscle, it already puts down impressive numbers, but the sound might just be the best part of all. Around town, the 'Vette is quiet enough to easily blend in with the rest of traffic. However, tip the throttle down and the valves in the exhaust open up to turn the engine into roaring monster. Be careful where you make this thing howl, though, because it's pretty easy for the police to take notice. The host finds that out the hard way in this week's episode of Jay Leno's Garage. Related Gallery 2015 Chevrolet Corvette Z06 Convertible View 18 Photos News Source: Jay Leno's Garage via YouTube Celebrities Chevrolet Coupe Performance Videos Jay Lenos Garage chevy corvette stingray chevy corvette z06

Chevrolet Silverado, GMC Sierra could get independent rear suspension

The Chevrolet Silverado and the GMC Sierra could reportedly receive a variant of the four-link independent rear suspension found under the new Tahoe and Suburban. While that's not a surprise, a recent report suggests electrification, not comfort, convinced General Motors to make the change. Replacing the time-tested solid rear axle with an independent suspension will improve comfort, handling and off-road prowess, while adding weight, and likely making the trucks a little bit more expensive. It's a fair trade-off, but GM Authority learned the real reason for the swap is that at least one of the pickups will spawn an electric model, and it's more difficult to package a bulky battery pack around a solid rear axle. The independent rear suspension takes up far less space, even if it has more moving parts. General Motors will build its first regular-production electric pickup on an evolution of the Silverado's T1 platform named BT1, according to the same source. The b stands for -- you guessed it -- batteries. The firm reportedly doesn't want to make two suspensions for cost reasons, so the independent setup will come standard regardless of whether the truck runs on gasoline, diesel, or electricity. As a bonus, Chevrolet and GMC could choose to offer their T1-based trucks with Magnetic Ride Control or an air suspension, options available on the 2021 Suburban and Tahoe. The independent rear suspension will also find its way to the next-generation GMC Yukon due to be revealed January 14, and to the 2021 Cadillac Escalade scheduled to make its debut February 4. The long-rumored, born-again Hummer will get it, too, because it will arrive as an electric model built on the BT1 platform. It's worth noting none of this is official, and General Motors has remained quiet about what's next for its new suspension design, and what will be under its electric truck's sheet metal. If the GM Authority report is accurate, the Silverado (pictured) and the Sierra could ditch their solid rear axle for the 2021 model year. The change will likely be accompanied by other tweaks inside and out. Featured Gallery 2019 Chevrolet Silverado 1500 View 16 Photos Chevrolet GMC Truck