2012 Chevrolet Impala Lt 16k No Reserve Salvage Rebuildable Good Airbags on 2040-cars

Auto blog

GM recalling 426,000 sedans over faulty transmission shift cable

General Motors is recalling some 426,240 sedans that may have a faulty transmission shift cable, according to a National Highway Traffic Safety Administration report this morning. The recall concerns a fault within four-speed automatic transmissions equipped on 2007-2010 Saturn Aura models, and 2008-2010 Chevrolet Malibu and Pontiac G6 models.
The report specifies that tabs on the transmission shift cable may fracture and separate. Such a fault could cause a discrepancy between the actual position of the transmission and the apparent position of the shift lever.
GM is currently working to notify owners of the vehicles in question, and dealers will check and replace shift cables free of charge. Scroll down to read the complete NHTSA report.

Chevy Bolt-based prototype may be a Buick EV for China

Late last spring, we got a look at a GM prototype that was clearly based on the Chevy Bolt EV, but with updated styling. It seemed like it could be a more crossover-styled Bolt, given the recently trademarked name of EUV. Now we get another look at the prototype, but the bodywork seems less suggestive of a Chevy, and more of a Buick. This vehicle definitely still appears to be based on the Bolt, rather than on another small GM platform. In the photos of it next to the current model, the size, wheelbase and profile are extremely similar. There are differences, though. The nose isn't as sloped or as rounded, and the rear window kicks up a little earlier. The biggest changes are in the front and rear fascias, and it's here that we see hints of Buick. There are prominent air inlets on each side of the front bumper that give the car a more aggressive look. The headlights still have a fairly rounded, organic look, but with little extensions like fangs underneath. The styled running-light section, rounded shape and the smoked lenses seem very Buick-like. The grille features a large badge that doesn't fit the shape of a bow-tie, and is more that of a round logo like Buick's. Around at the back, the full-width taillights stand out, and in the middle there is obviously a round badge, again like a Buick. The wide taillights would also be a natural evolution of Buick's current light design language that uses somewhat wide and thin lights. The rear bumper has been redesigned with new lower taillights. Now that we've established that this seems very much like a Buick, we don't think we'll see this particular version offered here with the badge. This is more likely a Buick version of the Bolt for the Chinese market, where the brand is associated with luxury and has been the spearhead for GM's electric and hybrid models. In fact, the Chevy Volt hybrid was sold there as the Buick Velite 5, which was part of a family of a electrified Velite models. This would probably also carry a Velite badge as well. While we might not see this specific Buick variant, we probably will see it offered as a Chevy in some form. With its more aggressive, crossover shape, it could be the rumored EUV model. Or it could be just a refresh of the current Bolt, since the model has been largely unchanged since its introduction for the 2017 model year. And extrapolating from this prototype, we can see how the headlights could be tweaked to tie into those air scoops as on the Suburban and Silverado.

Our favorite mid-engine Corvette theories and rumors

The mid-engine Corvette! We just saw blurry photos through the foliage, and are hearts are all aflutter because it means that this car is real. And it's the most " never before" Corvette since 1984. Which leads us to all kinds of wacky theories and speculation. Everybody knows something or heard from a guy. None of those guys (or gals) from GM are talking to Autoblog, to be clear. But that won't stop us from stirring the pot. Let's go over a few point-by-point. The pushrod engine will be replaced by an overhead-cam V8 Car and Driver has repeatedly reported that an overhead-cam engine will come after the mid-engine Corvette's debut with an old-school pushrod. We've heard the same thing firsthand, albeit from a source with no connection to the development of the Corvette or powertrain. "At some point two valves can't pass future emissions regulations," said the guy we know. While the pushrod engine is compact, the design makes it difficult - if not impossible - for sophisticated variable valve timing (and lift) systems that control combustion with more precision. Hasty conclusion: The pushrod engine has a finite life in front of it. This one's a lock, it's a just a matter of when. Bowling Green's new paint shop is really the mid-engine assembly line Credit to Reddit for this one. Like we said, everybody knows a guy. But let's look deeper. The new paint facility costs $439 million dollars and adds 450,000 square feet, almost half the size of the existing plant. Plus GM announced another $290 million in upgrades at Bowling Green Assembly. That sure sounds like a lot of money, but you can actually spend that much on a paint booth. Porsche spent 500 million Euros (about $561 million dollars) to add the Macan assembly to its Leipzig, Germany plant in 2014. Chrysler shelled out $850 million for a paint shop in Sterling Heights, Michigan. GM spent $600 million for a new paint shop at the Fairfax (Kansas City) plant. Honda, on the other hand, is working on a thrifty $210 million project in Marysville, Ohio that includes a 300,000 square foot expansion, and the low-volume Acura NSX facility only cost $70 million. Hasty conclusion: The square footage and cost could easily mean a new assembly line instead of (or in addition to) a paint line. And if the NSX plant was really that cheap, GM could have hidden a similar sum in its existing announcements.