1963 Chevrolet Impala W/power Windows And A/c on 2040-cars

Auto blog

Driving Granatelli's turbine-powered 1978 Chevy Corvette [w/video]

With its curvy snout and feminine haunches, the third-gen Chevrolet Corvette looks like a dreamy – if dated – exemplar of Sports Car Fantasy 101 when viewed through modern eyes. This particular specimen circa '78, clad in silver and black paint with red pinstripes, appears to be a well-preserved example from the era. Apart from its low-profile Pirellis, slightly raised and slotted hood, spacious stance and a certain hand-painted descriptor alongside its crossed flag logos, you'd never guess there's a Space-Age propulsion unit powering this Coke bottle-bodied ride. Climb inside, and you're presented with aircraft gauges and big, colorful square buttons in the center panel. It takes a push of the "Ignitor" button, a tap of the starter button, and a slide of a T-handle for this nearly 40-year-old sports car to start sounding like Gulfstream G650 ready for takeoff. Yep, you're sitting in an 880-horsepower, turbine-powered Corvette, the only one of its kind in the world. Welcome to the whoosh. What The...? Built by Vince Granatelli, son of Indy 500 guru Andy Granatelli, this curious Corvette came into being by cramming a Pratt & Whitney ST6N-74 gas turbine engine into the donor car's lengthy front end. The same type of Jet A-burning mill powered Granatelli Senior's STP-sponsored racecar at the 1967 Indianapolis 500, where it famously led most of the 198 of 200 laps until a $6 transmission bearing failed, knocking it out of the race. The idea of turbine power usurping internal combustion was so threatening that Indy's governing body restricted turbine performance into obsolescence thereafter. A turbine-powered Corvette sounds excessive because it is. But there are also things about this 880-horsepower, 1,161-pound-feet monster that might surprise you. While it smacks of futurist exoticism and cost a then-dizzying $37,000 in 1967, the Canadian-built powerplant uses 80 percent fewer parts than an internal combustion V8 and will run on virtually anything combustible – whiskey, diesel, even Chanel No. 5. Though it's triple the length of a V8, the Pratt & Whitney beast weighs only 285 pounds. It's also one hell of a robust workhorse, typically serving as an auxiliary power unit for commercial aircraft or a generator in oil fields, where it can run for tens of thousands of consecutive hours before needing an overhaul. To adapt the Chevrolet for jet duty, the nose section was gutted and a sub-frame was built to compensate for the loosey-goosey front end.

2014 Chevrolet Corvette Stingray Convertible gives us a couple of looks

Put away your pixel paintbrushes, kids. Pack up your Photoshop. This is the real-deal 2014 Chevrolet Corvette Stingray Convertible in its first official images. The droptop Chevrolet will roll into the bright lights of the Palexpo exhibition at next week's Geneva Motor Show, a four-wheeled statement of intent that General Motors is serious about taking its Corvette franchise global.
Chevy isn't providing anything in the way of further details with these two shots, but we've learned at least a couple of things about the car shown here. First off, the example seen in these images is fitted with the optional Z51 Performance Package - something that isn't immediately evident because there's no sign of the coupe model's prominent ductwork on its rear haunches. In order to accommodate the power folding hard tonneau cover, the vents that feed the transmission and differential coolers have been relocated to the underside of the car. The dark paint color on this example also does a good job of muting the contrasting black front fender vents and hood opening - Z51-spec design details that have proven to be somewhat controversial.
One other thing to note: These two shots also display the Stingray wearing different alloy wheels than the split five-spoke design shown at the hardtop's Detroit Auto Show unveiling in January. The simpler, thin five-spoke wheels should do a good job of showing off the Z51's upgraded brakes, and they'll be optional on the coupe as well.

GM sees 'strong year' in 2018, then gold in Chevy Silverado for 2019

DETROIT — General Motors said on Tuesday it expects earnings in 2018 to be largely flat compared with 2017, but that profits should pick up pace in 2019 as its revamped line of high-margin pickup trucks hits the U.S. market. The 2018 earnings outlook was above market expectations, sending GM shares up more than 3 percent in premarket trading. "GM had a very good 2017 as we continued to transform our company to be more focused, resilient and profitable," GM Chief Executive Mary Barra said in a statement. "We are positioned for another strong year in 2018 and an even better one in 2019." GM and its Detroit rivals, Ford and Fiat Chrysler Automobiles, are bringing on new trucks at a time when overall U.S. new vehicle sales have been falling, but truck sales continue to grow as consumers abandon passenger cars in favor of pickups, SUVs and crossovers. GM on Saturday fired a new round in the battle for profits from one of the U.S. auto industry's most lucrative segments when it showed a new generation of its Chevrolet Silverado pickup truck at the Detroit auto show. The new Silverado, a highlight of the event, is the successor to GM's best-selling vehicle in North America. Sales of the current Silverado rose nearly 2 percent to 585,000 vehicles in 2017. In the coming months, the company will also reveal a revamped GMC Sierra pickup truck. U.S. new vehicle sales fell 2 percent in 2017 after hitting a record high in 2016, and are expected to drop further in 2018 as interest rates rise and more late-model used cars return to dealer lots to compete with new ones. GM said on Tuesday that while it retools a factory in Ft. Wayne, Indiana, to make the new pickup trucks, it will shift some production to an Oshawa, Ontario, plant in order to avoid missing sales in a hot market for the vehicles. The No. 1 U.S. automaker said it will record a $7 billion non-cash charge for its fourth-quarter 2017 earnings related to deferred tax assets. GM said it expects capital expenditure in 2018 of around $8.5 billion, about $1 billion of which will go toward funding self-driving car technology. Last week, the company said it is seeking U.S. government approval for a fully autonomous car — one without a steering wheel, brake pedal or accelerator pedal — to enter the automaker's first commercial ride-sharing fleet in 2019. GM said it expects 2017 earnings per share at the high end of its previously forecast range of $6 to $6.50.