2007 Chevrolet Hhr Ls - $199 P/mo, $200 Down! on 2040-cars

Auto blog

GM recalls Cadillac ATS and Chevy Impala for separate issues

The National Highway Traffic Safety Administration added two recalls from General Motors in the government organization's daily update of safety campaigns. Both were for failing to meet Federal Motor Vehicle Safety Standards but for completely separate reasons. The larger recall covers 58,698 units of the 2013-2015 Cadillac ATS, but it doesn't really carry huge safety concerns. In vehicles produced between April 25, 2012, and February 9, 2015, the controls for the tilt and slide of the moonroof are not recessed enough, as required by federal law. According to NHTSA, it's possible that someone could inadvertently activate the auto-close for the roof panel, which the agency claims increases "the risk of personal injury." Dealers will install a new trim plate that will add the necessary clearance. The other campaign covers 1,177 examples of the 2014 Chevrolet Impala from between November 15, 2012, and May 27, 2014. However, this is actually a repeat of a previous recall on the Chevy and the Cadillac XTS from 2014. The affected Impalas here "were remedied incorrectly" under the earlier campaign, according to NHTSA. On these sedans, it's possible the electronic parking brake might not fully disengage and still remain in some contact with the rotor, which is in violation of federal rules. The fault can cause excessive heat from the brakes that could potentially lead to a fire, according to NHTSA. To fix the problem, dealers will reprogram the electronic parking brake control module. Show full PR text RECALL Subject : Inadvertent Press of Roof Panel Switch/FMVSS 118 Report Receipt Date: FEB 24, 2015 NHTSA Campaign Number: 15V106000 Component(s): VISIBILITY Potential Number of Units Affected: 58,698 All Products Associated with this Recall Vehicle Make Model Model Year(s) CADILLAC ATS 2013-2015 Details Manufacturer: General Motors LLC SUMMARY: General Motors LLC (GM) is recalling certain model year 2013-2015 Cadillac ATS vehicles manufactured April 25, 2012, to February 9, 2015. In the affected vehicles, the power-operated roof panels auto-close when the non-recessed "Slide" or "Tilt" switches are pressed. As such, these vehicles fail to comply with the requirements of the Federal Motor Vehicle Safety Standards (FMVSS) No.

GM Design shows what could have been and what might be

We periodically like to check in with GM Design's Instagram account to see what they're cooking up. Even better is when we catch a glimpse of an alternate history of what legendary designers from The General's past were thinking, though those ideas may not have made it into production. This week, for example, the account posted some illustrations from George Camp, whose career at GM spanned nearly four decades, from 1963 to 2001. One of the renderings is of what appears to be a 1971-72 Pontiac GTO Judge, but with two headlights instead of the production unit's quad beams. The rear departs from the canonical version most dramatically, with a massive integrated wing. Other bits that didn't make the production cut include large side vents, a gill-like side marker and rectangular intakes below the headlights that wouldn't be out of place on a modern design today. Amazingly, from what we can make out of the date, it appears that the drawing was done sometime in 1965, which makes it quite prescient.           View this post on Instagram                       A post shared by GM Design (@generalmotorsdesign) There's also a very aerodynamic interpretation of a Corvette ZR-1. To our eyes it splits the difference between the 1986 Corvette Indy concept and a fourth-generation F-body Pontiac Firebird, so perhaps parts of Camp's work on this sketch did make it into physical form. There's also a radical sports car concept from May 1970 that resembles the Mazda RX-500 concept from the same year, a Syd Mead-looking Cadillac coupe, and an Oldsmobile with a cool take on the company's trademark waterfall grille and elements of the Colonnade Cutlass at the rear. Other recent posts include a FJ Cruiser-like off-road EV, a sleek coupe with the Chevy corporate grille, and a rendering of a Silverado-esque pickup that looks far better than the current production version.           View this post on Instagram                       A post shared by GM Design (@generalmotorsdesign) It's pretty easy to lose hours in the account, but it's always fascinating to see GM's visions of what could have been and what might be. Related Video:

Chevy SS prototype spotted wearing Pontiac G8 clothes

Do not adjust your computer screen, you are not seeing the rebirth of the Pontiac brand. General Motors has chosen to use a G8 to disguise a test mule for the latest prototype of the forthcoming Chevrolet SS. The G8 was closely related to the Holden Commodore and Vauxhall VXR, the platform upon which the new Chevrolet performance model will be based. It should come as little surprise, then, that GM has opted to use the cladding from the former G8.
Thought the front clip of this mule is pure Pontiac, note the vents immediately behind the front wheel. That is a distinctive design hallmark of the Vauxhall VXR. Also note that this vehicle is right-hand drive, as the Holden and its Chevy counterpart will be very closely related. That likely includes potential drivetrains. The spy photos of this mule also reveal very wide rear tires, and rear wheels that do not match the fronts.