Find or Sell Used Cars, Trucks, and SUVs in USA

El Camino on 2040-cars

Year:1968 Mileage:99999
Location:

Bronson, Florida, United States

Bronson, Florida, United States
Advertising:
Engine:none
Vehicle Title:Clear
Condition:
Used: A vehicle is considered used if it has been registered and issued a title. Used vehicles have had at least one previous owner. The condition of the exterior, interior and engine can vary depending on the vehicle's history. See the seller's listing for full details and description of any imperfections. ...
VIN (Vehicle Identification Number)
: 136808k132078
Year: 1968
Drive Type: 2 wheel
Make: Chevrolet
Mileage: 99,999
Model: El Camino
Number of Cylinders: none

1968 el camino factory ac, very solid start for a restoration, some rust and bondo but its minimal, very solid were it counts. pics tell the story. I will send specific pics upon request, and answer any question. no motor or trans, lots of parts, full payment due 72 hrs after auction. paypal only, buyer must pick up.

Auto Services in Florida

Youngs` Automotive Service ★★★★★

Auto Repair & Service
Address: 1430 Ponce de Leon Blvd, Spring-Hill
Phone: (352) 796-3791

Winner Auto Center Inc ★★★★★

Auto Repair & Service, Auto Oil & Lube, Automobile Electric Service
Address: 3400 N Highway 1 (US 1), Cocoa
Phone: (321) 632-3175

Vehicles Four Sale Inc ★★★★★

Used Car Dealers
Address: 900 State St, Miami-Gardens
Phone: (954) 967-6988

Valvoline Instant Oil Change ★★★★★

Auto Repair & Service, Auto Oil & Lube, Automotive Tune Up Service
Address: 12890 W Colonial Dr, Oakland
Phone: (321) 236-5680

USA Auto Glass ★★★★★

Auto Repair & Service, Automobile Parts & Supplies, Windshield Repair
Address: Pembroke-Park
Phone: (954) 447-0031

Tuffy Auto Service Centers ★★★★★

Auto Repair & Service, Brake Repair
Address: 2572 Tamiami Trl, Port-Charlotte
Phone: (941) 764-9815

Auto blog

Final C6 Corvette built in Bowling Green

Fri, 01 Mar 2013

With all of the attention given to the 2014 Chevrolet Corvette Stingray lately, you could be forgiven for thinking that it's already well along in production, yet tooling up for the new C7 has only just begun. In fact, production of the outgoing C6 generation in Bowling Green, Kentucky just halted on Thursday.
As the C6 has aged, production numbers have predictably ebbed along with demand, but this year, the addition of the 427 and 60th anniversary models resulted in an uptick in vehicles built - this, despite a model year shortened by around 25 percent to accomodate the new model changeover. The final C6 Corvette ever, No. 13,466 built this year, was a white 427 Convertible destined for the General Motors Heritage Center museum. The car's 7.0-liter V8 heart was assembled by Corvette chief engineer Tadge Juechter himself.
In total, Bowling Green pushed out 215,100 C6 Corvettes over nine years. If you're still a C6 fan at heart and are hoping to get a good deal on a phase-out model, step lively - Chevrolet reportedly had about 6,100 unsold units, which Autoweek suggests is good for around five and a half months of supply at the model's current sales rates. Given that demand will likely slacken even further as the C7 draws closer, that should be a big enough stockpile to keep dealers satisfied until 2014 Stingrays begin showing up on their forecourts in December.

GM recalling nearly 4,000 vehicles over airbag concerns

Thu, 31 Jan 2013

Four different General Motors vehicles from the 2012 model year are being recalled over a potential airbag issue. The driver's side airbag shorting bar in the 2012 Buick Verano and 2012 Chevrolet Camaro, Cruze and Sonic might make contact with the airbag terminals, even during a crash. If so, the airbag won't deploy when it should, possibly increasing injury to the driver.
The recall is expected to begin on February 13 for the 3,896 units that might be affected. GM will notify owners who can then take their vehicles to dealers to have the airbag coil replaced. A bulletin from the National Highway Traffic Safety Administration below has more info.

GM to invest $150 million in Flint to boost heavy-duty pickup production

Thu, Jun 13 2019

FLINT, Mich. — General Motors President Mark Reuss said on Wednesday that the automaker is investing about $150 million at its Flint Assembly plant in Michigan to boost production of heavy duty trucks by another 40,000 vehicles a year. Reuss announced the investment at the Flint truck assembly plant wearing a United Auto Workers pin. The Detroit automaker had announced back in February it was adding 1,000 jobs in Flint to build a new generation of heavy-duty pickup trucks. GM did not say that the latest investment would add more jobs at the plant, but Reuss said there could be opportunities to add workers as the launch of the automaker's new trucks progresses. GM has been under pressure from President Donald Trump and lawmakers of both parties to add jobs in the United States after it said last November it would idle the Chevy Cruze assembly plant in Lordstown, Ohio, and likewise had no new products for three other U.S. manufacturing plants. The Flint investment will include upgrades to the plant's conveyors and other new tooling, and will be completed in the first half of 2020. GM has invested more than $1.6 billion in the plant since 2013. Last month, GM said it would invest $24 million to increase truck production at its assembly plant in Fort Wayne, Indiana, which makes Chevrolet Silverado and GMC Sierra models. Sales of heavy-duty pickups in the United States have grown to more than 600,000 vehicles a year, up more than 20 percent since 2013, according to industry data. Prices for luxury models can easily top $70,000. GM's Chevrolet and GMC brands have long trailed Ford's F-series heavy duty trucks in the lucrative segment. The new Chevrolet and GMC heavy duty trucks have been re-engineered to tow heavier trailers, and keep pace in what has become an arms race among the Detroit Three automakers to claim superior torque and towing capability. Related: Silverado HD vs. 2019 Ram, Ford heavy duty trucks: How they compare on paper