1985 Chevrolet El Camino on 2040-cars

Auto blog

2017 North American Car, Truck, and Utility of the Year entries announced

Over 40 vehicles will compete for the 2017 North American Car, Truck, and Utility of the Year awards. If that name looks a little strange, it's because the competition added a third category. In years past, pickup trucks, crossovers, SUVs, commercial vans, and minivans competed for the same award. That's why there were occasionally weird comparisons, like last year's competition between the Volvo XC90 and Nissan Titan XD. The new format separates pickups and commercial vans into the truck contest and CUVs, SUVs, and minivans into the utility competition. A complete list of eligible vehicles is below, but here are a few highlights. For one, the entire list of entries has a luxurious lean. Of the 43 vehicles, nearly half of them are from premium brands. There are two eligible Bentleys – the Bentayga and Mulsanne – the Rolls-Royce Dawn, Jaguar F-Pace, Audi Q7, and the Mercedes-Benz GLS-, E-, and S-Class Maybach. The performance ranks are lofty, too, with the Audi R8, Acura NSX, Alfa Romeo Giulia, Mercedes SL- and SLC-Class, Porsche 718, and F-150 Raptor. The mainstream entries are just as comprehensive. From the Chrysler Pacifica to the Chevrolet Cruze to the Fiat 124 Spider to the Mitsubishi Mirage, NACTOY has covered an enormous price range with this year's contestants. Of course, these are only the eligible vehicles. They'll need to run through three rounds of judging, starting in September at NACTOY's traditional Hell, MI, test drive. The Canadian and American journalists involved in the judging will announce this year's nine finalists – three in each category – on December 6. Cars Acura NSX Alfa Romeo Giulia Audi A4 Audi R8 Bentley Mulsanne Buick Cascada Buick LaCrosse Cadillac CT6 Chevrolet Bolt Chevrolet Cruze Fiat 124 Genesis G90 Hyundai Elantra Infiniti Q60 Jaguar XE Kia Cadenza Lincoln Continental Mercedes-Benz E-Class sedan Mercedes-Benz S550 Maybach Mercedes-Benz SL-Class Mercedes-Benz SLC-Class Mini Clubman Mitsubishi Mirage/G4 Porsche 718 Boxster and Cayman Rolls-Royce Dawn Toyota Prius Prime Volvo S90 SUVs Audi Q7 Bentley Bentayga Buick Envision Cadillac XT5 Chrysler Pacifica GMC Acadia Infiniti QX30 Kia Sportage Mercedes-Benz GLS-Class Jaguar F-Pace Mazda CX-9 Nissan Armada Trucks Ford F-Series Super Duty pickups Ford F-150 Raptor Honda Ridgeline Nissan Titan half-ton Related Video: Featured Gallery Bentley Bentayga View 23 Photos News Source: Automotive News - sub.

Next-gen Chevy Silverado and GMC Sierra may use carbon fiber

It's been generally accepted that the next generation of full-size GM trucks will use some sort of strong, lightweight material for the beds while retaining steel for the cab. While aluminum seems like the most obvious choice, according to Automotive News, the Chevy Silverado and GMC Sierra will incorporate both aluminum and carbon fiber in their beds. The publication cites sources from within GM, though it seems the introduction of this comparatively exotic material mix is still a few years off. While carbon fiber is both stronger and lighter than steel and aluminum, it takes significantly more time and money to produce, essentially relegating the material to small-volume cars. The main benefit for trucks is the resulting reduction in weight to improve fuel economy without sacrificing the tough, rugged capabilities truck buyers expect. The Ford F-150 made the switch to aluminum for the 2015 model year and it's proved highly successful. It seemed like it was only a matter of time before the competition followed suit. Automotive News says that the next-gen trucks will launch with aluminum beds and that it will take a couple of years before we'll see any carbon fiber incorporated into the design. Even then, only look for the composite material on higher-trim models, with a trickle down to lower-spec trucks possible further in the future. In 2011, GM announced it was working with Japan-based Teijin Limited on a carbon fiber reinforced thermoplastic. There's a good chance that material's introduction will be on trucks. Related Video: News Source: Automotive News Plants/Manufacturing Rumormill Chevrolet GM GMC Truck

The Corvette Museum sinkhole has been filled

After swallowing eight of the most prized pieces of the collection from the National Corvette Museum, the massive sinkhole from a year ago is rapidly becoming nothing but a bad memory. Based on the museum's weekly construction update, you can barely see the remnants of the 25-foot deep hole once in the floor. The Corvette Museum's Skydome was not always going to look like this. The original hope was to keep the sinkhole there as a tourist attraction. That plan eventually fell through, though, and instead it was decided five of the less-damaged Corvettes would remain unrestored. Progress has been moving fast to get the repairs done. Even a month ago, the hole was still very visible, and the construction company used remote-controlled Bobcat loaders to fill it in. Now, the museum has launched a contest to guess how many tons of stone it took to fill in the massive crater. The winner gets a print of the 2009 Corvette ZR1 Blue Devil being lifted out. Related Gallery National Corvette Museum Car Recovery View 25 Photos News Source: Corvettemuseum via YouTubeImage Credit: National Corvette Museum Weird Car News Chevrolet GM Videos National Corvette Museum