1966 El Camino Rare on 2040-cars

Auto blog

2014 Chevrolet Malibu gets more torque, more room and inspiration from the Impala

The 2014 Chevrolet Malibu, having stared at the Impala across the showroom floor for a year, gets nips and tucks all over inspired by its larger brother. The 2.5-liter four-cylinder in the base car will get a stop-start system and 23 city miles per gallon, 35 highway, each number representing a one-mpg improvement over the 2013 car. Output is 196 horsepower and 186 pound-feet of torque.
Opt for the 2.0-liter turbo and, while power holds steady at 259 hp, torque goes up by 14 percent to a striking 295 lb-ft (a figure Chevy calls best in the class). The final details include newly programmed transmission shift points and faster shifts, for better engaging and enjoying the added power.
Looks-wise, the grille's been reshaped to be more in line with the new Chevrolet look, a narrower upper grille hovering over a larger lower grille.

GM recalls select Chevy Cruze, Sonic and Buick Verano models over airbag issue

General Motors is recalling certain 2012 Buick Verano, Chevrolet Cruze and Sonic models due to a defect in the driver's airbag system. According to the National Highway Traffic Safety Administration, the airbag has a shorting bar which may contact two internal terminals. If that happens during a crash, the supplemental restraint may not deploy, increasing the risk of driver injury. The recall includes a total of 2,949 units.
GM will contact owners and replace the steering wheel airbag coil at no cost. At this point, it's unclear when the recall will begin, though owners may contact the automaker at 1-800-521-7300 for more information. You may also take a closer look at the full NHTSA notice below.

UAW to vote on strike at Kentucky Corvette plant

The current wait time for a new Chevrolet Corvette Stingray is well, not short. With word of a strike at the Bowling Green, KY factory responsible for seventh-generation sports car, though, that wait time could end up growing substantially.
Now, a strike is still a ways off. UAW Local 2164, which represents the 800 workers responsible for screwing the Corvette together, is set to vote on authorizing a strike today, but even if the employees give the action a go, it's far from a sure thing. According to The Tennessean, both regional and national union officials would need to put their stamp of approval on strike action.
"The membership has to vote to strike, but it's just a step in the process," said Gary Casteel, the UAW's Region 8 director and one of the people that would need to authorize a strike action. Casteel told The Tennessean, "It's purely a local situation, though. They are having some issues with the local management."