Water Damaged Title------2013 Chevrolet Corvette Grand Sport 3lt 6 Speed Manual on 2040-cars

Auto blog

Chevy admits there's confusion over Bolt and Volt names

Offering the possibility of 200 miles of driving range and the potential for a price of about $30,000, the Chevrolet Bolt is an incredibly enticing vehicle, and it has an opportunity to be a big player in the EV world. However, the hatchback has been plagued by one problem since the moment it debuted – the name. Bolt sounds very similar to Volt, Chevy's extended-range plug-in, and they can be easy to confuse in a conversation. That's not the best quality to have when trying to get a new vehicle's name out there among customers, and General Motors North America president Alan Batey told the Detroit Free Press that the company is aware of the problem. While the EV is definitely going into production, the model might be wearing a different moniker when it hits showrooms. "We're still in the decision phase. It could go either way," Batey said to the Free Press. He indicated the automaker still has about a year before a final decision is necessary. The Bolt will be built at GM's Orion Assembly plant in Michigan and will likely go on sale around 2017. That will put the Chevy on the market at roughly the same time as the 200-mile Tesla Model 3. Batey didn't seem too concerned, though. "Unlike Tesla, we can spread the cost over a whole lineup," he said to the Free Press. The future doesn't look quite so bright for the Spark EV, though. Batey suggested that it might not last once the longer-range Bolt fills that niche in the lineup. Related Video:

Next-gen Chevy Silverado and GMC Sierra may use carbon fiber

It's been generally accepted that the next generation of full-size GM trucks will use some sort of strong, lightweight material for the beds while retaining steel for the cab. While aluminum seems like the most obvious choice, according to Automotive News, the Chevy Silverado and GMC Sierra will incorporate both aluminum and carbon fiber in their beds. The publication cites sources from within GM, though it seems the introduction of this comparatively exotic material mix is still a few years off. While carbon fiber is both stronger and lighter than steel and aluminum, it takes significantly more time and money to produce, essentially relegating the material to small-volume cars. The main benefit for trucks is the resulting reduction in weight to improve fuel economy without sacrificing the tough, rugged capabilities truck buyers expect. The Ford F-150 made the switch to aluminum for the 2015 model year and it's proved highly successful. It seemed like it was only a matter of time before the competition followed suit. Automotive News says that the next-gen trucks will launch with aluminum beds and that it will take a couple of years before we'll see any carbon fiber incorporated into the design. Even then, only look for the composite material on higher-trim models, with a trickle down to lower-spec trucks possible further in the future. In 2011, GM announced it was working with Japan-based Teijin Limited on a carbon fiber reinforced thermoplastic. There's a good chance that material's introduction will be on trucks. Related Video: News Source: Automotive News Plants/Manufacturing Rumormill Chevrolet GM GMC Truck

Next-gen GMC Sierra spied with diesel power

The next generation of GM trucks is arriving soon, and we're expecting a huge leap forward over the current lineup. The Chevy Silverado and the GMC SIerra sell extremely well, but haven't done much to move the segment forward in a long time. The Ford F-150 has an all-aluminum body and turbocharged V6 power. The Ram 1500 gained a diesel and coil spring suspension. These spy shots show that diesel may be in the cards for GM. Some quick shots and copious use of flash show what is most likely a tank for diesel exhaust fluid and a diesel particulate filter, both necessary equipment for any modern diesel. It's unclear what form factor that engine will come in, though GM has a number of engines to choose from, including the 2.8-liter inline four that's found in the Colorado and Canyon, though that may be a little light duty for the Silverado and Sierra. Other rumors surrounding the trucks suggest a move to an aluminum cab while retaining a steel bed. That seems like a reasonable move for GM, even if the company was attempting to shame Ford for its move to aluminum a few years ago. Look for more news as early as the Detroit Auto Show in January. Related Video: Featured Gallery 2019 GMC Sierra spy shots View 21 Photos Image Credit: Spied Bilde Spy Photos Chevrolet GMC Truck