Find or Sell Used Cars, Trucks, and SUVs in USA

Chevrolet Corvette Hardtop on 2040-cars

US $2,000.00
Year:1973 Mileage:123000 Color: Silver
Location:

Philadelphia, Pennsylvania, United States

Philadelphia, Pennsylvania, United States

73 CORVETTE, NOT MATCHING # 350 ENGINE, TURBO 400, TILT TELESCOPIC STEERING WHEEL. SOLID FRAME, OK PAINT NICE INTERIOR, RUNS DRIVES GOOD, NEW BRAKES ALL AROUND, NEW TRAILING ARMS, NEW RUBBER IN SUSPENSION FRONT AND REAR RECENT ALIGNMENT CAR NOW STEERS AND DRIVES SMOOTH.

Auto Services in Pennsylvania

YBJ Auto Sales ★★★★★

New Car Dealers, Used Car Dealers
Address: 715 Walnut St, Bethlehem
Phone: (610) 438-5300

West View Auto Body ★★★★★

Automobile Body Repairing & Painting
Address: 420 Perry Hwy, Mount-Lebanon
Phone: (412) 931-0600

Wengert`s Automotive ★★★★★

Auto Repair & Service, Automobile Diagnostic Service, Automobile Inspection Stations & Services
Address: 5118 Old Route 22, Shartlesville
Phone: (610) 488-6624

University Collision Center ★★★★★

Auto Repair & Service, Automobile Body Repairing & Painting
Address: 1103 S 31st St, Crum-Lynne
Phone: (215) 755-5957

Ultimate Auto Body Inc ★★★★★

Automobile Body Repairing & Painting, Towing
Address: Castle-Shannon
Phone: (412) 481-7110

Stewart Collision Service ★★★★★

Auto Repair & Service, Automobile Body Repairing & Painting, Automobile Parts & Supplies
Address: 73 E Fayette St, Brownfield
Phone: (724) 437-9381

Auto blog

Next-gen Chevy Silverado and GMC Sierra may use carbon fiber

Thu, Dec 7 2017

It's been generally accepted that the next generation of full-size GM trucks will use some sort of strong, lightweight material for the beds while retaining steel for the cab. While aluminum seems like the most obvious choice, according to Automotive News, the Chevy Silverado and GMC Sierra will incorporate both aluminum and carbon fiber in their beds. The publication cites sources from within GM, though it seems the introduction of this comparatively exotic material mix is still a few years off. While carbon fiber is both stronger and lighter than steel and aluminum, it takes significantly more time and money to produce, essentially relegating the material to small-volume cars. The main benefit for trucks is the resulting reduction in weight to improve fuel economy without sacrificing the tough, rugged capabilities truck buyers expect. The Ford F-150 made the switch to aluminum for the 2015 model year and it's proved highly successful. It seemed like it was only a matter of time before the competition followed suit. Automotive News says that the next-gen trucks will launch with aluminum beds and that it will take a couple of years before we'll see any carbon fiber incorporated into the design. Even then, only look for the composite material on higher-trim models, with a trickle down to lower-spec trucks possible further in the future. In 2011, GM announced it was working with Japan-based Teijin Limited on a carbon fiber reinforced thermoplastic. There's a good chance that material's introduction will be on trucks. Related Video: News Source: Automotive News Plants/Manufacturing Rumormill Chevrolet GM GMC Truck

Race Recap: 2013 Twelve Hours of Sebring, cakewalk up front, grindfest out back [w/spoilers]

Tue, 19 Mar 2013

This year's 12 Hours of Sebring wasn't exactly a foregone conclusion because we're still talking about racing, and anything can happen when the speeds are as high as the adrenaline and the desire. But we're still talking about Audi bringing it's two top-spec racers - and its huge budget and its nearly neurotic attention to detail - to a race that it uses as a test bed for The 24 Hours of Le Mans and as a way to open the endurance racing season with a victory.
Besides, 12 hours is a long time, especially at Sebring, and things didn't go all Audi's way. On top of that, although it was a pretty quiet race, behind the Audis things got even grimier, with plenty of battles, plenty of mechanical issues, and the new BMW Z4 GTE and Viper GTS-R being race tested. Oh, and that brand new chromed-out DeltaWing...

Camaro SS facelift and dune-riding the new Mercedes-Benz GLS | Autoblog Podcast #579

Fri, May 3 2019

In this week's Autoblog Podcast, Editor-in-Chief Greg Migliore is joined by Road Test Editor Reese Counts and Associate Editor Joel Stocksdale. First, they talk about the newly refreshed Chevy Camaro SS. Then they dish on the cars they've been driving, including the Lexus UX, Lexus GS F and Volvo V90, as well as riding in the new Mercedes-Benz GLS. After that, they ask the question, how many AMG cars is too many? Finally they turn to car buying, and suggest potential vehicles for a shopper on Reddit for the "Spend My Money" segment. Autoblog Podcast #579 Get The Podcast iTunes – Subscribe to the Autoblog Podcast in iTunes RSS – Add the Autoblog Podcast feed to your RSS aggregator MP3 – Download the MP3 directly Rundown 2020 Camaro SS facelift Cars we're driving: 2019 Lexus UX 2019 Lexus GS F 2019 Volvo V90 Cross Country 2020 Mercedes-Benz GLS ride How many AMGs is too many? Spend My Money Feedback Email – Podcast@Autoblog.com Review the show on iTunes Related Video: