Find or Sell Used Cars, Trucks, and SUVs in USA

Chevy Chevrolet Colorado Custom Lowrider Crew Cab Pick-up Truck ****nice!!! on 2040-cars

US $11,500.00
Year:2004 Mileage:22200
Location:

Mays Landing, New Jersey, United States

Mays Landing, New Jersey, United States
Advertising:

I am selling my Chevy Colorado Crew Cab. (CUSTOM LOWRIDER)

This truck is absolutely priced to sell...

I am the original owner and purchased it Brand New in 2004. It is Factory Green, power windows, locks and mirrors. The truck ONLY has 22,000 Miles on it! I would say easy miles too. The truck is bagged front and back with Chassis Tech equipment. It is dual compressor and dual tank. Has a custom Four Link suspension in the rear. I had a custom telescopic driveshaft and drive shaft loop guard made. The Rear was professionally narrowed with custom axles so the wheels would tuckn into the bed. There are 22" inch wheels in the back and 20" in the front. The rims and tires are BRAND NEW and were over $3,500 alone! I installed a fuel cell in the bed. The Tailgate handle was removed and relocated. The interior has custom bucket seats and an awesome 2 amp sound system for high and low range. The amps are frenched into the rear seats. The subwoofer enclosure is rear console installed and made of stainless steel. There are many, many custom aspects of this vehicle and should really be seen to appreciate. I am only selling this piece to purchase a home. This is a project truck that is about 85% complete but it runs and drives perfectly. I  have over $35,000 invested... You wont be dissapointed with this truck. I will send more pictures upon request..Thanks for looking!! Please ONLY SERIOUS BUYERS. Call or Text for more pictures or questions, my name is Brett...(609) 226-0608...

Auto Services in New Jersey

Williams Custom Tops-Interiors ★★★★★

Automobile Parts & Supplies, Automobile Seat Covers, Tops & Upholstery, Automobile Accessories
Address: 910 Woodbourne Rd, Fieldsboro
Phone: (215) 757-3100

Volkswagon of Langhorne ★★★★★

Auto Repair & Service, New Car Dealers, Used Car Dealers
Address: 1862 E Lincoln Hwy, Pennington
Phone: (215) 741-4100

Vip Honda Honda Automobiles ★★★★★

New Car Dealers
Address: 542 Somerset St, Fanwood
Phone: (908) 753-6071

Tri State Auto Glass ★★★★★

Automobile Parts & Supplies, Glass-Auto, Plate, Window, Etc, Windshield Repair
Address: 15511 Liberty Ave, West-New-York
Phone: (718) 206-0143

Solveri Collision Center ★★★★★

Auto Repair & Service, Automobile Body Repairing & Painting
Address: 2300 Route 88, Asbury-Park
Phone: (732) 202-7448

Scotts Auto Service ★★★★★

Auto Repair & Service
Address: 161 Kinderkamack Rd, Haworth
Phone: (201) 391-3433

Auto blog

GM recalling 686k Lambda-platform models for hatch repair

Fri, Jul 10 2015

General Motors is recalling 686,287 units of its Lambda platform crossovers. On models equipped with a power rear hatch the system can potentially fail. This campaign includes the 2008-2012 Buick Enclave, 2009-2012 Chevrolet Traverse, 2007-2012 GMC Acadia, and 2007-2010 Saturn Outlook. According to GM's documents to the National Highway Traffic Safety Administration (as a PDF), dirt can get into a portion of the strut that holds up the hatch and cause the part to prematurely fail. There's a redundancy in place called the Prop Rod Recovery system that's designed to shut the liftgate if there's a malfunction. However, if the breakdown happens too quickly after the hatch is opened the prop rod might not work the way it's supposed to. If someone were in the way of the falling liftgate, they could be hurt. For the repair, dealers will update the software for the power liftgate actuator motor control unit to prevent the hatch from closing so quickly. They'll also check the operation of the system afterward. Related Video: RECALL Subject : Liftgate Struts may Fail and Liftgate may Fall Report Receipt Date: JUN 30, 2015 NHTSA Campaign Number: 15V415000 Component(s): STRUCTURE Potential Number of Units Affected: 686,287 All Products Associated with this Recall Vehicle Make Model Model Year(s) BUICK ENCLAVE 2008-2012 CHEVROLET TRAVERSE 2009-2012 GMC ACADIA 2007-2012 SATURN OUTLOOK 2007-2010 Details Manufacturer: General Motors LLC SUMMARY: General Motors LLC (GM) is recalling certain model year 2008-2012 Buick Enclave vehicles manufactured January 3, 2007, to February 29, 2012, 2009-2012 Chevrolet Traverse vehicles manufactured July 6, 2008, to February 29, 2012, 2007-2012 GMC Acadia vehicles manufactured September 15, 2006, to February 29, 2012, and 2007-2010 Saturn Outlook vehicles manufactured August 17, 2006, to March 18, 2010. The affected vehicles, equipped with the power liftgate option, have gas struts that hold the power liftgate up when open. These struts may prematurely wear and the open liftgate may suddenly fall. CONSEQUENCE: If the open liftgate unexpectedly falls, it may strike a person, increasing their risk of injury. REMEDY: GM will notify owners, and dealers will update the software for the power liftgate actuator motor control unit so that the motor will prevent the rapid closing of the lift gate, free of charge. The manufacturer has not yet provided a notification schedule.

The Corvette Museum sinkhole has been filled

Wed, Feb 11 2015

After swallowing eight of the most prized pieces of the collection from the National Corvette Museum, the massive sinkhole from a year ago is rapidly becoming nothing but a bad memory. Based on the museum's weekly construction update, you can barely see the remnants of the 25-foot deep hole once in the floor. The Corvette Museum's Skydome was not always going to look like this. The original hope was to keep the sinkhole there as a tourist attraction. That plan eventually fell through, though, and instead it was decided five of the less-damaged Corvettes would remain unrestored. Progress has been moving fast to get the repairs done. Even a month ago, the hole was still very visible, and the construction company used remote-controlled Bobcat loaders to fill it in. Now, the museum has launched a contest to guess how many tons of stone it took to fill in the massive crater. The winner gets a print of the 2009 Corvette ZR1 Blue Devil being lifted out. Related Gallery National Corvette Museum Car Recovery View 25 Photos News Source: Corvettemuseum via YouTubeImage Credit: National Corvette Museum Weird Car News Chevrolet GM Videos National Corvette Museum

Driving Granatelli's turbine-powered 1978 Chevy Corvette [w/video]

Thu, Jan 8 2015

With its curvy snout and feminine haunches, the third-gen Chevrolet Corvette looks like a dreamy – if dated – exemplar of Sports Car Fantasy 101 when viewed through modern eyes. This particular specimen circa '78, clad in silver and black paint with red pinstripes, appears to be a well-preserved example from the era. Apart from its low-profile Pirellis, slightly raised and slotted hood, spacious stance and a certain hand-painted descriptor alongside its crossed flag logos, you'd never guess there's a Space-Age propulsion unit powering this Coke bottle-bodied ride. Climb inside, and you're presented with aircraft gauges and big, colorful square buttons in the center panel. It takes a push of the "Ignitor" button, a tap of the starter button, and a slide of a T-handle for this nearly 40-year-old sports car to start sounding like Gulfstream G650 ready for takeoff. Yep, you're sitting in an 880-horsepower, turbine-powered Corvette, the only one of its kind in the world. Welcome to the whoosh. What The...? Built by Vince Granatelli, son of Indy 500 guru Andy Granatelli, this curious Corvette came into being by cramming a Pratt & Whitney ST6N-74 gas turbine engine into the donor car's lengthy front end. The same type of Jet A-burning mill powered Granatelli Senior's STP-sponsored racecar at the 1967 Indianapolis 500, where it famously led most of the 198 of 200 laps until a $6 transmission bearing failed, knocking it out of the race. The idea of turbine power usurping internal combustion was so threatening that Indy's governing body restricted turbine performance into obsolescence thereafter. A turbine-powered Corvette sounds excessive because it is. But there are also things about this 880-horsepower, 1,161-pound-feet monster that might surprise you. While it smacks of futurist exoticism and cost a then-dizzying $37,000 in 1967, the Canadian-built powerplant uses 80 percent fewer parts than an internal combustion V8 and will run on virtually anything combustible – whiskey, diesel, even Chanel No. 5. Though it's triple the length of a V8, the Pratt & Whitney beast weighs only 285 pounds. It's also one hell of a robust workhorse, typically serving as an auxiliary power unit for commercial aircraft or a generator in oil fields, where it can run for tens of thousands of consecutive hours before needing an overhaul. To adapt the Chevrolet for jet duty, the nose section was gutted and a sub-frame was built to compensate for the loosey-goosey front end.