Frame Off Restored Chevelle Super Sport 396 V8 4 Speed on 2040-cars

Auto blog

Next-gen Chevy Silverado and GMC Sierra may use carbon fiber

It's been generally accepted that the next generation of full-size GM trucks will use some sort of strong, lightweight material for the beds while retaining steel for the cab. While aluminum seems like the most obvious choice, according to Automotive News, the Chevy Silverado and GMC Sierra will incorporate both aluminum and carbon fiber in their beds. The publication cites sources from within GM, though it seems the introduction of this comparatively exotic material mix is still a few years off. While carbon fiber is both stronger and lighter than steel and aluminum, it takes significantly more time and money to produce, essentially relegating the material to small-volume cars. The main benefit for trucks is the resulting reduction in weight to improve fuel economy without sacrificing the tough, rugged capabilities truck buyers expect. The Ford F-150 made the switch to aluminum for the 2015 model year and it's proved highly successful. It seemed like it was only a matter of time before the competition followed suit. Automotive News says that the next-gen trucks will launch with aluminum beds and that it will take a couple of years before we'll see any carbon fiber incorporated into the design. Even then, only look for the composite material on higher-trim models, with a trickle down to lower-spec trucks possible further in the future. In 2011, GM announced it was working with Japan-based Teijin Limited on a carbon fiber reinforced thermoplastic. There's a good chance that material's introduction will be on trucks. Related Video: News Source: Automotive News Plants/Manufacturing Rumormill Chevrolet GM GMC Truck

GM seeks national mandate for zero-emissions cars

DETROIT — General Motors says it will ask the federal government for one national gas mileage standard, including a requirement that a percentage of auto companies' sales be zero-emissions vehicles. Mark Reuss, GM's executive vice president of product development, said the company will propose that a certain percentage of nationwide sales be made up of vehicles that run on electricity or hydrogen fuel cells. GM says a nationwide program modeled on such a requirement in California could result in 7 million electric vehicles, or EVs, on U.S. roads by 2030. California wants 15.4 percent of vehicle sales by 2025 to be EVs or other zero emission vehicles. Nine other states, including Maryland, Massachusetts, New Jersey and New York, have adopted those requirements. In January, California Governor Jerry Brown set a target of 5 million zero-emission vehicles in California by 2030. The Trump administration criticizes California's ZEV mandate, saying it requires automakers to spend tens of billions of dollars developing vehicles that most consumers do not want, only to sell them at a loss. Reuss told reporters that governments and industries in Asia and Europe "are working together to enact policies now to hasten the shift to an all-electric future. It's very simple: America has the opportunity to lead in the technologies of the future." A national mandate also would create jobs and reduce fuel consumption, CO2 emissions and "make EVs more affordable," Reuss added. GM, the nation's largest automaker, will spell out the request Friday in written comments on a Trump administration proposal to roll back Obama-era fuel economy and emissions standards, freezing them at 2020 levels instead of gradually making them tougher. Under a regulation finalized by the Environmental Protection Agency at the end of the Obama administration, the fleet of new automobiles would have to get 36 miles per gallon by 2025, 10 mpg higher than the current requirement. But the Trump administration's preferred plan is to freeze the standards starting in 2021. Administration officials say waiving the tougher fuel efficiency requirements would make vehicles more affordable, which would get safer cars into consumer hands more quickly. GM on Thursday said it doesn't support the freeze, but wants flexibility to deal with consumers' shift from cars to less-efficient SUVs and trucks.

Cadillac could base its entry-level sedan on the Chevy Cruze [UPDATE]

UPDATE: Cadillac spokesperson Donny Nordlicht tells Autoblog , "The post speculating on a future Cadillac model derived from the Chevrolet Cruze is completely false." Premium automakers Mercedes-Benz and Audi have seen plenty of success with new small front-drive-based sedans. The CLA-Class had its best January ever this year, while Audi moved more of its new A3 in 2015 than its predecessor sold in 2005 through 2010 combined. The fact that Cadillac wants a piece of that pie is no surprise, then. There's a new rumor that GM's luxury brand could launch its own compact – possibly called CT2 – to battle the Germans. Cadillac, a brand that's pushed hard to rebuild its rear-drive reputation, could develop a new entry-level model based on the front-wheel-drive 2016 Chevrolet Cruze's D2XX platform. Go ahead and make your Cimarron jokes. Sources are telling GM Inside News that a Cadillac built on the Delta platform would ditch the Cruze's turbocharged 1.4-liter four-cylinder for a 1.5-liter turbo in base models. General Motors' well received 2.0-liter turbo four would serve in higher-end models. According to GMIN, the Delta-based Cadillac would likely command a $6,000 to $9,000 premium over the Cruze, so figure $23,000 to $26,000 on the low end to $30,000 to $33,000 for something at the top of the range. As much as we dislike the kind of badge engineering that brought us the Cavalier-based Cadillac Cimarron in the '80s, the company has done an admirable job of distinguishing vehicles on shared platforms lately. A Delta-platform Cadillac would at least have a good basis – the new Cruze is surprisingly comfy. That said, we question GM's rationale if this rumor is indeed true. Put simply, Cadillac needs another sedan like I need another student loan payment. The company has four sedans, three of which overlap two segments, and none of which are selling very well. That's not because they're bad, but because customers want crossovers, of which Caddy has but one – the new XT5. Spending the time and money to add a fifth sedan to the mix when the company desperately needs to flesh out its CUV range would be a tremendous mistake. As much as we hate to say it, if Cadillac really wants to add a small, entry-level car to its range, it'd better be a crossover. Related Video: