1969 Chevy Chevelle Ss 396 # Matching Frame Off Restoration on 2040-cars

Auto blog

GM recalls select Chevy Cruze, Sonic and Buick Verano models over airbag issue

General Motors is recalling certain 2012 Buick Verano, Chevrolet Cruze and Sonic models due to a defect in the driver's airbag system. According to the National Highway Traffic Safety Administration, the airbag has a shorting bar which may contact two internal terminals. If that happens during a crash, the supplemental restraint may not deploy, increasing the risk of driver injury. The recall includes a total of 2,949 units.
GM will contact owners and replace the steering wheel airbag coil at no cost. At this point, it's unclear when the recall will begin, though owners may contact the automaker at 1-800-521-7300 for more information. You may also take a closer look at the full NHTSA notice below.

Camaro spy shots show subtly different grille, front fascia

It looks like there some changes in store for the Chevrolet Camaro - the only thing is that we just don't know what Chevy has up its sleeve. Looking at these spy shots, we'd initially be inclined to think that there is just a minor facelift or a new special edition, but upon closer inspection, there are a few oddities about this car that definitely have us intrigued.
The most obvious difference on this prototype is the slightly restyled front fascia with a smaller lower air inlet and the two-bar grille. Then we get to some of the car's mysterious details. For starters, this fascia has the SS vent above the grille, but it looks to be blocked off. Granted this could just be a one-off piece used for testing. What really piqued our interest was at the rear of the car where it has quad exhaust outlets that are used on the ZL1. Could this be the LS7-powered Camaro that we reported on back in December?
At this point, your guess is as good as ours as to what we're looking at here, so let us know in the comments what you think this could be.

UAW to vote on strike at Kentucky Corvette plant

The current wait time for a new Chevrolet Corvette Stingray is well, not short. With word of a strike at the Bowling Green, KY factory responsible for seventh-generation sports car, though, that wait time could end up growing substantially.
Now, a strike is still a ways off. UAW Local 2164, which represents the 800 workers responsible for screwing the Corvette together, is set to vote on authorizing a strike today, but even if the employees give the action a go, it's far from a sure thing. According to The Tennessean, both regional and national union officials would need to put their stamp of approval on strike action.
"The membership has to vote to strike, but it's just a step in the process," said Gary Casteel, the UAW's Region 8 director and one of the people that would need to authorize a strike action. Casteel told The Tennessean, "It's purely a local situation, though. They are having some issues with the local management."