1969 Chevrolet Chevelle 454 Cid Built Southern Car No Money Spared !! on 2040-cars

Auto blog

Next-gen Chevy Silverado and GMC Sierra may use carbon fiber

It's been generally accepted that the next generation of full-size GM trucks will use some sort of strong, lightweight material for the beds while retaining steel for the cab. While aluminum seems like the most obvious choice, according to Automotive News, the Chevy Silverado and GMC Sierra will incorporate both aluminum and carbon fiber in their beds. The publication cites sources from within GM, though it seems the introduction of this comparatively exotic material mix is still a few years off. While carbon fiber is both stronger and lighter than steel and aluminum, it takes significantly more time and money to produce, essentially relegating the material to small-volume cars. The main benefit for trucks is the resulting reduction in weight to improve fuel economy without sacrificing the tough, rugged capabilities truck buyers expect. The Ford F-150 made the switch to aluminum for the 2015 model year and it's proved highly successful. It seemed like it was only a matter of time before the competition followed suit. Automotive News says that the next-gen trucks will launch with aluminum beds and that it will take a couple of years before we'll see any carbon fiber incorporated into the design. Even then, only look for the composite material on higher-trim models, with a trickle down to lower-spec trucks possible further in the future. In 2011, GM announced it was working with Japan-based Teijin Limited on a carbon fiber reinforced thermoplastic. There's a good chance that material's introduction will be on trucks. Related Video: News Source: Automotive News Plants/Manufacturing Rumormill Chevrolet GM GMC Truck

Recharge Wrap-up: Lexus CT 200h is NWAPA's favorite hybrid, 'No Charge to Charge' in LA

The Northwest Automotive Press Association (NWAPA) has given the Lexus CT 200h its Favorite Hybrid title. It named the compact luxury hybrid its favorite of 2014 at its Drive Revolution in Portland (where it also named the new Volkswagen Golf TDI the Northwest Green Car of the Year). According to NWAPA president Nik Miles, the CT 200h earned the honor for "impressive combination of state-of-the-art small car luxury and hybrid technology." For 2014, the Lexus CT200h got an updated front end, including the spindle grille we've been seeing on new Lexus vehicles, plus a redesigned steering wheel and sliding sun visors. Read more in the press release below. Chevrolet credits the Malibu for helping make stop-start mainstream. Chevrolet started including stop-start technology standard in Malibus equipped with the four-cylinder engine. Chevy has sold about 83,000 of that model, so 97 percent of 2014 and 2015 Malibu sales include stop-start. Now, that technology has made its way into the 2015 Impala. With drivers idling an average of 16 minutes a day, stop-start can significantly reduce harmful emissions and save fuel. According to Navigant Research, we can expect annual sales of cars equipped with stop-start technology to surpass 55 million by 2022. Read more in the press release below. Nissan Leaf customers in Los Angeles will get access to free charging beginning August 15. Nissan is extending its "No Charge to Charge" promotion to LA, which will allow customers to charge at public charging stations at no cost. Leaf customers - including those who bought or leased their car from the participating dealerships on or after July 1 - will get an EZ-Charge card, allowing them to use ChargePoint, Blink, CarCharging, AeroVironment and NRG eVgo chargers for free. Rapid chargers can charge the Leaf's battery to 80 percent in 30 minutes. Nissan plans to offer the "No Charge to Charge" in at least 14 more markets in the US, bringing the total to 25, within the next year. See the press release below for more details. California will get six all-electric school buses for three school districts as part of a demonstration program. The California Energy Commission awarded a grant of $1.4 million for the program to National Strategies LLC; this is in addition to a $2.2-million grant from the South Coast Air Quality Management District. The EV buses use vehicle-to-grid technology, allowing them to sell energy back to the grid when it is needed.

Even if GM does close all 5 of those plants, it'll still have too many

DETROIT — General Motors' monumental announcement on Monday that it will close three car assembly plants and two powertrain plants in North America and slash its workforce will only partially close the gap between capacity and demand for the automaker's sedans, according to a Reuters analysis of industry production and capacity data. Sales of traditional passenger cars in North America have been declining for the past six years and are still withering. After GM ends production next year at factories in Michigan, Ohio and Ontario, it will still have four U.S. passenger-car plants — all operating at less than 50 percent of rated capacity, according to figures supplied by LMC Automotive. In comparison, Detroit-based rivals Ford and Fiat Chrysler Automobiles will have one car plant each in North America after 2019. The Detroit Three are facing rapidly dwindling demand for traditional passenger cars from U.S. consumers, many of whom have shifted to crossovers and trucks. Passenger cars accounted for 48 percent of retail light-vehicle sales in the United States in 2014, according to market researchers at J.D. Power and Associates. This year, sedans will account for less than a third of light vehicle sales. That shift in turn has left most North American car plants operating far below their rated capacities, while many SUV and truck plants are running on overtime. The collapse in passenger-car demand is a challenge for nearly all automakers in the United States, including Japan's Toyota and Honda, which have the top-selling models in the compact and midsize car segments. Toyota executives said last month they are evaluating the company's U.S. model lineup. But Toyota also plans to build compact Corolla sedans at a new $1.6 billion factory it is building in Alabama with partner Mazda. The obstacles facing GM in its plans to close more auto factories became apparent on Tuesday as U.S. President Donald Trump threatened to block payment of government electric vehicle subsidies to GM. While it is not certain that Trump unilaterally has the power to do that, he made it clear he intends to use his office to pressure the company to keep open a small car plant in Ohio that GM says will stop building vehicles in March.