2014 Chevrolet Captiva Sport Lt on 2040-cars

Auto blog

Motor Trend puts Chevy Camaro Z28 and Porsche 911 GT3 Head 2 Head

Motor Trend admits, "This is an unfair comparison." But that doesn't make it any less fun to watch when they pit a Camaro Z/28 against the Porsche 911 GT3. The former has a 7.0-liter V8 with 505 horsepower and 481 pound-feet of torque shifted through a six-speed manual. The latter has a 3.8-liter flat-six with 475 hp and 324 lb-ft shifted through a seven-speed dual-clutch transmission. Yet those are only the little disparities – the big disparities are mass and money: the Camaro weighs 3,882 pounds and costs $76,150 as-tested, the Porsche weighs 3,267 pounds and costs $145,785. But they're both about hardcore performance, so MT takes them out on the street, to the drag strip, to the parking lot for figure eights and a skidpad test, and finally to Big Willow for Randy Pobst to give his professional assessment. Remember when a lotta people spent a lotta time debating Pirates vs. Ninjas? This is like that, only it's the "haul-ass good-time car" vs. the "track surgeon." Enjoy the debate in the video.

Chevy SS prototype spotted wearing Pontiac G8 clothes

Do not adjust your computer screen, you are not seeing the rebirth of the Pontiac brand. General Motors has chosen to use a G8 to disguise a test mule for the latest prototype of the forthcoming Chevrolet SS. The G8 was closely related to the Holden Commodore and Vauxhall VXR, the platform upon which the new Chevrolet performance model will be based. It should come as little surprise, then, that GM has opted to use the cladding from the former G8.
Thought the front clip of this mule is pure Pontiac, note the vents immediately behind the front wheel. That is a distinctive design hallmark of the Vauxhall VXR. Also note that this vehicle is right-hand drive, as the Holden and its Chevy counterpart will be very closely related. That likely includes potential drivetrains. The spy photos of this mule also reveal very wide rear tires, and rear wheels that do not match the fronts.

GM recalls 8,500 Chevrolet Malibu models for rear suspension glitch

According to a letter from General Motors to the National Highway Traffic Safety Administration, flaws in the build process of the 2013 Chevrolet Malibu have led to the recall of 8,519 cars. Units built between December 6, 2011 and January 15, 2013 may have been assembled with rear suspension cradles that had insufficient torque applied to certain bolts. That out-of-spec assembly could lead to issues ranging from slight noises to a loss of vehicle control.
The problem was first noticed in December of last year by a GM test fleet driver and eventually tracked back to the improperly torqued bolts on the suspension cradle assembled through July 2012 by a supplier located not too far from the Malibu's Detroit/Hamtramck Assembly Plant. Since an official NHTSA recall notice has not been issued yet, it isn't clear whether or not Detroit-built Malibus were the only ones affected (the 2013 Malibu is also built at GM's Fairfax Assembly Plant in Kansas City, Kansas). Dealers will fix the problem by inspecting vehicles for proper torque specs, retightening if not within specs and, in some cases, perform a rear-wheel alignment.