Completly Restored 1979 Z/28 Camaro on 2040-cars

Auto blog

GM tells owners not to use SUV wipers due to fire risk

General Motors is recalling 31,685 examples of the 2016 Buick Enclave, Chevrolet Traverse, and GMC Acadia because a short circuit in the windshield wiper motor can potentially lead to a fire. Due to the danger, the company is asking owners not to use the wipers until the problem is fixed, according to The Detroit Free Press citing the Associated Press. A manufacturing defect in the wiper motor cover means that the electrical terminals can come into contact and cause a short. The part could "melt, smoke, or catch fire," according to a statement from GM. The company will get them fixed immediately, and dealers will replace the cover. If there's bad weather at the time the owner specifies to get the recall work completed, the automaker will come pick up the crossovers. Depending on parts availability, the automaker will supply a rental car for customers, as well. The issue was discovered at the factory. According to the company's statement, only 6,405 actually made it to customers, and they were notified immediately by overnight letter. The rest were in dealer stock. The affected crossovers carry build dates between August 18, 2015 and September 24, 2015. Of those, there are 29,295 in the US and 1,073 in Canada. GM Statement: General Motors has told the National Highway Traffic Safety Administration that it will recall approximately 29,295 2016 model year Chevrolet Traverse, Buick Enclave and GMC Acadia SUVs in the U.S. because the front windshield wiper motor may overheat when in use because of a manufacturing defect. In some cases, the front windshield wiper motor cover may melt, smoke or catch fire. The approximately 6,405 customers who have taken delivery of these vehicles were notified by overnight letter and are urged to contact a GM dealer as soon as possible to arrange a service appointment. These customers should not use the front windshield wipers until they have been repaired. If weather conditions prevent driving the vehicle without using the windshield wipers, GM will arrange to pick up the vehicle for servicing. If repair parts are unavailable, GM will provide a rental car at no cost until parts become available. The total population, including Canada, Mexico and exports, is approximately 31,685. About 25,280 of these vehicles are in dealer stock and will not be sold until repairs are made.

Audi S4 drivers are the most accident-prone, insurance report says

Culling data from more than 4.6 million automobile insurance applications, researchers at the Insurify insurance comparison marketplace picked a winner — or more to the point, a loser — in its determination of the car model with the most accidents so far in 2023: the Audi S4. Why does the sporty, luxury-class German sedan rank so high (or so low)? The organization found that S4 drivers, piloting a car with almost 350 horsepower, are among those who collect the most speeding tickets, and that they get into accidents at a rate 54 percent higher than the national average. If the S4 isnÂ’t a surprise with an at-fault accident rate of 11.7 percent, consider the “family friendly” brand that appears three times on the Insurity list: Subaru. It is represented by three models, including the turbocharged WRX and XV Crosstrek, and at the better-performing bottom of the list, the Subaru Impreza, with an accident rate of 10.3 percent.  In 2023, 7.6 percent of U.S. drivers were involved in at least one at-fault accident in the prior seven years. For drivers of cars on this list, the average at-fault accident rate was 10.5 percent, meaning these drivers are 1.4 times as likely to have an at-fault accident on record. According to its statement, the Insurity data science team explored key safety features, driver behavior, and Insurance Institute for Highway Safety (IIHS) evaluations to pinpoint possible reasons behind these carsÂ’ high accident rates. Following is the list, counting down to the models with most reported accidents: 10. Subaru Impreza (percentage of drivers with a prior at-fault accident on record: 10.3 percent; MSRP base model): $19,795) 9. Kia Niro (percentage of drivers with a prior at-fault accident on record: 10.4 percent; MSRP base model): $26,590) 8. Chevrolet Silverado LD (percentage of drivers with a prior at-fault accident on record: 10.4%, MSRP base model): $34,500) 7. Subaru XV Crosstrek (percentage of drivers with a prior at-fault accident on record: 10.5 percent, MSRP 6. Subaru WRX.(percentage of drivers with a prior at-fault accident on record: 10.7% MSRP base model): $29,605) 5. Toyota GR86 (percentage of drivers with a prior at-fault accident on record: 10.8 percent MSRP base model): $29,900) 4. Hyundai Veloster N (percentage of drivers with a prior at-fault accident on record: 10.9 percent; MSRP base model): $32,500) 3.

Next-gen Chevy Silverado and GMC Sierra may use carbon fiber

It's been generally accepted that the next generation of full-size GM trucks will use some sort of strong, lightweight material for the beds while retaining steel for the cab. While aluminum seems like the most obvious choice, according to Automotive News, the Chevy Silverado and GMC Sierra will incorporate both aluminum and carbon fiber in their beds. The publication cites sources from within GM, though it seems the introduction of this comparatively exotic material mix is still a few years off. While carbon fiber is both stronger and lighter than steel and aluminum, it takes significantly more time and money to produce, essentially relegating the material to small-volume cars. The main benefit for trucks is the resulting reduction in weight to improve fuel economy without sacrificing the tough, rugged capabilities truck buyers expect. The Ford F-150 made the switch to aluminum for the 2015 model year and it's proved highly successful. It seemed like it was only a matter of time before the competition followed suit. Automotive News says that the next-gen trucks will launch with aluminum beds and that it will take a couple of years before we'll see any carbon fiber incorporated into the design. Even then, only look for the composite material on higher-trim models, with a trickle down to lower-spec trucks possible further in the future. In 2011, GM announced it was working with Japan-based Teijin Limited on a carbon fiber reinforced thermoplastic. There's a good chance that material's introduction will be on trucks. Related Video: News Source: Automotive News Plants/Manufacturing Rumormill Chevrolet GM GMC Truck