2010 Chevrolet Camaro 2 Ss Yellow Coupe 1 Ownr 9250 Miles 426hp 6.2l Many Extras on 2040-cars

Auto blog

How GM engineers are using diaper 'snow' to keep you warm

Testing how snow affects General Motors' vehicles isn't really a problem right now for the company's engineers, but in the dog days of summer the process isn't exactly easy. The only real option is for them to book time at the automaker's climatic wind tunnel. However, a flash of brilliance from an engineer allows snow to be simulated regardless of the temperature outside, and the discovery is all because of his daughter's wet diaper. The realization came to GM Thermal Systems engineer Nicholas Jahn while he was swimming with his daughter and noticed how her diaper ballooned in size in the water. He found out the substance that makes this possible is called sodium polyacrylate. When the material gets wet it grows and forms fluffy flakes that are a close imitation of snow. Best of all, the stuff can be prepared easily any time of the year, and it's reusable. The engineering team uses the material to test the effectiveness of the heating systems of GM's vehicles. They spread the sodium polyacrylate over the inlets at the base of the windshield to obstruct the airflow and then crank the heater. After some time, they can see how much is being sucked into the system and design more efficient systems in the future. See how the process works in the video above and read about the diaper discovery in GM's press release below. Diapers Change Chevy Cruze Winter Warm-up Time GM validation engineer uses diaper material "snow" to reduce frigid drives 2015-01-06 DETROIT – An item commonly found on an infant's changing table is helping General Motors' engineers simulate snow year round, ensuring heating systems in cars like the 2015 Chevrolet Cruze can quickly and efficiently warm its interior. Packed snow can prevent air from entering the inlet panel at the bottom of the windshield, obstructing the flow of air into the heating system and reducing the amount of air it can push out. This can lead to less efficient warming of the car's interior and windshield defrosting. "The last thing anyone wants to do when it's freezing cold out is scrape their windshield," said Nicholas Jahn, GM Vehicle Thermal Systems engineer. "The testing we perform on the Chevrolet Cruze with the diaper material allows us to maximize the car's heating capabilities." Ironically, Jahn stumbled upon his diaper-based testing method in the middle of summer. During a swim with his daughter, he noticed her diaper multiplied in size when it came into contact with water.

GM patent reveals new two-stage turbocharger

Modern turbochargers may be some of the best ever made, but performance is something that engineers are always trying to improve. According to GM Inside News, General Motors (GM) is hoping to alleviate some of the negative aspects of a two-stage turbocharger setup with a newly-patented design. The patent, that was filed on May 19, 2016, reveals a clever bypass system that allows the engine, a four-cylinder unit, to optimize both the low-pressure and high-pressure inlets for its respective functions. According to the filing, a conventional two-stage turbocharger setup is engineered to allow both turbines to operate simultaneously at low and mid engine speeds. At high engine speeds, only the low-pressure turbine works. The setup can't isolate either the low or high pressure side, which can impair low-end performance. GM's new two-stage turbocharger setup looks to eliminate this by linking the high-pressure turbo to the exhaust manifold through the high-pressure inlet duct. The low-pressure turbo is attached to the high-pressure turbo by a low-pressure inlet duct, which is linked to a connecting channel. A single actuator that is housed in the exhaust manifold creates a bypass that can opens the high-pressure inlet or close the connecting channel. Depending on what the engine load and speed is, the ECU guides the actuator—a single rotating spindle with discs corresponding to flanges on the high and low pressure sides—to isolate one of the two turbos. Isolating the turbos allow the respective inlets to be engineered for the best possible fluid dynamic performance. The setup should increase performance and decrease lag. There's no word on what car this setup will make an appearance on, but it will most likely be used in premium vehicles before trickling down to the rest of GM's vehicles. Related Video: News Source: GM Inside News, AutoGuide via GM Authority Cadillac Chevrolet GM Technology Sedan turbo patent engine turbocharging

Recharge Wrap-up: Tesla sells Model S 85 and 70D in Malaysia, Chevy Spark EV built using clean energy

Tesla will send Model S 70D and Model S 85 EVs to Malaysia for leasing to government-linked companies. Only those companies will have access to the models as a two-year lease, which will be imported and leased by Malaysian Green Technology Corporation. The plan is part of an initiative by the Ministry of Energy, Green Technology and Water to allow government officials and other influential people to get to know the electric vehicles and the benefits that come along with them. Most of the 120 vehicles available will be the 70D model, and the lessee companies will have the option to purchase the cars at the end of the two years. Read more from Paul Tan's Automotive News. Wanxiang is hosting students from Delaware in China as part of a program to learn Mandarin and visit schools and science and technology sites. Wanxiang, the auto parts company that acquired Fisker (which had manufacturing based in Delaware) and battery maker A123 Systems, will give the students tours of its solar technology facilities, among other places, and see what daily life is like for families in the region. The program helps students interested in science and technology to foster marketable skills — like learning a foreign language — that will help them get jobs in industries around the world. Read more at Delaware Online. The Chevrolet Spark EV's electric motor (pictured) and drive unit are manufactured using clean energy. The e-motors building of the General Motors Baltimore Operations complex has a new rooftop solar array and uses LED and CFL lighting, helping the building recently earn LEED Silver certification. The landfill-free facility also takes advantage of the 1.23-megawatt solar array on the grounds, helping it source six percent its energy from renewable sources. The plant has reduced its energy intensity by 15.5 percent in three years, and continues to work toward reducing consumption and sourcing clean energy. "We believe reducing our environmental footprint is good for the climate and good for our business," says GM Executive Director of Global Public Policy Greg Martin. Read more in the press release below. Spark EV Motor Plant Fueled by Green, Clean Energy ENERGY STAR®, USGBC and Maryland state agency recognize facility's efforts WHITE MARSH, Md. – Chevrolet recently began selling the Spark EV to Maryland commuters able to take advantage of the state's robust charging infrastructure.