1967 Rs Camaro Clear Title Great Project True Barn Find Clean And Complete Nice! on 2040-cars

Auto blog

NHTSA upgrades probe into 1.7 million GM vehicles over wiper failures

WASHINGTON — The U.S. National Highway Traffic Safety Administration (NHTSA) said Tuesday it is upgrading an investigation into 1.7 million General Motors vehicles for windshield wiper failures. The auto safety agency opened the probe in November 2018 to see if GM needed to expand a 2016 recall of 2013 model year Chevrolet Equinox and GMC Terrain SUVs to cover additional vehicles. The engineering analysis probe covers 2010-2012 and 2014-2016 Equinox and Terrain vehicles. NHTSA could demand a recall after it completes the probe. NHTSA said it has reviewed 1,900 complaints and reports related to the issue in the 1.7 million vehicles. NHTSA said it has seen elevated failure rates in the 1.7 million vehicles, even though GM said the recalled vehicles have "double the warranty rate and five times the complaint rate." GM said it will "fully cooperate to support their investigation. We do not believe these windshield washer systems are defective." The wiper failures that prompted the 2016 recall were attributed to water and debris intrusion into the windshield wiper assembly ball joints, leading to excessive wear and eventual detachment of the ball joint. GM said it was installing an improved windshield wiper motor and transmission assembly and relocating a drain hole at the base of the windshield. Related Video:

Chevy Bolt-based prototype may be a Buick EV for China

Late last spring, we got a look at a GM prototype that was clearly based on the Chevy Bolt EV, but with updated styling. It seemed like it could be a more crossover-styled Bolt, given the recently trademarked name of EUV. Now we get another look at the prototype, but the bodywork seems less suggestive of a Chevy, and more of a Buick. This vehicle definitely still appears to be based on the Bolt, rather than on another small GM platform. In the photos of it next to the current model, the size, wheelbase and profile are extremely similar. There are differences, though. The nose isn't as sloped or as rounded, and the rear window kicks up a little earlier. The biggest changes are in the front and rear fascias, and it's here that we see hints of Buick. There are prominent air inlets on each side of the front bumper that give the car a more aggressive look. The headlights still have a fairly rounded, organic look, but with little extensions like fangs underneath. The styled running-light section, rounded shape and the smoked lenses seem very Buick-like. The grille features a large badge that doesn't fit the shape of a bow-tie, and is more that of a round logo like Buick's. Around at the back, the full-width taillights stand out, and in the middle there is obviously a round badge, again like a Buick. The wide taillights would also be a natural evolution of Buick's current light design language that uses somewhat wide and thin lights. The rear bumper has been redesigned with new lower taillights. Now that we've established that this seems very much like a Buick, we don't think we'll see this particular version offered here with the badge. This is more likely a Buick version of the Bolt for the Chinese market, where the brand is associated with luxury and has been the spearhead for GM's electric and hybrid models. In fact, the Chevy Volt hybrid was sold there as the Buick Velite 5, which was part of a family of a electrified Velite models. This would probably also carry a Velite badge as well. While we might not see this specific Buick variant, we probably will see it offered as a Chevy in some form. With its more aggressive, crossover shape, it could be the rumored EUV model. Or it could be just a refresh of the current Bolt, since the model has been largely unchanged since its introduction for the 2017 model year. And extrapolating from this prototype, we can see how the headlights could be tweaked to tie into those air scoops as on the Suburban and Silverado.

2013 Chevy COPO Camaro announced with two new engines and manual option

Chevrolet is following up the 2012 COPO Camaro with another limited run of the drag-strip-ready production car for 2013. Ditching the superchargers, the 2013 COPO Camaro can only be equipped with one of three naturally aspirated V8 engines, and other new features include the option of a manual transmission, new front springs, some minor styling changes and a lower starting price of $86,000. All cars are designed to abide by the rules of the NHRA's Stock Eliminator or Super Stock classifications, depending on in which series buyers wish to enter their Chevrolet Camaro.
Returning for 2013 is the 427-cubic-inch V8 producing 425 horsepower, but the new engines include a 325-hp 350-CID V8 and a 375-hp 396-CID V8. Buyers can select to purchase all three engines, and each will be matched with the sequence number of that car; the track-only COPO cars will not have vehicle identification numbers and can't be registered for street use.
Chevrolet is also offering unique enthusiast-specific options such as a COPO Build Book and the opportunity for owners to help assemble their car's engine at the Chevrolet Performance Build Center in Wixom, MI.