Chevrolet 4x4 1977 Short Wheel Base Lifted 4 Inches With 36 Inch Mud Tires on 2040-cars

Auto blog

Next-gen Chevy Silverado and GMC Sierra may use carbon fiber

It's been generally accepted that the next generation of full-size GM trucks will use some sort of strong, lightweight material for the beds while retaining steel for the cab. While aluminum seems like the most obvious choice, according to Automotive News, the Chevy Silverado and GMC Sierra will incorporate both aluminum and carbon fiber in their beds. The publication cites sources from within GM, though it seems the introduction of this comparatively exotic material mix is still a few years off. While carbon fiber is both stronger and lighter than steel and aluminum, it takes significantly more time and money to produce, essentially relegating the material to small-volume cars. The main benefit for trucks is the resulting reduction in weight to improve fuel economy without sacrificing the tough, rugged capabilities truck buyers expect. The Ford F-150 made the switch to aluminum for the 2015 model year and it's proved highly successful. It seemed like it was only a matter of time before the competition followed suit. Automotive News says that the next-gen trucks will launch with aluminum beds and that it will take a couple of years before we'll see any carbon fiber incorporated into the design. Even then, only look for the composite material on higher-trim models, with a trickle down to lower-spec trucks possible further in the future. In 2011, GM announced it was working with Japan-based Teijin Limited on a carbon fiber reinforced thermoplastic. There's a good chance that material's introduction will be on trucks. Related Video: News Source: Automotive News Plants/Manufacturing Rumormill Chevrolet GM GMC Truck

Here are a few of our automotive guilty pleasures

It goes without saying, but I'll say it anyway. The world is full of cars, and just about as many of them are bad as are good. It's pretty easy to pick which fall into each category after giving them a thorough walkaround and, more important, driving them. But every once in a while, an automobile straddles the line somehow between good and bad — it may be hideously overpriced and therefore a marketplace failure, it may be stupid quick in a straight line but handles like a drunken noodle, or it may have an interior that looks like it was made of a mess of injection-molded Legos. Heck, maybe all three. Yet there's something special about some bad cars that actually makes them likable. The idea for this list came to me while I was browsing classified ads for cars within a few hundred miles of my house. I ran across a few oddballs and shared them with the rest of the team in our online chat room. It turns out several of us have a few automotive guilty pleasures that we're willing to admit to. We'll call a few of 'em out here. Feel free to share some of your own in the comments below. Dodge Neon SRT4 and Caliber SRT4: The Neon was a passably good and plucky little city car when it debuted for the 1995 model year. The Caliber, which replaced the aging Neon and sought to replace its friendly marketing campaign with something more sinister, was panned from the very outset for its cheap interior furnishings, but at least offered some decent utility with its hatchback shape. What the two little front-wheel-drive Dodge models have in common are their rip-roarin' SRT variants, each powered by turbocharged 2.4-liter four-cylinder engines. Known for their propensity to light up their front tires under hard acceleration, the duo were legitimately quick and fun to drive with a fantastic turbo whoosh that called to mind the early days of turbo technology. — Consumer Editor Jeremy Korzeniewski  Chevrolet HHR SS: Chevy's HHR SS came out early in my automotive journalism career, and I have fond memories of the press launch (and having dinner with Bob Lutz) that included plenty of tire-smoking hard launches and demonstrations of the manual transmission's no-lift shift feature. The 260-horsepower turbocharged four-cylinder was and still is a spunky little engine that makes the retro-inspired HHR a fun little hot rod that works quite well as a fun little daily driver.

Chevy's low-cost pedestrian avoidance to debut on 2016 Malibu

The mainstreaming of safety technologies that began on luxury vehicles will get a big boost from General Motors later this year. The General says it plans to offer 22 driver assistance systems across its product portfolio of 2016 models, starting with the redesigned Chevrolet Malibu - the one that we know will keep tabs on teenagers for the benefit of parents. Pedestrian avoidance will be another of its available options. Instead of kitting the sedan out with numerous and expensive radar arrays, the GM system uses the camera mounted next to the rearview mirror that is already used for the lane-keeping function. New software lets it detect pedestrians, and when it detects a potential collision with one, it can alert the driver and brake autonomously if the driver doesn't react. Eventually, engineers want to give it the ability to do the same with cyclists. Because it uses existing hardware updated with new code, GM says the application costs "a few hundred dollars." GM demonstrated the Front Pedestrian Braking preventing a crash with a dummy pedestrian at speeds up to 15 miles per hour. Automotive News reports that it will reduce the severity of impact up to 40 miles per hour, but "may not be of much use in collisions at higher speeds." That feature will also join the options list of the Cadillac CT6. The press release below has more on GM's driver tech soon on the way. Related Video: GM Paving Way to Smarter and Safer Driving at All-New Active Safety Test Area 22 crash-avoidance technologies offered on 2016 Chevrolet, Buick, GMC and Cadillac models MILFORD, Mich. 2015-07-24 – Chevrolet, Buick, GMC and Cadillac will offer 22 different active safety technologies across their 2016 model year U.S. lineups, ranging from driver alerts to those that automatically intervene and assist the driver in critical situations. Safety engineers will develop and test these and other safety technologies for products around the world at GM's new, 52-acre Active Safety Test Area at its Milford Proving Ground near Detroit. The $14 million facility officially opened Friday. "Our comprehensive safety strategy of helping customers before, during and after a crash continues," said Jeff Boyer, vice president of GM Global Vehicle Safety.