1972 Chevrolet Big Block Patina Custom C10 Ratrod on 2040-cars

Auto blog

Car and Driver reveals spy shots of mid-engine 2017 Corvette

Some news in the car world is perennial, and some is perennially wrong. Typically news about some upcoming mid-engined Chevy Corvette has fallen into the latter category, with rumors never yet generating a road car. This time could very well be different. Car and Driver has some exclusive photographs of what would appear to be a Corvette test mule with a mid-mounted engine. The car in question might look like a Holden SSV ute that's undergone some indelicate modification, but C/D editor Don Sherman assures that the bones of a C8 'Vette live within that crude bodywork. Sherman points to the closeness of the cabin to the front axle as clue number one of this car's mid-engine attitude, as well as the powertrain-sized space between the back of the seats and the rear axle. The roof and glasshouse are all clearly plucked from the current C7, and the gas tank filler positioned on the B-pillar is another huge clue. The buff book estimates that the mule points to a timeline for sale, even. Testing on this level could mean a mid-engined C8 ready for sale in as few as 20 months, or for the 2017 model year. Click over to Car and Driver to have a close look at this important set of spy photographs, as well as a rendering of what a finished C8 might ultimately look like

Next-gen Chevy Silverado and GMC Sierra may use carbon fiber

It's been generally accepted that the next generation of full-size GM trucks will use some sort of strong, lightweight material for the beds while retaining steel for the cab. While aluminum seems like the most obvious choice, according to Automotive News, the Chevy Silverado and GMC Sierra will incorporate both aluminum and carbon fiber in their beds. The publication cites sources from within GM, though it seems the introduction of this comparatively exotic material mix is still a few years off. While carbon fiber is both stronger and lighter than steel and aluminum, it takes significantly more time and money to produce, essentially relegating the material to small-volume cars. The main benefit for trucks is the resulting reduction in weight to improve fuel economy without sacrificing the tough, rugged capabilities truck buyers expect. The Ford F-150 made the switch to aluminum for the 2015 model year and it's proved highly successful. It seemed like it was only a matter of time before the competition followed suit. Automotive News says that the next-gen trucks will launch with aluminum beds and that it will take a couple of years before we'll see any carbon fiber incorporated into the design. Even then, only look for the composite material on higher-trim models, with a trickle down to lower-spec trucks possible further in the future. In 2011, GM announced it was working with Japan-based Teijin Limited on a carbon fiber reinforced thermoplastic. There's a good chance that material's introduction will be on trucks. Related Video: News Source: Automotive News Plants/Manufacturing Rumormill Chevrolet GM GMC Truck

Chevy gets cracking on Cruze EV fleet testing

Chevrolet Cruze EV - Click above for high-res image gallery
The Chevrolet Volt hasn't yet gone on sale, but General Motors is looking at ways of expanding its electric vehicle lineup. Chevy, along with partner LG, is employing a group of all-electric cars in the form of the Cruze. The sedans are part of a demonstration fleet which is located in Seoul, South Korea and is being used to provide data in an electric vehicle research project. The goal is to gather information on driving patterns and charging behavior in addition to consumer acceptance.
The Cruze EVs, along with some Daewoo Lacetti Premieres EVs, are the first fleet of full-size electric vehicles and should provide invaluable information for The General. Staying full-size means not sacrificing cargo space, so the battery pack is mounted to the underbody, leaving the trunk area open for plenty recyclable, canvas grocery bags.