1960 Panel Truck In Primer Runs And Drives 6 Cylinder 3speed Manual Trans on 2040-cars
Ninety Six, South Carolina, United States
Body Type:panel truck
Engine:6 cylinder
Vehicle Title:Clear
For Sale By:owner
Interior Color: some primer some original
Make: Chevrolet
Number of Cylinders: 6
Model: C-10
Trim: 2 door
Drive Type: rwd
Mileage: 19,000
Warranty: none
Exterior Color: gray primer
1960 c10 apache panel truck 6 cly 3 speed manual trans truck in primer does drive and no smoke gas tank has been reconditioned has original rims and original trans also most body work has been done rebuilt carb still has oil bath filter most of truck is original
Chevrolet C-10 for Sale
Auto Services in South Carolina
Tony`s Automotive and Tire ★★★★★
Star Automotive ★★★★★
Sprayglo Auto Refinishing and Body Repair ★★★★★
Speed Street Collision Center ★★★★★
Presnell`s Auto Repair ★★★★★
Peterson`s Auto Service & Detail Shop ★★★★★
Auto blog
Want a V8 on the cheap? Buy a work truck
Thu, Aug 3 2017In case you didn't notice, V8 cars have gotten pretty expensive. If you want a modern muscle car like the Dodge Challenger R/T, Ford Mustang GT, or Chevy Camaro SS, you'll need between $34,000 and $38,000 for a stripped out example of one. The cheapest of those is the Challenger, and the priciest is the Camaro. These are also the cheapest V8 cars the companies offer. But if you absolutely have to have a V8 for less, there is an option, work trucks. As it turns out, all of the Big Three offer their most basic work trucks with V8s. And because they're so basic, they're pretty affordable, especially when sticking with the standard two-wheel drive. A Ram 1500 Tradesman with a V8 can be had for as little as $29,840, which is a little more than $4,000 less than a Challenger R/T. For a bit more at $30,275, you can have a Chevy Silverado W/T, almost $8,000 less than a Camaro SS. The most expensive is the V8 Ford F-150 starts at a starting price of $30,670, which is a bit over $5,000 less than the Mustang. Of course you'll be in an ultra bare bones vehicle with few comforts, and the price will go up if you add stuff, but we're bargain hunting here, and sacrifices are sometimes necessary. Besides, what you lose in comfort, you gain in loads of cargo space and towing (try to look at the bright side). Also, as a side note, all three trucks are available with optional electronic locking rear differentials. At the discounted price of these trucks, you still get a heaping helping of power. The most potent of the trio is the Ram 1500 Tradesman with 395 horsepower and 410 pound-feet of torque generated by a 5.7-liter V8. Compared with the Challenger R/T, the Ram is up by 20 horsepower and they're tied for torque. The value proposition is even more stark between the two vehicles when looking at the price per horsepower. Each pony in the Ram costs $75.54, while the Challenger charges you $90.91. The Challenger is also more expensive per horsepower than its close competitors. The F-150's 5.0-liter V8 is just barely behind the Ram with 395 horsepower and 400 pound-feet of torque. That's still more power than the Challenger, and it matches the torque of the 2017 Mustang GT. On the down side, it still would be down 20 horsepower on that same 2017 Mustang, and it's behind by 60 horsepower and 20 pound-feet on the new 2018 Mustang GT. The F-150 also just edges out the Mustang in the dollar per horsepower measure.
GM dealers unhappy about pickup prices
Mon, 21 Oct 2013The backlash is beginning. Following General Motors' price hike of the Chevrolet Silverado and GMC Sierra last week, dealers across the country are expressing their ire over increasing prices in the face of rebates and discounts on trucks from Ford and Ram.
Speaking to Automotive News, Sam Pilato, the general manager at Dimmitt Chevrolet in Clearwater, FL, Silverados are "selling very poorly." W. Carrol Smith, the president of Monument Chevrolet in the heart of truck country, Texas, said, "[GM's] position is that the vehicle stands on its own and it doesn't need a bigger rebate. That's not what the market is telling us."
According to AN, that's the general attitude amongst Chevy and GMC dealers across the country, where the twin pickups are getting butchered in sales by competitors offering up to $9,000 off their sticker prices. Part of the problem for GM is that its trucks are arriving on the market near the end of the current F-150's lifecycle, a fact that Ford has taken advantage of.
More Corvette Stingray Factoids: Vanishing panel gaps and 26-mpg LT1
Thu, 28 Feb 2013During January's Detroit Auto Show, we managed a longer than expected wandering tag-team interview with C7 Corvette chief engineering exec Tadge Juechter (pictured above), and LT1 engine boss Jordan Lee (pictured below). They are, quite honestly, two of the very nicest bigshot lads to ever walk the engineering corridors of an American manufacturer. Both are enthralled by what they're doing for a day job. So are we.
We've followed the pre-sale anticipation for the Chevrolet C7 Corvette Stingray like an Oreck vacuum yanking every speck of dirt from a well-trampled carpet. Everything is reportable and contains a grain of further knowledge about this dramatically important and cheered-for car, as it continues to be pressured into representing all that is superior about the American dream. The Corvette wears one heavy cloak.
So, most of what was talked about has been expertly reported already right here on Autoblog. But, looking through our notes again, both Jeuchter and Lee added facts to the buzzing mix.