2005 Chevrolet Blazer Extreme on 2040-cars

Auto blog

Next-gen Chevy Silverado and GMC Sierra may use carbon fiber

It's been generally accepted that the next generation of full-size GM trucks will use some sort of strong, lightweight material for the beds while retaining steel for the cab. While aluminum seems like the most obvious choice, according to Automotive News, the Chevy Silverado and GMC Sierra will incorporate both aluminum and carbon fiber in their beds. The publication cites sources from within GM, though it seems the introduction of this comparatively exotic material mix is still a few years off. While carbon fiber is both stronger and lighter than steel and aluminum, it takes significantly more time and money to produce, essentially relegating the material to small-volume cars. The main benefit for trucks is the resulting reduction in weight to improve fuel economy without sacrificing the tough, rugged capabilities truck buyers expect. The Ford F-150 made the switch to aluminum for the 2015 model year and it's proved highly successful. It seemed like it was only a matter of time before the competition followed suit. Automotive News says that the next-gen trucks will launch with aluminum beds and that it will take a couple of years before we'll see any carbon fiber incorporated into the design. Even then, only look for the composite material on higher-trim models, with a trickle down to lower-spec trucks possible further in the future. In 2011, GM announced it was working with Japan-based Teijin Limited on a carbon fiber reinforced thermoplastic. There's a good chance that material's introduction will be on trucks. Related Video: News Source: Automotive News Plants/Manufacturing Rumormill Chevrolet GM GMC Truck

Why does the Corvette Stingray have so many vents? Here's why

Just looking at the new 2014 Chevrolet Corvette Stingray, it's not hard to see that the car's design was created with aerodynamics at the forefront, but Chevrolet designers point out exactly what went into designing the iconic coupe in a pair of recently released videos. The videos show the Corvette going through early design phases, including clay models and wind tunnel tests, as well as talking to the car's chief engineer, Tadge Juechter.
Both videos help explain various aspects of the C7 Corvette, but it's the aero tuning of the car that is most interesting. This includes extra attention paid to the lower air dam and vented hood to help reduce drag and lift, while the rear quarter inlets are for differential and transmission cooling. Juechter said that some of these aero-tuned elements were inspired from GM's involvement in racing.
If you have about five minutes and you can't get enough information about the new 'Vette, then check out the videos posted below.

NHTSA closes book on Ford, GM probes of 600,000 vehicles

US safety regulators have closed a pair of investigations into some 500,000 Ford Crown Victoria, Mercury Grand Marquis and Marauder sedans built between 2004 to 2007, and 100,000 Chevrolet Impala models from 2014. The Ford investigation focused on rusting heat shields, which may become dislodged and jam the steering, according to Reuters. The National Highway Traffic Safety Administration found that this happened very rarely. In fact, of the ten incidents filed with the government safety watchdog, six came from a single police department, which evidently had some sort of problem with its reporting. As for the Impala, the NHTSA investigators attributed two incidences of "unintended autonomous braking" to user error. In both cases, the vehicles were involved in rear-end collisions. According to GM investigators, it's believed that drivers accidentally activated the electric parking brake, causing the collisions. The vehicles in question were rental cars. Featured Gallery Ford Crown Victoria Related Gallery 2014 Chevrolet Impala View 10 Photos News Source: ReutersImage Credit: Ford, Chevrolet Government/Legal Chevrolet Ford Safety Sedan ford crown victoria mercury grand marquis