2000 Chevy Blazer Ls 4x4 V6 Clean No Reserve Auction! on 2040-cars
Chelmsford, Massachusetts, United States
Chevrolet Blazer for Sale
Auto Services in Massachusetts
Worldwide Preowned ★★★★★
Vanderveer Motors ★★★★★
Swanson Buick-GMC Truck ★★★★★
Superior Systems ★★★★★
Sully`s Auto Body ★★★★★
Standard Auto Wrecking ★★★★★
Auto blog
Audi S4 drivers are the most accident-prone, insurance report says
Sun, Jun 25 2023Culling data from more than 4.6 million automobile insurance applications, researchers at the Insurify insurance comparison marketplace picked a winner — or more to the point, a loser — in its determination of the car model with the most accidents so far in 2023: the Audi S4. Why does the sporty, luxury-class German sedan rank so high (or so low)? The organization found that S4 drivers, piloting a car with almost 350 horsepower, are among those who collect the most speeding tickets, and that they get into accidents at a rate 54 percent higher than the national average. If the S4 isnÂ’t a surprise with an at-fault accident rate of 11.7 percent, consider the “family friendly” brand that appears three times on the Insurity list: Subaru. It is represented by three models, including the turbocharged WRX and XV Crosstrek, and at the better-performing bottom of the list, the Subaru Impreza, with an accident rate of 10.3 percent. In 2023, 7.6 percent of U.S. drivers were involved in at least one at-fault accident in the prior seven years. For drivers of cars on this list, the average at-fault accident rate was 10.5 percent, meaning these drivers are 1.4 times as likely to have an at-fault accident on record. According to its statement, the Insurity data science team explored key safety features, driver behavior, and Insurance Institute for Highway Safety (IIHS) evaluations to pinpoint possible reasons behind these carsÂ’ high accident rates. Following is the list, counting down to the models with most reported accidents: 10. Subaru Impreza (percentage of drivers with a prior at-fault accident on record: 10.3 percent; MSRP base model): $19,795) 9. Kia Niro (percentage of drivers with a prior at-fault accident on record: 10.4 percent; MSRP base model): $26,590) 8. Chevrolet Silverado LD (percentage of drivers with a prior at-fault accident on record: 10.4%, MSRP base model): $34,500) 7. Subaru XV Crosstrek (percentage of drivers with a prior at-fault accident on record: 10.5 percent, MSRP 6. Subaru WRX.(percentage of drivers with a prior at-fault accident on record: 10.7% MSRP base model): $29,605) 5. Toyota GR86 (percentage of drivers with a prior at-fault accident on record: 10.8 percent MSRP base model): $29,900) 4. Hyundai Veloster N (percentage of drivers with a prior at-fault accident on record: 10.9 percent; MSRP base model): $32,500) 3.
Next-gen Chevy Silverado and GMC Sierra may use carbon fiber
Thu, Dec 7 2017It's been generally accepted that the next generation of full-size GM trucks will use some sort of strong, lightweight material for the beds while retaining steel for the cab. While aluminum seems like the most obvious choice, according to Automotive News, the Chevy Silverado and GMC Sierra will incorporate both aluminum and carbon fiber in their beds. The publication cites sources from within GM, though it seems the introduction of this comparatively exotic material mix is still a few years off. While carbon fiber is both stronger and lighter than steel and aluminum, it takes significantly more time and money to produce, essentially relegating the material to small-volume cars. The main benefit for trucks is the resulting reduction in weight to improve fuel economy without sacrificing the tough, rugged capabilities truck buyers expect. The Ford F-150 made the switch to aluminum for the 2015 model year and it's proved highly successful. It seemed like it was only a matter of time before the competition followed suit. Automotive News says that the next-gen trucks will launch with aluminum beds and that it will take a couple of years before we'll see any carbon fiber incorporated into the design. Even then, only look for the composite material on higher-trim models, with a trickle down to lower-spec trucks possible further in the future. In 2011, GM announced it was working with Japan-based Teijin Limited on a carbon fiber reinforced thermoplastic. There's a good chance that material's introduction will be on trucks. Related Video: News Source: Automotive News Plants/Manufacturing Rumormill Chevrolet GM GMC Truck
GM to trim Russian output, raise prices amid currency woes
Thu, Feb 5 2015General Motors is shutting down its factory in Russia's second largest city, St. Petersburg, from the middle of March until the middle of May as the country's currency, the ruble, continues to give economists fits. The ruble's value has plunged due not only to western sanctions, but a precipitous fall in oil prices. We knew these factors were already impacting the auto industry there, as Ford reported in its 2014 earnings statement, and now they're forcing GM to cut production at the factory, shown above, that is responsible for production of the Chevrolet Cruze and Opel Astra. Meanwhile, Automotive News is citing Russian outlet Kommersant as saying that GM has hiked its prices in the country by an average of 20 percent over the past two months. While a GM spokesman confirmed the St. Petersburg plant would be shut down for the two-month span reported by Kommersant and AN, he would not confirm the price increase. News Source: Automotive News - sub. req.Image Credit: Alexander Nikolayev / AFP / Getty Images Earnings/Financials Plants/Manufacturing Chevrolet GM Opel opel astra