1992 S-10 Blazer C-10 Front End V-8 Pro Street Hot Rod Pro Touring on 2040-cars
Port Orange, Florida, United States
Vehicle Title:Clear
Engine:4.3L 262Cu. In. V6 GAS OHV Naturally Aspirated
Body Type:Sport Utility
Fuel Type:GAS
Exterior Color: Gray
Make: Chevrolet
Interior Color: Black
Model: S10 Blazer
Trim: Sport Sport Utility 2-Door
Drive Type: RWD
Number of Cylinders: 6
Mileage: 900
Chevrolet Blazer for Sale
- 1978 k5 blazer
- 1989 chevrolet blazer silverado sport utility 2-door 5.7l(US $9,500.00)
- Suv 4.3liter v-6, automatic, 4x4, ls, "low reserve"
- Suv 4.3l cd preferred equipment group 1sc convenience group 4 speakers lighting
- Lt 4.3l cd trip odometer reclining seats reading light(s) power windows
- 1994 chevrolet blazer 2 door 4x4 georgia tahoe(US $4,850.00)
Auto Services in Florida
Yow`s Automotive Machine ★★★★★
Xtreme Car Installation ★★★★★
Whitt Rentals ★★★★★
Vlads Autobahn LLC ★★★★★
Village Ford ★★★★★
Ultimate Euro Repair ★★★★★
Auto blog
Sunday Drive: Trucks and SUVs of all shapes and sizes
Sun, Nov 5 2017The American automotive marketplace is dominated by trucks and SUVs, and so was the last week of coverage on Autoblog. By far, the most popular story of the week was our First Drive of the 2018 Lincoln Navigator. It may look like an old-school lumberer, but in reality Lincoln's flagship is a thoroughly modern, turbocharged-V6-powered, three-row, luxury people mover. The Jeep Wrangler is the world's most recognizable vehicle. So it's no surprise that the next version looks a whole heck of a lot like the last one, and the one before. It's all in the details, which is why we were so excited when Jeep decided to unleash a trio of images showing both two- and four-door Wranglers for us to dissect ahead of the SUV's official debut at the L.A. Auto Show later this year. Past that, spy photos of the next Chevy Silverado and Ram 1500 were predictably popular. See both of those below, and the cap it all off, check out the entire week's worth of SEMA coverage – including the bonkers Hennessey VelociRaptor 6x6 – in our mega image gallery at the bottom of this post. Enjoy! As always, tune in to Autoblog next week for a front-row seat to all the happenings worth following in the automotive industry. 2018 Lincoln Navigator First Drive | From black sheep to flagship 2018 Jeep Wrangler revealed: First photos released before L.A. Auto Show debut 2019 Chevy Silverado looks slim and clean beneath the camo 2019 Ram 1500 gets vertical touchscreen infotainment system 2017 SEMA Show Mega Photo Gallery Chevrolet Jeep Lincoln RAM Truck SUV recap sunday drive
Next-gen Chevy Silverado and GMC Sierra may use carbon fiber
Thu, Dec 7 2017It's been generally accepted that the next generation of full-size GM trucks will use some sort of strong, lightweight material for the beds while retaining steel for the cab. While aluminum seems like the most obvious choice, according to Automotive News, the Chevy Silverado and GMC Sierra will incorporate both aluminum and carbon fiber in their beds. The publication cites sources from within GM, though it seems the introduction of this comparatively exotic material mix is still a few years off. While carbon fiber is both stronger and lighter than steel and aluminum, it takes significantly more time and money to produce, essentially relegating the material to small-volume cars. The main benefit for trucks is the resulting reduction in weight to improve fuel economy without sacrificing the tough, rugged capabilities truck buyers expect. The Ford F-150 made the switch to aluminum for the 2015 model year and it's proved highly successful. It seemed like it was only a matter of time before the competition followed suit. Automotive News says that the next-gen trucks will launch with aluminum beds and that it will take a couple of years before we'll see any carbon fiber incorporated into the design. Even then, only look for the composite material on higher-trim models, with a trickle down to lower-spec trucks possible further in the future. In 2011, GM announced it was working with Japan-based Teijin Limited on a carbon fiber reinforced thermoplastic. There's a good chance that material's introduction will be on trucks. Related Video: News Source: Automotive News Plants/Manufacturing Rumormill Chevrolet GM GMC Truck
GM might outsource vans to AM General
Thu, Nov 26 2015General Motors will possibly boost production of the Chevrolet Colorado and GMC Canyon at the Wentzville Assembly Plant in Missouri by contracting out some commercial van manufacturing to AM General. Demand for the two midsize trucks continues to boom, and GM would like to take advantage of the strong market for them. The possible deal came to light in a letter to workers at the factory, according to Automotive News. "This potential partnership would free up production capacity and allow the organization to capitalize on our ability to build midsize trucks to further satisfy customer demand," a portion of the document allegedly said. AM General would reportedly only take over assembly of the cutaway versions of the Chevy Express and GMC Savana. Customers and critics have quickly embraced the latest Colorado and Canyon since their introduction. The Chevy just won back-to-back Motor Trend Truck of the Year awards. GM also had to add a third shift and extra workers in 2014 just to keep up with demand. The Wentzville plant even increased employment on the weekends earlier in 2015 to assemble an extra 2,000 of the trucks each month. While the two pickups boom, deliveries for the Chevy Express and GMC Savana are down 26.9 percent and 26.6 percent respectively through the first 10 months of the year. GM doesn't break out numbers for the cutaway versions, but they make up about a third of production, according to Automotive News. AM General built the Humvee for the US military and does some contract work with automakers. For example, the company's Indiana factory now produces the Mercedes-Benz R-Class for export to China. Here's hoping this potential deal will help both GM and AM General keep their factories humming. Related Video: