1987 Chevrolet Blazer Silverado Sport Utility 2-door 5.7l on 2040-cars

Auto blog

2015 Chevrolet Corvette Z06 [w/videos]

I think I was supposed to be back hours ago. Driving northwest on State Road 190 with a final destination deep in the heart of the Death Valley National Park, it occurs to me that I might have agreed to return after an hour or so, instead of the four I'll end up stealing, solo, in the new Z06. Somewhere in the combination of mountain vistas, arching, speed-hungry desert roads, and the sound of this titanic engine on a constant run up the rev ladder, I forgot everything I'd promised back at home base. The generous, civilized part of me worries for a moment that absconding with the new-best Corvette might have left one of my fellow journalists without a car. But the selfish part of me – the part largely in control of the rocket-launcher of a throttle under my right foot ­– says "screw it." I spent two days with the 2015 Chevy Corvette Z06, a monster of a sports car that will soon be dominating track days everywhere, and I never once was inclined to share it. Hurtling through the shattered stillness of the desert and pulling big Gs at Spring Mountain circuit, I never felt overly disposed to give up my seat. This Corvette, more than any I've yet driven, was deep enough to hold my attention; for two days, for two years, probably. With this Z06, the Corvette steps over the amazing-for-the-price category, and solidly into the best-cars-in-the-world zone. There are peripheral elements that remind me of its blue collar, Bowtie heritage, sure, but there's more that simply begs me to carry on driving... faster. Most casual car observers will be able to pick the 2015 Z06 out from its less aggressive Stingray brothers. Subtler hints include a new, more open grille, larger extractor on the taller hood and rather discreet badges on the flanks of the car. More outrageous is the finned spoiler on the rear trunk lid, and the widebody look offered from flared fenders – an extra 1.57 inches (40 millimeters) at their beefiest point. Even driving around performance-car-laden Pahrump, NV – loaded thanks to the very active community at the Spring Mountain racing resort – members of the local populace were turning heads, waving and generally noting the Z06 with approval when I drove through town. In Torch Red over black painted aluminum wheels, staggered at 19-inches in front and 20 at the back, the amped-up Z06 hits a new level of road presence for the C7.

GM recalls Chevy Express, GMC Savana over rollaway concern

The National Highway Traffic Safety Administration has issued a recall notice for a small number of General Motors fullsize vans due to possible rollaway concerns. On certain 2013 Chevrolet Express and 2013 GMC Savana models, it is possible to remove the key from the ignition without the shifter being in park.
Only 980 total units are being affected by this recall, and GM is fixing the issue by replacing the ignition cylinder and associated keys. Affected Chevy vans were built during most of November and December while its GMC counterpart was only built for a week in November. The recall goes into effect on January 23, and to find out if your vehicle applies to the recall, the GM and NHTSA contact numbers can be found on the official recall notice, which is posted below.

Next-gen Chevy Silverado and GMC Sierra may use carbon fiber

It's been generally accepted that the next generation of full-size GM trucks will use some sort of strong, lightweight material for the beds while retaining steel for the cab. While aluminum seems like the most obvious choice, according to Automotive News, the Chevy Silverado and GMC Sierra will incorporate both aluminum and carbon fiber in their beds. The publication cites sources from within GM, though it seems the introduction of this comparatively exotic material mix is still a few years off. While carbon fiber is both stronger and lighter than steel and aluminum, it takes significantly more time and money to produce, essentially relegating the material to small-volume cars. The main benefit for trucks is the resulting reduction in weight to improve fuel economy without sacrificing the tough, rugged capabilities truck buyers expect. The Ford F-150 made the switch to aluminum for the 2015 model year and it's proved highly successful. It seemed like it was only a matter of time before the competition followed suit. Automotive News says that the next-gen trucks will launch with aluminum beds and that it will take a couple of years before we'll see any carbon fiber incorporated into the design. Even then, only look for the composite material on higher-trim models, with a trickle down to lower-spec trucks possible further in the future. In 2011, GM announced it was working with Japan-based Teijin Limited on a carbon fiber reinforced thermoplastic. There's a good chance that material's introduction will be on trucks. Related Video: News Source: Automotive News Plants/Manufacturing Rumormill Chevrolet GM GMC Truck