1974 Chevrolet Blazer 4wd on 2040-cars

Auto blog

This is your 2014 Chevrolet SS

Think you've waited long enough for this? If so, then you'll want to savor the high-res photos we've so far been given of the 2014 Chevrolet SS, the first rear-wheel-drive performance sedan from The Bowtie in 17 years.
We all know its our version of the brand new VF-model Holden Commodore, but what's under the hood that earns the appellation "performance?" A 6.2-liter LS3 V8 engine producing 415 horsepower and 415 pound-feet of torque. That's 35 hp and lb-ft less than the same engine is expected to produce in the 2014 Chevrolet Corvette. Chevrolet says the sedan will get from 0-to-60 miles per hour "in about five seconds."
Shifting comes courtesy of a six-speed automatic with paddles on the steering wheel, while stopping arrive via four-piston Brembo calipers up front, a single sliding piston in back. The forged aluminum wheels are 19-inchers all around, each set supporting right around 50 percent of the sedan's weight, and the aluminum hood and trunk are meant to keep the center of gravity low.

2016 Chevy Colorado and GMC Canyon recalled for opening console lids

The Basics: General Motors is recalling 9,200 examples of the 2016 Chevrolet Colorado with build dates between August 25, 2015 and September 24, 2015, and the 2016 GMC Canyon manufactured from August 28, 2015 to September 24, 2015. In total, 8,763 of these pickups are in the US, and the rest are in Canada or Mexico. The Problem: The console compartment lid could open in a crash, and the items inside the storage compartment might hit occupants during the accident. This fault puts the pickups out of compliance with the Federal Motor Vehicle Safety Standard. Injuries/Deaths: None reported. The fix: Dealers will replace the console compartment door latch assembly with an improved part. If you own one: GM has not yet told NHTSA when the repairs for these pickups begin. Related Video: RECALL Subject : Console Door may not Fully Latch/FMVSS 201 Report Receipt Date: DEC 01, 2015 NHTSA Campaign Number: 15V807000 Component(s): LATCHES/LOCKS/LINKAGES Potential Number of Units Affected: 8,763 All Products Associated with this Recall Vehicle MakeModelModel Year(s) CHEVROLET COLORADO 2016 GMC CANYON 2016 Details Manufacturer: General Motors LLC SUMMARY: General Motors LLC (GM) is recalling certain model year 2016 Chevrolet Colorado trucks manufactured August 25, 2015 to September 24, 2015, and GMC Canyon trucks manufactured August 28, 2015 to September 24, 2015. The affected vehicles have a console compartment lid latch assembly that may fail to keep the compartment door closed in the event of a crash. As such, these vehicles fail to comply with the requirements of the Federal Motor Vehicle Safety Standard (FMVSS) number 201, "Occupant Protection in Interior Impact." CONSEQUENCE: If the console compartment door does not remain closed in a crash, the contents stored in the console may strike the vehicle occupants, increasing their risk of injury. REMEDY: GM will notify owners, and dealers will replace the console compartment door latch assembly, free of charge. The manufacturer has not yet provided a notification schedule. Owners may contact Chevrolet customer service at 1-800-222-1020, or GMC customer service at 1-800-462-8782. GM's number for this recall is 16370. NOTES: Owners may also contact the National Highway Traffic Safety Administration Vehicle Safety Hotline at 1-888-327-4236 (TTY 1-800-424-9153), or go to www.safercar.gov.

Experimental mid-engine XP-819 Corvette going up for auction

It seems to be commonplace that when a new Corvette is in development, rumors swirl about a possible mid-engine layout. As is the case of Chevy's most recent C7 Corvette, these rumors never pan out.
In any case, the idea for a 'Vette with an engine mounted behind the driver can probably all be traced back to a single car, the 1964 XP-819 prototype. Built as an "engineering exercise" back in 1964, the prototype was designed with a rear-mounted engine. History tells us that the idea of a rear-engine Corvette fizzled, and the XP-819 was eventually cut up into pieces and stored at a shop in Daytona Beach, FL.
After sitting for untold years, a restoration project started on the car, and while it isn't yet fully completed, the current owner of the car, Mid America Motorworks, will have the car on display at the 2013 Amelia Island Concours d'Elegance as a "driveable chassis" with hopes of having a fully completed car ready to bring to next year's show.