'98 Chevrolet Blazer Lt Sport Utility 4-door 4.3l Tan 4 Wd Clean Minimal Rust Ny on 2040-cars
Glenfield, New York, United States
Still on the road - I just want a smaller vehicle
Needs 2 O2 sensors, back brakes and rotors AC needs a pump Heater needs a motor - heat and fan work fine but it's either on or off Fairly new starter, fuel pump and battery Tires still have miles left on them Push Button 4WD works great Cruise doesn't seem to be working Rear wiper blade missing - motor still works |
Chevrolet Blazer for Sale
- 1979 chevy k5 blazer! fully restored and tastefully customized!!
- 2000 chevy blazer 4x4 ls 110k miles clean carfax new car trade no reserve
- 1995 awd chevy blazer with a factory ( 210hp ) high output 4.3liter v6 122k !!(US $2,600.00)
- 1974 chevrolet blazer 4x4 cheyenne - original - one of a kind!
- 1976 chevrolet k5 2wd blazer(US $6,250.00)
- 1998 chevy blazer ls 4x4, no reserve, fl dealer,runs and drives great
Auto Services in New York
Xtreme Auto Sales ★★★★★
WaLo Automotive ★★★★★
Volkswagon of Orchard Park ★★★★★
Urban Automotive ★★★★★
Trombley Tire & Auto ★★★★★
Tony`s Boulevard Service Center ★★★★★
Auto blog
Next-gen Chevy Silverado and GMC Sierra may use carbon fiber
Thu, Dec 7 2017It's been generally accepted that the next generation of full-size GM trucks will use some sort of strong, lightweight material for the beds while retaining steel for the cab. While aluminum seems like the most obvious choice, according to Automotive News, the Chevy Silverado and GMC Sierra will incorporate both aluminum and carbon fiber in their beds. The publication cites sources from within GM, though it seems the introduction of this comparatively exotic material mix is still a few years off. While carbon fiber is both stronger and lighter than steel and aluminum, it takes significantly more time and money to produce, essentially relegating the material to small-volume cars. The main benefit for trucks is the resulting reduction in weight to improve fuel economy without sacrificing the tough, rugged capabilities truck buyers expect. The Ford F-150 made the switch to aluminum for the 2015 model year and it's proved highly successful. It seemed like it was only a matter of time before the competition followed suit. Automotive News says that the next-gen trucks will launch with aluminum beds and that it will take a couple of years before we'll see any carbon fiber incorporated into the design. Even then, only look for the composite material on higher-trim models, with a trickle down to lower-spec trucks possible further in the future. In 2011, GM announced it was working with Japan-based Teijin Limited on a carbon fiber reinforced thermoplastic. There's a good chance that material's introduction will be on trucks. Related Video: News Source: Automotive News Plants/Manufacturing Rumormill Chevrolet GM GMC Truck
GM 6.2L V8 claims most powerful light-duty truck engine title
Thu, 12 Sep 2013General Motors has officially captured the horsepower crown for mainstream pickup trucks with its 6.2-liter V8. The big mill, available in both the Chevrolet Silverado and GMC Sierra, comes to market with 420 horsepower and 460 pound-feet of torque, handily outdoing its two cross-town competitors, Ram (5.7-liter V8, 395 ponies and 407 lb-ft) and Ford (6.2-liter V8, 411 hp and 434 lb-ft).
The new GM 6.2 will take a bit of an investment, though. Those that want the extra thrust will need to go with either the LTZ or High Country trims from the Chevy, or the SLT and Denali trims from GMC, which are the two highest trim levels for the respective vehicles. Trim levels aside, if you're in the business of towing, GM has you covered. Optioned with the 6.2-liter V8 and the Max Trailering Package, owners will be able to pull 12,000 pounds, a hugely impressive figure.
We still aren't certain as to what sort of economy the new engine will get, but it'll probably be a bad bet for the fuel conscious. As for availability, expect to see the 6.2-liter trucks in showrooms later in the fall.
Read This: Auto Extremist advocates for Corvette as brand with multiple models [w/poll]
Fri, 25 Jan 2013The 2014 Chevrolet Corvette really grinds Peter De Lorenzo's gears. Or, more accurately, the self-anointed Auto Extremist has an issue with what he sees as mismanagement of the legendary sports car by General Motors executives. In a new editorial on his website, De Lorenzo argues it's time to split Corvette off from Chevrolet to create an all-new brand, complete with a model range with at least three new takes on the sports car. Capable of fully leveraging the successes of the Corvette Racing program and brandishing the full might of GM's technical prowess, the Corvette brand would theoretically give Porsche something to sweat over.
Sure, that sounds like a party, but given GM's troubled track record when it comes to launching (let alone managing) brands, we say that's slippery slope that could just as easily end with the whole Corvette franchise in the scrap bin. Either way, the notion is certainly an interesting one. Head over to Auto Extremist to take in the full editorial, and then let us know what you think in Comments. Should GM split off its most storied nameplate?
View Poll