57 Chevy 210 Black Corvette 350 Engine & Trans on 2040-cars
Hollywood, Florida, United States
Body Type:Sedan
Vehicle Title:Clear
Engine:82 Corvet 350 3 speed trams in floor
Fuel Type:Gasoline
For Sale By:Private Seller
Number of Cylinders: 8
Make: Chevrolet
Model: Bel Air/150/210
Trim: 210 with Belair trim
Mileage: 84,000
Exterior Color: Black
Drive Type: rear
Interior Color: Gray/Black
1957 chevrolet 4 door 210 black sedan. Interior in excellent condition, (Light Grey/Black trim). Excellent driving conditions. Late model 350 Corvette engine. 3 speed standard transmission Corvette rally wheels all new belaire trim. ALL ORIGINAL JUST FEW UPGRADES STRONG MOTOR, DRIVES EXCELLENT UPGRADED ELECTRONIC IGNITION AND ALTERNATOR DRIVER SIDE WINDOW MINOR CRACKED. HAS REPLACEMENT WINDOW NOT INSTALLED EXCELLENT INTERIOR 210 ORIGINAL PATTERNS ALL DOORS WORK HOOD AND TRUNK SOLID
Excellent driver Not restored but excellent body in and out.
Chevrolet Bel Air/150/210 for Sale
1955 chevy 210 2 door sedan(US $14,000.00)
1955 chevy nomad wagon california car(US $10,800.00)
1952 chevy 2dr deluxe nice original condition(US $3,400.00)
Show stopping 1956 bel air hardtop restomod
1955 chevy 210 4-door sedan restoration project(US $29,000.00)
1955 chevrolet bel air nomad custom, very rare(US $74,900.00)
Auto Services in Florida
Zip Auto Glass Repair ★★★★★
Willie`s Paint & Body Shop ★★★★★
Williamson Cadillac Buick GMC ★★★★★
We Buy Cars ★★★★★
Wayne Akers Truck Rentals ★★★★★
Valvoline Instant Oil Change ★★★★★
Auto blog
Some 2012-13 Chevy Volts may not have enough battery coolant
Mon, Jun 23 2014The 2012 and 2013 model year Chevrolet Volt extended-range plug-in vehicle may have a battery glitch caused by low coolant levels. No recall has been issued and General Motors is taking care of the issue at no cost to drivers. Some of the affected Volts may have lower-than-advisable coolant levels because of some pesky air pockets in the car's cooling circuit. When the coolant levels get too low, the charging system for the battery powering the car's onboard generator (i.e. the Rechargeable Energy Storage System, or the RESS) may be shut down, turning one's Volt into a run-of-the-mill gas-powered car, and a pricey one at that. The Car Connection says GM is advising owners of the '12 and '13 Volts to contact their local Chevy dealer for a free fix. GM representatives didn't immediately respond to a request for comment from AutoblogGreen for more details. We believe this is a separate issue than the one that brought 8,000 Volts back to the dealers for a battery coolant fix, what GM called a "voluntary customer satisfaction effort," a few years ago. General Motors sold 23,094 Chevy Volts last year after selling 23,461 Volts in 2012, so that fix-it list may get fairly lengthy. Check out a GM-Volt.com user thread related to this issue here. *UPDATE: Chevrolet spokesman Randy Fox confirmed in an e-mail to AutoblogGreen that the company issued a service bulletin to dealers that they may need to top off coolant levels on certain Volts because of the issue, and that the vehicle will "return to normal charging operation" once that's done.
Chevy's 6.6-liter Duramax is pretty much all new
Thu, Sep 29 2016To say there's a heated battle in heavy-duty pickups is an understatement, with Chevrolet, Ford, and Ram constantly trading blows of increased torque, horsepower, and towing capacity. The latest salvo is the revised, more powerful turbo diesel 6.6-liter Duramax V8 in the 2017 Chevy Silverado. It has 910 pound-feet of torque, an increase of 145, putting it nearly level with the Ford Super Duty. Here's a closer look at where those gains come from. How exactly did Chevrolet add all that torque plus 48 horsepower? The automaker essentially took a fine-tooth comb to the entire engine. Chevy says it changed 90 percent of the V8, and the cumulative effect of those small changes adds up to big increases. As you might guess, the turbocharger is updated. The larger unit features electric actuation of the variable nozzle turbine (VNT), and what Chevy calls a double axle cartridge mechanism that separates the VNT moving parts from the housing. That helps with heat performance as well, with a claim that the exhaust side of the turbo can run continuously up to 1,436 degrees Fahrenheit. Helping that cause are six exhaust gaskets made of Inconel - an nickel alloy that contains chromium and iron – and upgraded stainless steel for the exhaust manifold. Despite having the same cast iron cylinder block, albeit with some minor enhancements, the engine has new cylinder heads, pistons, piston pins, connecting rods, and crankshaft, which have all been upgraded to handle 20 percent higher cylinder pressures. Alongside the increase in pressure, Chevrolet also increased the cylinder head's structure with a honeycomb design. The pattern features high-strength aluminum with dual layer water jackets that not only improve strength, but also optimize water flow for better cooling. For 2017, the cylinder head also benefits from integrated plenum that aids the engine in getting more air under heavy loads. The cylinder head isn't the only component to get a minor update, as the pistons have a larger diameter pin for improved oil flow. The same detailed improvements has been bestowed to the humble connecting rods (second in our hearts only to the inanimate carbon rod). The new design has the bolts oriented roughly 45-degrees to the rod instead of parallel. The angle split design, as it's called allows for easier passage through the cylinder.
GM Design shows what could have been and what might be
Thu, May 27 2021We periodically like to check in with GM Design's Instagram account to see what they're cooking up. Even better is when we catch a glimpse of an alternate history of what legendary designers from The General's past were thinking, though those ideas may not have made it into production. This week, for example, the account posted some illustrations from George Camp, whose career at GM spanned nearly four decades, from 1963 to 2001. One of the renderings is of what appears to be a 1971-72 Pontiac GTO Judge, but with two headlights instead of the production unit's quad beams. The rear departs from the canonical version most dramatically, with a massive integrated wing. Other bits that didn't make the production cut include large side vents, a gill-like side marker and rectangular intakes below the headlights that wouldn't be out of place on a modern design today. Amazingly, from what we can make out of the date, it appears that the drawing was done sometime in 1965, which makes it quite prescient.      View this post on Instagram            A post shared by GM Design (@generalmotorsdesign) There's also a very aerodynamic interpretation of a Corvette ZR-1. To our eyes it splits the difference between the 1986 Corvette Indy concept and a fourth-generation F-body Pontiac Firebird, so perhaps parts of Camp's work on this sketch did make it into physical form. There's also a radical sports car concept from May 1970 that resembles the Mazda RX-500 concept from the same year, a Syd Mead-looking Cadillac coupe, and an Oldsmobile with a cool take on the company's trademark waterfall grille and elements of the Colonnade Cutlass at the rear. Other recent posts include a FJ Cruiser-like off-road EV, a sleek coupe with the Chevy corporate grille, and a rendering of a Silverado-esque pickup that looks far better than the current production version.      View this post on Instagram            A post shared by GM Design (@generalmotorsdesign) It's pretty easy to lose hours in the account, but it's always fascinating to see GM's visions of what could have been and what might be. Related Video: