1955 Chevrolet Bel Air/150/210 -- on 2040-cars

Auto blog

Recharge Wrap-up: U of M wins Solar Challenge, family attempts record-breaking e-bike ride

The University of Michigan Solar Car Team has won the 2014 American Solar Challenge. It is the team's eighth national championship, its fifth in a row, and its first using Siemens' product lifecycle management (PLM) software. The race took place over 1,722 miles and seven days traveling across eight states. The team's car, called "Quantum," outpaced the nearest competitor by four hours. Looking forward, Michigan Solar Car Project Manager Pavan Naik says, "The switch to Siemens tools will give us the ability to model and simulate everything and truly allow us to optimize the performance of our new vehicle. As we start on our quest to win the World Solar Challenge in 2015, we'll be leveraging a full complement of PLM solutions." Read more in the press release below. The EcoCar3 competition, in which teams will convert Chevrolet Camaros into hybrid electric cars, begins in September. The various college teams will have four years to lessen the car's environmental impact as much as possible while maintaining performance and, of course, that cool Camaro design. EcoCar3, which is put on by the US Department of Energy and General Motors, kicks off with a workshop in Novi, Michigan from September 16 - 18. Read more at the DOE website at the dedicated EcoCar3 site or watch the announcement video at our previous post. Zap and Jonway Auto are shifting to a high rate of EV production. Zap already has two lines creating the Urbee EV to met demand, and is switching over a third to make electric minivans and SUVs. The company aims to produce 30,000 EVs by 2015 for the Chinese market. Zap says it has a backlog of 25,000 Urbee orders. Read more in the press release below. A family of four hopes to make a world record-breaking, 6,000-mile electric bike journey this fall. The family, which recently drove from Argentina to Montana in a pickup with a camper, will ride from Montana to Maine, then down the East Coast to Florida in an attempt to break the record for longest electric bicycle ride. They'll use two bikes. The Father, Thomas, will ride one of the bikes carrying one of the children, while the rest of the family rides in a support vehicle, with the mother, Dylan, riding the second bike when they can find others to drive. They have started a crowdfunding campaign for some of the equipment needed to document the trip. See the video below or read more at Treehugger.

Driving Granatelli's turbine-powered 1978 Chevy Corvette [w/video]

With its curvy snout and feminine haunches, the third-gen Chevrolet Corvette looks like a dreamy – if dated – exemplar of Sports Car Fantasy 101 when viewed through modern eyes. This particular specimen circa '78, clad in silver and black paint with red pinstripes, appears to be a well-preserved example from the era. Apart from its low-profile Pirellis, slightly raised and slotted hood, spacious stance and a certain hand-painted descriptor alongside its crossed flag logos, you'd never guess there's a Space-Age propulsion unit powering this Coke bottle-bodied ride. Climb inside, and you're presented with aircraft gauges and big, colorful square buttons in the center panel. It takes a push of the "Ignitor" button, a tap of the starter button, and a slide of a T-handle for this nearly 40-year-old sports car to start sounding like Gulfstream G650 ready for takeoff. Yep, you're sitting in an 880-horsepower, turbine-powered Corvette, the only one of its kind in the world. Welcome to the whoosh. What The...? Built by Vince Granatelli, son of Indy 500 guru Andy Granatelli, this curious Corvette came into being by cramming a Pratt & Whitney ST6N-74 gas turbine engine into the donor car's lengthy front end. The same type of Jet A-burning mill powered Granatelli Senior's STP-sponsored racecar at the 1967 Indianapolis 500, where it famously led most of the 198 of 200 laps until a $6 transmission bearing failed, knocking it out of the race. The idea of turbine power usurping internal combustion was so threatening that Indy's governing body restricted turbine performance into obsolescence thereafter. A turbine-powered Corvette sounds excessive because it is. But there are also things about this 880-horsepower, 1,161-pound-feet monster that might surprise you. While it smacks of futurist exoticism and cost a then-dizzying $37,000 in 1967, the Canadian-built powerplant uses 80 percent fewer parts than an internal combustion V8 and will run on virtually anything combustible – whiskey, diesel, even Chanel No. 5. Though it's triple the length of a V8, the Pratt & Whitney beast weighs only 285 pounds. It's also one hell of a robust workhorse, typically serving as an auxiliary power unit for commercial aircraft or a generator in oil fields, where it can run for tens of thousands of consecutive hours before needing an overhaul. To adapt the Chevrolet for jet duty, the nose section was gutted and a sub-frame was built to compensate for the loosey-goosey front end.

2019 GMC Sierra revealed with CarbonPro bed and new diesel engine

It's only March, and it's already been one hell of a year for trucks. January's Detroit Auto Show saw the reveals of the 2019 Ram 1500, 2019 Ford Ranger and the 2019 Chevy Silverado. The Chicago Auto Show brought new versions of the Toyota Tacoma and Toyota Tundra TRD Pro. Today, we finally got our first look at the Silverado's twin, the 2019 GMC Sierra. The truck features new styling, a new diesel engine and — on the Sierra Denali — a carbon fiber bed. As with every new full-size truck, the Sierra is larger than the outgoing model in almost every dimension, though exact dimensions haven't been revealed. For reference, though, the Chevy Silverado's bed is 7-inches wider than before. The new Sierra grille is more upright than before and features new C-shaped lighting. The Denali gets LED headlights, tail lights and fog lights. Both SLT and Denali trims get unique 22-inch wheels. As we saw in spy photos, the Sierra's interior is mostly just a copy of the Silverado's with some chrome accents sprinkled throughout. If you like the current truck interiors, you'll be pleased with the new model. Those hoping for a wholesale change will be left wanting. The big improvements inside include a full-color heads-up display, trailer hitch assist apps and cameras, and the rear-camera mirror found in models like the Chevy Traverse and Cadillac CT6. Safety and convenience features include a surround-view camera, blind-spot monitoring, pedestrian detection and low-speed automatic braking. Like the Silverado, there's been a significant effort to cut weight in the new Sierra. The 2019 model loses as much as 360 pounds compared to the current truck. It uses aluminum for the doors, hood and tailgate. Steel is still used for the fenders, roof and standard cargo box. The Denali, however, gets the real surprise here. Available only on the top-tier trim, the bed box will be constructed of carbon fiber rather than steel, saving 62 pounds. Carbon fiber only replaces the steel inner panels and floor. GMC says the carbon fiber will also help scratch and corrosion resistance. SLT and Denali models also get a new MultiPro tailgate. This is unique to the Sierra and separate from the Silverado's power assist unit. A new feature that helps one get into and out of the bed using an assist handle. The tailgate step has a maximum weight capacity of 375 pounds. There multiple positions that allow customers to extend the bed, or drop the center vertically to gain easier access to the back.