Hatchback Manual Fwd Blue Financing Available on 2040-cars

Auto blog

GM recalling nearly 4,000 vehicles over airbag concerns

Four different General Motors vehicles from the 2012 model year are being recalled over a potential airbag issue. The driver's side airbag shorting bar in the 2012 Buick Verano and 2012 Chevrolet Camaro, Cruze and Sonic might make contact with the airbag terminals, even during a crash. If so, the airbag won't deploy when it should, possibly increasing injury to the driver.
The recall is expected to begin on February 13 for the 3,896 units that might be affected. GM will notify owners who can then take their vehicles to dealers to have the airbag coil replaced. A bulletin from the National Highway Traffic Safety Administration below has more info.

GM to add 1,200 workers at 2 Michigan factories

DETROIT — General Motors is adding 1,200 jobs at two Michigan factories to build midsize SUVs and two new luxury sedans. GM said Friday that its Lansing Delta Township plant will get a third shift and 800 more workers to build the Chevrolet Traverse and Buick Enclave SUVs, which have three rows of seats. The Lansing Grand River plant will get a second shift and 400 more workers to build two new Cadillac sedans, the CT4 and CT5. Employees laid off at other GM factories will fill the new jobs first, then workers will be added, GM spokesman Dan Flores said. The company has not determined yet how many new people will be needed, he said. Both additional shifts will start working sometime between April and June, the company said. Lansing Delta Township now employs about 2,500 salaried and blue-collar workers, while the Grand River plant has 1,400. GM sold more than 147,000 Traverse SUVs in the U.S. last year, a 0.4% increase from 2018. Enclave sales were up 3% to just over 51,000, according to Autodata Corp. Related Video:

Next-gen Chevy Silverado and GMC Sierra may use carbon fiber

It's been generally accepted that the next generation of full-size GM trucks will use some sort of strong, lightweight material for the beds while retaining steel for the cab. While aluminum seems like the most obvious choice, according to Automotive News, the Chevy Silverado and GMC Sierra will incorporate both aluminum and carbon fiber in their beds. The publication cites sources from within GM, though it seems the introduction of this comparatively exotic material mix is still a few years off. While carbon fiber is both stronger and lighter than steel and aluminum, it takes significantly more time and money to produce, essentially relegating the material to small-volume cars. The main benefit for trucks is the resulting reduction in weight to improve fuel economy without sacrificing the tough, rugged capabilities truck buyers expect. The Ford F-150 made the switch to aluminum for the 2015 model year and it's proved highly successful. It seemed like it was only a matter of time before the competition followed suit. Automotive News says that the next-gen trucks will launch with aluminum beds and that it will take a couple of years before we'll see any carbon fiber incorporated into the design. Even then, only look for the composite material on higher-trim models, with a trickle down to lower-spec trucks possible further in the future. In 2011, GM announced it was working with Japan-based Teijin Limited on a carbon fiber reinforced thermoplastic. There's a good chance that material's introduction will be on trucks. Related Video: News Source: Automotive News Plants/Manufacturing Rumormill Chevrolet GM GMC Truck