08 Tahoe Z71 Leather 74k Miles Black On Black Priced To Sell on 2040-cars

Auto blog

Junkyard Gem: 2005 Chevrolet Aveo LS Sedan

The story of Daewoo in North America took some interesting plot turns over the decades. First we had the 1988-1993 Pontiac LeMans, a rebadged Daewoo LeMans. A bit later, Daewoo began selling cars under its own nameplate here, with the Lanos, Nubira, and Leganza available for the 1999-2002 model years. Then Daewoo fled the continent and left warranty service of those cars in the hands of Manny, Moe, and Jack. With GM taking over Daewoo Motors after Daewoo's bankruptcy, we got some Daewoos with Suzuki badges here— the Verona and the Reno— while Chevrolet began selling the South Korean-built Daewoo Kalos as the Aveo for the 2004 model year. This car may not be a gem in the sense that you would want to own one, but it's a gem of automotive history and thus deserves its place in this series (especially because it's one of the rare 5-speed cars sold here). Many (maybe even most) of these cars ended up in the hands of rental-car companies and other fleet users, but we can tell from the three-pedal setup that this car went to a non-fleet buyer. We've had a couple of these cars compete in the 24 Hours of Lemons, where I work as a dignified and respected race official, and they've been amazingly quick on a road course in the hands of good drivers. Power came from this 103-horsepower Opel-designed four displacing 1.6 liters. The Nubira and Lanos got versions of this engine on these shores, too. The LS was the top trim level for the Aveo in 2004, so this car got air conditioning and a halfway decent audio system (by 2004 standards). The seat fabric is industrial-grade stuff, which would have held up well under the steady drip and/or torrents of bodily fluids coating the interiors of rental cars. The 2004 Aveo LS started at $12,045, which comes to about $16,675 in 2020 dollars, so it was a lot of commuter-appliance for the price. The following generation of this car became the Chevrolet Sonic, beginning with the 2012 model year. You can still buy a new Sonic, and the inflation-adjusted price is nearly identical to that of the original AveoÂ… though you might want to move fast if you really want one, because Daewoo stopped selling the Kalos in South Korea not long ago. If you want the rarest member of the Aveo family available in North America, find yourself a hen's-teeth Pontiac G3, the short-lived Pontiac-badged version. Speaking of the G3, here's the way it broke the hearts of gas pumps around the world.

Driving Granatelli's turbine-powered 1978 Chevy Corvette [w/video]

With its curvy snout and feminine haunches, the third-gen Chevrolet Corvette looks like a dreamy – if dated – exemplar of Sports Car Fantasy 101 when viewed through modern eyes. This particular specimen circa '78, clad in silver and black paint with red pinstripes, appears to be a well-preserved example from the era. Apart from its low-profile Pirellis, slightly raised and slotted hood, spacious stance and a certain hand-painted descriptor alongside its crossed flag logos, you'd never guess there's a Space-Age propulsion unit powering this Coke bottle-bodied ride. Climb inside, and you're presented with aircraft gauges and big, colorful square buttons in the center panel. It takes a push of the "Ignitor" button, a tap of the starter button, and a slide of a T-handle for this nearly 40-year-old sports car to start sounding like Gulfstream G650 ready for takeoff. Yep, you're sitting in an 880-horsepower, turbine-powered Corvette, the only one of its kind in the world. Welcome to the whoosh. What The...? Built by Vince Granatelli, son of Indy 500 guru Andy Granatelli, this curious Corvette came into being by cramming a Pratt & Whitney ST6N-74 gas turbine engine into the donor car's lengthy front end. The same type of Jet A-burning mill powered Granatelli Senior's STP-sponsored racecar at the 1967 Indianapolis 500, where it famously led most of the 198 of 200 laps until a $6 transmission bearing failed, knocking it out of the race. The idea of turbine power usurping internal combustion was so threatening that Indy's governing body restricted turbine performance into obsolescence thereafter. A turbine-powered Corvette sounds excessive because it is. But there are also things about this 880-horsepower, 1,161-pound-feet monster that might surprise you. While it smacks of futurist exoticism and cost a then-dizzying $37,000 in 1967, the Canadian-built powerplant uses 80 percent fewer parts than an internal combustion V8 and will run on virtually anything combustible – whiskey, diesel, even Chanel No. 5. Though it's triple the length of a V8, the Pratt & Whitney beast weighs only 285 pounds. It's also one hell of a robust workhorse, typically serving as an auxiliary power unit for commercial aircraft or a generator in oil fields, where it can run for tens of thousands of consecutive hours before needing an overhaul. To adapt the Chevrolet for jet duty, the nose section was gutted and a sub-frame was built to compensate for the loosey-goosey front end.

Chevy to resume engine-building program for 2015 Corvette Z06

One of Chevrolet's most popular and unique customer features is set to return for 2015, as the company has announced that the Engine Build Experience is back. Interested owners will be able to screw together their engines beginning in March. The $5,000 option (which does not include the cost of travel) will give future owners of the 2015 Corvette Z06 the chance to screw together their car's actual 6.2-liter, supercharged V8. Available on each of the Z06's three trims, the Engine Build Experience includes a day at the Performance Build Center, instruction from an engine assembly tech, photographs of the experience and a personalized engine plaque. Once the build process is completed, the engine will (eventually) be fitted under the hood of the customer's personal Z06. "Chevrolet recognizes the passion customers have for Corvette and the Engine Build Experience offers them a truly unique opportunity for hands-on involvement in the creation of the heart of their new car," Corvette product manager Harlan Charles. "It's important for customers to understand their engine won't be installed the day after they built it. It will flow into the scheduling process for vehicle assembly, which depends on a number of logistical variables." Scroll down for the official announcement of the Z06's Engine Build Experience, available below. Exclusive Corvette Engine Build Experience Returns Program renewed for supercharged LT4 engine at new Bowling Green build center 2015-01-07 BOWLING GREEN, Ky. – Chevrolet announced today it is resuming the exclusive Engine Build Experience for Corvette Z06 customers – the only program of its kind for supercar customers. Starting in March 2015, Corvette Z06 customers will be able to assemble the 650-hp supercharged LT4 engine for their cars at the new Performance Build Center inside the Bowling Green Assembly Plant. "Chevrolet recognizes the passion customers have for Corvette and the Engine Build Experience offers them a truly unique opportunity for hands-on involvement in the creation of the heart of their new car," said Harlan Charles, Corvette product manager. "It's a chance to bond with their new car." The Engine Build Experience is selected with order code PBC and is offered on all Z06 trim levels.