2004 Chevrolet Suburban 1500 Lt Sport Utility 4-door 5.3l on 2040-cars

Auto blog

GM executive chief EV engineer says reducing cost of plug-in vehicles is 'huge priority'

As we know, another major automaker investing heavily in electrified vehicles is General Motors, and it's doing things much differently than rivals BMW, Ford or Nissan. The Chevrolet Volt extended-range EV is a modest seller at its $35,000 sticker price but a huge hit with owners. The Chevy Spark BEV, still in limited availability, puts smiley faces on its owners and drivers. The just-introduced Cadillac ELR, a sharp-looking, fun-driving $76,000 luxocoupe take on the Volt's EREV mechanicals, has admittedly low sales expectations. With this interesting trio in showrooms and much more in the works, the third vehicle electrification leader I collared for an interview at Detroit's North American International Auto Show (see #1 and #2) was Pam Fletcher, GM's executive chief engineer, Electrified Vehicles. ABG: Why do your EREVs need four-cylinder power to extend their range when BMW's i3 makes do with an optional 650 cc two-banger? "We designed [the Volt and the ELR] to go anywhere, any time" - Pam Fletcher PF: I get that question all the time: why not something smaller? You don't really need that much. You use the electric to its ability, then you just need to limp. But we designed those cars to go anywhere, any time, and we don't want their performance to be compromised. If you're driving through the mountains, we don't want you to be crawling up grades, or to be limited on any terrain. So it's optimized to be able to travel literally the biggest grades and mountain roads around the globe at posted speeds. Because what if you can't? Another good reason: when the engine is on, you have to run it wide open throttle, max speed, most of the time. And while we can do a lot with acoustics, and the ELR has active noise cancelation, a small-displacement, low cylinder-count engine at high speed, high load all the time isn't something you want to live with. That's how we came up with the balance we did among the key factors of performance, NVH [noise, vibration and harshness] and range. ABG: Where you go from here? Is the range-extender engine due for an update? PF: We know and love the current Volt, and there is still a lot of acclaim about it, so we think it's a good recipe. But we are heavily in the midst of engineering the next-generation car, which I think everyone will love and be excited about.

Want a V8 on the cheap? Buy a work truck

In case you didn't notice, V8 cars have gotten pretty expensive. If you want a modern muscle car like the Dodge Challenger R/T, Ford Mustang GT, or Chevy Camaro SS, you'll need between $34,000 and $38,000 for a stripped out example of one. The cheapest of those is the Challenger, and the priciest is the Camaro. These are also the cheapest V8 cars the companies offer. But if you absolutely have to have a V8 for less, there is an option, work trucks. As it turns out, all of the Big Three offer their most basic work trucks with V8s. And because they're so basic, they're pretty affordable, especially when sticking with the standard two-wheel drive. A Ram 1500 Tradesman with a V8 can be had for as little as $29,840, which is a little more than $4,000 less than a Challenger R/T. For a bit more at $30,275, you can have a Chevy Silverado W/T, almost $8,000 less than a Camaro SS. The most expensive is the V8 Ford F-150 starts at a starting price of $30,670, which is a bit over $5,000 less than the Mustang. Of course you'll be in an ultra bare bones vehicle with few comforts, and the price will go up if you add stuff, but we're bargain hunting here, and sacrifices are sometimes necessary. Besides, what you lose in comfort, you gain in loads of cargo space and towing (try to look at the bright side). Also, as a side note, all three trucks are available with optional electronic locking rear differentials. At the discounted price of these trucks, you still get a heaping helping of power. The most potent of the trio is the Ram 1500 Tradesman with 395 horsepower and 410 pound-feet of torque generated by a 5.7-liter V8. Compared with the Challenger R/T, the Ram is up by 20 horsepower and they're tied for torque. The value proposition is even more stark between the two vehicles when looking at the price per horsepower. Each pony in the Ram costs $75.54, while the Challenger charges you $90.91. The Challenger is also more expensive per horsepower than its close competitors. The F-150's 5.0-liter V8 is just barely behind the Ram with 395 horsepower and 400 pound-feet of torque. That's still more power than the Challenger, and it matches the torque of the 2017 Mustang GT. On the down side, it still would be down 20 horsepower on that same 2017 Mustang, and it's behind by 60 horsepower and 20 pound-feet on the new 2018 Mustang GT. The F-150 also just edges out the Mustang in the dollar per horsepower measure.

2016 Chevy Equinox brings its revised face to Chicago

It's vital these days for automakers to keep up with the Jones' when in the crossover market. The segment is just too popular among buyers to let a vehicle waste away, and Chevrolet is giving the 2016 Equinox a slight refresh at the Chicago Auto Show to hopefully keep people interested. In reality, though, the CUV isn't too much different beyond a tweaked face and some interior improvements. The exterior now boasts a revised front fascia with a chrome-accented grille and projector beam headlights, and at the rear there are new taillights. Top -evel models get LED running lights, as well. Inside, the Equinox features a standard seven-inch touchscreen infotainment system with a backup cam, and for added safety, the CUV is now available with rear cross traffic and blade zone alert on some trims. Beyond these updates, the powertrains carry over entirely from before with the choice between a 2.4-liter four-cylinder and a 3.6-liter V6. These refreshed 2016 models go on sale this fall. Related Video: