2002 Chevy Silverado 2500hd Crew Cab Flat Bed 4wd Diesel Leather Seats Grill Tx on 2040-cars

Auto blog

Driving Granatelli's turbine-powered 1978 Chevy Corvette [w/video]

With its curvy snout and feminine haunches, the third-gen Chevrolet Corvette looks like a dreamy – if dated – exemplar of Sports Car Fantasy 101 when viewed through modern eyes. This particular specimen circa '78, clad in silver and black paint with red pinstripes, appears to be a well-preserved example from the era. Apart from its low-profile Pirellis, slightly raised and slotted hood, spacious stance and a certain hand-painted descriptor alongside its crossed flag logos, you'd never guess there's a Space-Age propulsion unit powering this Coke bottle-bodied ride. Climb inside, and you're presented with aircraft gauges and big, colorful square buttons in the center panel. It takes a push of the "Ignitor" button, a tap of the starter button, and a slide of a T-handle for this nearly 40-year-old sports car to start sounding like Gulfstream G650 ready for takeoff. Yep, you're sitting in an 880-horsepower, turbine-powered Corvette, the only one of its kind in the world. Welcome to the whoosh. What The...? Built by Vince Granatelli, son of Indy 500 guru Andy Granatelli, this curious Corvette came into being by cramming a Pratt & Whitney ST6N-74 gas turbine engine into the donor car's lengthy front end. The same type of Jet A-burning mill powered Granatelli Senior's STP-sponsored racecar at the 1967 Indianapolis 500, where it famously led most of the 198 of 200 laps until a $6 transmission bearing failed, knocking it out of the race. The idea of turbine power usurping internal combustion was so threatening that Indy's governing body restricted turbine performance into obsolescence thereafter. A turbine-powered Corvette sounds excessive because it is. But there are also things about this 880-horsepower, 1,161-pound-feet monster that might surprise you. While it smacks of futurist exoticism and cost a then-dizzying $37,000 in 1967, the Canadian-built powerplant uses 80 percent fewer parts than an internal combustion V8 and will run on virtually anything combustible – whiskey, diesel, even Chanel No. 5. Though it's triple the length of a V8, the Pratt & Whitney beast weighs only 285 pounds. It's also one hell of a robust workhorse, typically serving as an auxiliary power unit for commercial aircraft or a generator in oil fields, where it can run for tens of thousands of consecutive hours before needing an overhaul. To adapt the Chevrolet for jet duty, the nose section was gutted and a sub-frame was built to compensate for the loosey-goosey front end.

Amelia Island 2013: Chevrolet Corvette Sting Ray from concepts to split windows

While this year marks 60 years of the Chevrolet Corvette, the 2013 Amelia Island Concours d'Elegance focused on one of the coupe's most sought after models, the 1963 Sting Ray. General Motors design boss Ed Welburn was on hand to show off the all-new C7 Corvette, but even the hard-edged styling of the 2014 Stingray couldn't take away from the beautiful 1963 models sitting out on the field.
In addition to the original Sting Ray and the 1959 Sting Ray Concept, some of the other classic 'Vettes included "Big Tank" racecars, an interesting cutaway coupe, a right-hand-drive Z06 and the attention-grabbing 1963 Corvette Rondine by Pininfarina. Another impressive Corvette was the 1964 Corvette XP-819 rear-engine prototype. Owner Mike Yager had the car finished as a driving chassis for this year's show, but promises the car will be back to its original glory in time for next year's event.

Chevy reveals new IndyCar aero package

The IndyCar Series is not one that demands its participating teams and automakers to design their own chassis as they do in Formula One, but for this season, the organizers have opened it up to allow for custom aero packages. What you're looking at here is the new look of the chassis to be fielded by teams running under Chevy power. Based on the Dallara DW12 chassis – introduced three years ago and named after the late Dan Wheldon – Chevy's new package is designed for road courses and short ovals, with the speedway configuration to be revealed later. The kit features new wings front and rear and more sculpted side pods. It's also got new wedges at the back to envelop the otherwise open wheels that are a hallmark of Indy racing, a more streamlined engine cover and bigger rear bumper pods. The new package will debut at the Grand Prix of St. Petersburg that will kick off this year's championship in Florida on March 29, followed by the road-course grands prix in Louisiana, Long Beach, Alabama and Indianapolis before the new package needs to be ready for the Indy 500 late in May. Half of the teams on the starting grid this season will be running under Chevy power and are expected to use this new aero kit, with the remaining Honda teams slated to run a different package of their own. Chevrolet Debuts All-New 2015 IndyCar Aero Package Chevy-developed bodywork delivers improved aerodynamics 2015-02-17 INDIANAPOLIS – Chevrolet-powered racecars in the 2015 Verizon IndyCar Series will feature Chevrolet-developed aero packages. Chevrolet introduced the road course/short oval body design today at the Indianapolis Motor Speedway. It is distinguished from the previous racecar with new front wing elements, sculpted side pods and a new rear wing. A speedway configuration for the aero kit, designed for high-speed ovals, will be introduced ahead of its competitive debut at Indianapolis in May. "This is an important milestone in Chevrolet's involvement in IndyCar racing," said Jim Campbell, General Motors U.S. vice president of Performance Vehicles and Motorsports. "We focused on developing an aerodynamic package that delivers an balanced combination of downforce and drag, along with integrated engine performance. It's a total performance package." The new Chevy road course aero configuration delivers greater aerodynamic performance than the previous design.