'96 Chevy Silverado 1500 on 2040-cars

Auto blog

Driving Granatelli's turbine-powered 1978 Chevy Corvette [w/video]

With its curvy snout and feminine haunches, the third-gen Chevrolet Corvette looks like a dreamy – if dated – exemplar of Sports Car Fantasy 101 when viewed through modern eyes. This particular specimen circa '78, clad in silver and black paint with red pinstripes, appears to be a well-preserved example from the era. Apart from its low-profile Pirellis, slightly raised and slotted hood, spacious stance and a certain hand-painted descriptor alongside its crossed flag logos, you'd never guess there's a Space-Age propulsion unit powering this Coke bottle-bodied ride. Climb inside, and you're presented with aircraft gauges and big, colorful square buttons in the center panel. It takes a push of the "Ignitor" button, a tap of the starter button, and a slide of a T-handle for this nearly 40-year-old sports car to start sounding like Gulfstream G650 ready for takeoff. Yep, you're sitting in an 880-horsepower, turbine-powered Corvette, the only one of its kind in the world. Welcome to the whoosh. What The...? Built by Vince Granatelli, son of Indy 500 guru Andy Granatelli, this curious Corvette came into being by cramming a Pratt & Whitney ST6N-74 gas turbine engine into the donor car's lengthy front end. The same type of Jet A-burning mill powered Granatelli Senior's STP-sponsored racecar at the 1967 Indianapolis 500, where it famously led most of the 198 of 200 laps until a $6 transmission bearing failed, knocking it out of the race. The idea of turbine power usurping internal combustion was so threatening that Indy's governing body restricted turbine performance into obsolescence thereafter. A turbine-powered Corvette sounds excessive because it is. But there are also things about this 880-horsepower, 1,161-pound-feet monster that might surprise you. While it smacks of futurist exoticism and cost a then-dizzying $37,000 in 1967, the Canadian-built powerplant uses 80 percent fewer parts than an internal combustion V8 and will run on virtually anything combustible – whiskey, diesel, even Chanel No. 5. Though it's triple the length of a V8, the Pratt & Whitney beast weighs only 285 pounds. It's also one hell of a robust workhorse, typically serving as an auxiliary power unit for commercial aircraft or a generator in oil fields, where it can run for tens of thousands of consecutive hours before needing an overhaul. To adapt the Chevrolet for jet duty, the nose section was gutted and a sub-frame was built to compensate for the loosey-goosey front end.

All of the Bond cars of 'No Time To Die' (caution for spoilers)

Note: The following overview of the cars in No Time To Die contains spoilers. Read at your own risk, or come back after seeing the film to make sure you caught everything.   No Time To Die picks up right around where Spectre leaves us. James Bond (Daniel Craig) and Madeleine Swann (Lea Seydoux) are driving along in Bond’s restored and iconic DB5 in Matera, Italy. Things donÂ’t stay all that cheery for long in picturesque Matera, though. As is tradition in Bond films, the first car chase hits us with an explosion of action in what's a super-long opening scene. Fourth-gen Maserati Quattroporte: The baddies in the beginning are driving a Maserati and chasing after Bond in the DB5. Specifically, theyÂ’re in a fourth-gen Quattroporte, which feels right for a chase scene in Italy. Its squared-off looks are mean enough, and its Italian growl is a good background soundtrack to the DB5Â’s inline-six. In addition to the Quattroporte, the chase scene in Matera is home to a couple of the best stunts of the entire movie, including the arch jump done with a Triumph motorcycle seen in trailers — Matera is extremely hilly. Eventually, Bond and Swann find themselves in the DB5 again together, which is where the famous gatling gun scene from the trailer commences, but not before the bulletproof windows and body of the DB5 are thoroughly tested. RIP to the first-gen Range Rover Classics and Jaguar XFs that joined the Maserati in pursuit of Bond (here's a list of other Bond cars over the years). As the DB5 escape scene concludes, we catch a glimpse of what appears to be a Ferrari from the 1970s. However, the view was far enough away that weÂ’ll need a second look to be sure of the exact model. Land Rover Series III: Next time we see Bond, heÂ’s fishing in Jamaica and driving around a blue Land Rover Series III. ItÂ’s yet another of the many Land Rover products featured throughout the film, and unlike most of BondÂ’s Aston Martins, this one doesnÂ’t seem to have any unique features. The other intriguing vehicle out of Jamaica? An old Chevrolet Bel-Air expertly and effectively piloted by Bond newcomer, Ana de Armas. Next up, we get a few shots of the new and still-not-for-sale Aston Martin Valhalla mid-engine supercar (also seen in trailers). BondÂ’s old boss M is in the scene which appears to have been shot in some secret wind tunnel of sorts. Much to our dismay, nobody ends up driving the Valhalla in the film. Could it be a teaser for what the next 007Â’s car is?

Mark Reuss: GM can't afford product 'misses,' has 'thought about' CT6 V-Series

Mark Reuss is a busy man. He oversees General Motors' global product portfolio, an all-encompassing task for a company that sold more than 9.9 million cars and trucks last year. When GM launches a well-received product, like the road-going rocket ship that is the Chevrolet Corvette Z06 – he gets credit. When the company stumbles with the slow-selling Chevy Malibu or grapples with fallout from the decade-old Saturn Ion and its flawed ignition switch, he gets blamed. GM owners, the press and sometimes the federal government, demand answers. Bob Lutz famously held the job before Reuss. So did Mary Barra, who's now GM's chief executive. There's a New GM, but the lineage is connected to a long history. When he's not thinking product, Reuss, an executive vice president, also runs the purchasing and supply chain for the company, which is still one of the largest industrial empires in the world. We caught up with Reuss on the floor of the New York Auto Show, where GM had just rolled out two crucial new products: the 2016 Cadillac CT6 and the 2016 Chevrolet Malibu. Speaking with a small group of reporters, Reuss delved into a variety of subjects, including the new Malibu, Cadillac's future (he thinks the ATS-V is going to "flame the M3 and M4"), and other topics. On fixing the Malibu: "We can't miss. We can't have those kinds of misses [like the previous generation] on our cars and crossovers and trucks. We can't do that. If we do that, we give a reason for someone to go buy something else. It's that simple. "On a car like the Malibu we have a chance to really fix all of that, which we have, and then lead. Then you've got a real opportunity there. So that's what we've really been focused on here – to fix those things." He later added: "We need that car here to transform Chevrolet desperately because it's the heart of the market. And when you think of Chevrolet, people will come back and think about what we did with the [new] Malibu and the Cruze... It's hugely important to us." On Cadillac: "If we go out and try and out-German the Germans, it's probably not going to work. We've got an opportunity here generationally where there's a lot of people younger than me that have parents that drove BMWs and Mercedes, and I think there's an opportunity there for those people to drive something different than what their parents did, and I think that's always been an opportunity in the auto industry if you look at the history of it.