2006 Chevy Ssr Pu Truck Convertible Low Miles! on 2040-cars

Auto blog

Submit your questions for Autoblog Podcast #313 LIVE!

We record Autoblog Podcast #313 tonight, and you can drop us your questions and comments regarding the rest of the week's news via our Q&A module below. Subscribe to the Autoblog Podcast in iTunes if you haven't already done so, and if you want to take it all in live, tune in to our UStream (audio only) channel at 10:00 PM Eastern tonight.
Discussion Topics for Autoblog Podcast Episode #313
2014 Chevrolet Silverado and GMC Sierra introduced

Next-gen Chevy Silverado and GMC Sierra may use carbon fiber

It's been generally accepted that the next generation of full-size GM trucks will use some sort of strong, lightweight material for the beds while retaining steel for the cab. While aluminum seems like the most obvious choice, according to Automotive News, the Chevy Silverado and GMC Sierra will incorporate both aluminum and carbon fiber in their beds. The publication cites sources from within GM, though it seems the introduction of this comparatively exotic material mix is still a few years off. While carbon fiber is both stronger and lighter than steel and aluminum, it takes significantly more time and money to produce, essentially relegating the material to small-volume cars. The main benefit for trucks is the resulting reduction in weight to improve fuel economy without sacrificing the tough, rugged capabilities truck buyers expect. The Ford F-150 made the switch to aluminum for the 2015 model year and it's proved highly successful. It seemed like it was only a matter of time before the competition followed suit. Automotive News says that the next-gen trucks will launch with aluminum beds and that it will take a couple of years before we'll see any carbon fiber incorporated into the design. Even then, only look for the composite material on higher-trim models, with a trickle down to lower-spec trucks possible further in the future. In 2011, GM announced it was working with Japan-based Teijin Limited on a carbon fiber reinforced thermoplastic. There's a good chance that material's introduction will be on trucks. Related Video: News Source: Automotive News Plants/Manufacturing Rumormill Chevrolet GM GMC Truck

AMC Trans Am Javelin SST, an ultra-rare underdog, is up for auction

Among the rarest of the American muscle cars that went racing in the early Seventies — cars including the Camaro Z/28 and the Boss 302 Mustang — the 1970 AMC Trans Am Javelin SST may be the most hard to find, and among the most valuable. Only 100 units of this unique Javelin were produced, and one of them is up for auction at the Mecum event in Dallas on September 20. The Trans Am Javelin was fashioned in a patriotic livery of tricolor paint — red, white and blue — and arrived after the American Motors Corporation had decided in 1968 to compete in the Trans Am racing series against Ford and General Motors. The company's chief driver, Mark Donohue, would dominate the 1971 season, taking seven wins in his Javelin AMX and that yearÂ’s SCCA Trans-Am Championship. AMC took the trophy with 82 points, well ahead of Ford's 61, Chevrolet's 17 and Pontiac's paltry 7. The example listed for auction came equipped with a 390-cubic-inch V-8 engine with 325 horsepower at 5,000 rpm and 420 pound-feet of torque, power steering and brakes, dual exhaust, BorgWarner four-speed manual transmission and Hurst competition shifter. Its “ram induction system” sealed a chamber around the air filter so that cool air from the functional hood scoop would be funneled into the intake. This JavÂ’s factory price was $3,995 — a mere $32,000 or so in today's money, though it was expensive by the standards of the time. The 100 Trans Ams were among 19,714 Javelin units built in 1970, so they started out rare, and today the surviving examples are highly collectible, if and when they come up for sale. No bid estimate is available yet. Related Video: Motorsports Chevrolet Ford Pontiac Auctions Automotive History Racing Vehicles Classics