1963 Nova Ss on 2040-cars

Auto blog

GM 6.2L V8 claims most powerful light-duty truck engine title

General Motors has officially captured the horsepower crown for mainstream pickup trucks with its 6.2-liter V8. The big mill, available in both the Chevrolet Silverado and GMC Sierra, comes to market with 420 horsepower and 460 pound-feet of torque, handily outdoing its two cross-town competitors, Ram (5.7-liter V8, 395 ponies and 407 lb-ft) and Ford (6.2-liter V8, 411 hp and 434 lb-ft).
The new GM 6.2 will take a bit of an investment, though. Those that want the extra thrust will need to go with either the LTZ or High Country trims from the Chevy, or the SLT and Denali trims from GMC, which are the two highest trim levels for the respective vehicles. Trim levels aside, if you're in the business of towing, GM has you covered. Optioned with the 6.2-liter V8 and the Max Trailering Package, owners will be able to pull 12,000 pounds, a hugely impressive figure.
We still aren't certain as to what sort of economy the new engine will get, but it'll probably be a bad bet for the fuel conscious. As for availability, expect to see the 6.2-liter trucks in showrooms later in the fall.

Camaro spy shots show subtly different grille, front fascia

It looks like there some changes in store for the Chevrolet Camaro - the only thing is that we just don't know what Chevy has up its sleeve. Looking at these spy shots, we'd initially be inclined to think that there is just a minor facelift or a new special edition, but upon closer inspection, there are a few oddities about this car that definitely have us intrigued.
The most obvious difference on this prototype is the slightly restyled front fascia with a smaller lower air inlet and the two-bar grille. Then we get to some of the car's mysterious details. For starters, this fascia has the SS vent above the grille, but it looks to be blocked off. Granted this could just be a one-off piece used for testing. What really piqued our interest was at the rear of the car where it has quad exhaust outlets that are used on the ZL1. Could this be the LS7-powered Camaro that we reported on back in December?
At this point, your guess is as good as ours as to what we're looking at here, so let us know in the comments what you think this could be.

Next-gen Chevy Silverado and GMC Sierra may use carbon fiber

It's been generally accepted that the next generation of full-size GM trucks will use some sort of strong, lightweight material for the beds while retaining steel for the cab. While aluminum seems like the most obvious choice, according to Automotive News, the Chevy Silverado and GMC Sierra will incorporate both aluminum and carbon fiber in their beds. The publication cites sources from within GM, though it seems the introduction of this comparatively exotic material mix is still a few years off. While carbon fiber is both stronger and lighter than steel and aluminum, it takes significantly more time and money to produce, essentially relegating the material to small-volume cars. The main benefit for trucks is the resulting reduction in weight to improve fuel economy without sacrificing the tough, rugged capabilities truck buyers expect. The Ford F-150 made the switch to aluminum for the 2015 model year and it's proved highly successful. It seemed like it was only a matter of time before the competition followed suit. Automotive News says that the next-gen trucks will launch with aluminum beds and that it will take a couple of years before we'll see any carbon fiber incorporated into the design. Even then, only look for the composite material on higher-trim models, with a trickle down to lower-spec trucks possible further in the future. In 2011, GM announced it was working with Japan-based Teijin Limited on a carbon fiber reinforced thermoplastic. There's a good chance that material's introduction will be on trucks. Related Video: News Source: Automotive News Plants/Manufacturing Rumormill Chevrolet GM GMC Truck