1963 Chevrolet Nova 4 Door Sedan Starts And Runs Great Condition on 2040-cars

Auto blog

Driving Granatelli's turbine-powered 1978 Chevy Corvette [w/video]

With its curvy snout and feminine haunches, the third-gen Chevrolet Corvette looks like a dreamy – if dated – exemplar of Sports Car Fantasy 101 when viewed through modern eyes. This particular specimen circa '78, clad in silver and black paint with red pinstripes, appears to be a well-preserved example from the era. Apart from its low-profile Pirellis, slightly raised and slotted hood, spacious stance and a certain hand-painted descriptor alongside its crossed flag logos, you'd never guess there's a Space-Age propulsion unit powering this Coke bottle-bodied ride. Climb inside, and you're presented with aircraft gauges and big, colorful square buttons in the center panel. It takes a push of the "Ignitor" button, a tap of the starter button, and a slide of a T-handle for this nearly 40-year-old sports car to start sounding like Gulfstream G650 ready for takeoff. Yep, you're sitting in an 880-horsepower, turbine-powered Corvette, the only one of its kind in the world. Welcome to the whoosh. What The...? Built by Vince Granatelli, son of Indy 500 guru Andy Granatelli, this curious Corvette came into being by cramming a Pratt & Whitney ST6N-74 gas turbine engine into the donor car's lengthy front end. The same type of Jet A-burning mill powered Granatelli Senior's STP-sponsored racecar at the 1967 Indianapolis 500, where it famously led most of the 198 of 200 laps until a $6 transmission bearing failed, knocking it out of the race. The idea of turbine power usurping internal combustion was so threatening that Indy's governing body restricted turbine performance into obsolescence thereafter. A turbine-powered Corvette sounds excessive because it is. But there are also things about this 880-horsepower, 1,161-pound-feet monster that might surprise you. While it smacks of futurist exoticism and cost a then-dizzying $37,000 in 1967, the Canadian-built powerplant uses 80 percent fewer parts than an internal combustion V8 and will run on virtually anything combustible – whiskey, diesel, even Chanel No. 5. Though it's triple the length of a V8, the Pratt & Whitney beast weighs only 285 pounds. It's also one hell of a robust workhorse, typically serving as an auxiliary power unit for commercial aircraft or a generator in oil fields, where it can run for tens of thousands of consecutive hours before needing an overhaul. To adapt the Chevrolet for jet duty, the nose section was gutted and a sub-frame was built to compensate for the loosey-goosey front end.

Watch this time-lapse build of the Chevy SS for NASCAR

There's only about a week left until we get our first look at the production version of the 2014 Chevrolet SS sedan, but Chevrolet NASCAR teams have been looking at the race version of the car all winter. Autoweek has posted a really neat time-lapse video showing just a portion of what it takes to build one of NASCAR's new Gen6 stock cars.
Though the video is quite brief, it does show almost the entire build process starting with just the car's nose, and it gives us a good look at how integral the template is to the final product. As a bonus, Hendrick Motorsports also provided some videos showing two of its teams performing pit stop tests over the winter. The second video shows some of the more detailed aspects of the racecar's rear end, including the stock-looking trunk cutout and a newly mandated rear bumper extension that will be used on super speedways like Daytona and Talladega.
To see what Team Chevy has been up to all off-season, check out all three videos posted after the jump.

This map reveals the cleanest vehicles based on location

Naysayers love to point out how dirty the electricity grid mix is when it comes to charging electric vehicles. Curmudgeons are eager to jump into any conversation about EVs to enlighten the lucky listeners about how plug-in cars contribute to pollution, sometimes even throwing in a dash of climate-change denial for good measure. (Thanks, buddy. Pray, tell me more about the plight of oppressed SUV owners.) Unless someone buys an EV just because they think they're cool (which, yeah, they often are), they probably have at least a passable understanding of their environmental pros and cons. As many EV owners are already aware, location has a lot to do with any particular plug-in car's carbon footprint. Still, there's always more to know, and knowledge is not a bad thing, especially if one uses it to do the right thing. That's why this handy-dandy map from Carnegie Mellon University is so interesting. CMU researchers have compiled information about the lifecycle greenhouse gas emissions of various EVs based on where they're charged, as compared to gasoline-powered vehicles. The researchers looked at the Nissan Leaf, Chevrolet Volt, and Prius Plug-In Hybrid versus the gasoline-dependent Toyota Prius hybrid and the stop-start-equipped Mazda3 with i-ELOOP and compared grams of CO2 emitted per mile. CMU takes into account the grid mix, ambient temperature, and driving patterns. CMU takes into account the grid mix based on county, as well as ambient temperature and driving patterns in terms of miles traveled on the highway or in the city. For instance, if you drive a Nissan Leaf in urban areas of California, Texas, or Florida, your carbon footprint is lower than it would be if you were driving a standard Toyota Prius. However, if you charge your Leaf in the Midwest or the South, for the most part, you've got a larger carbon footprint than the Prius. If you live in the rural Midwest, you'd probably even be better off driving a Mazda3. Throughout the country, the Chevrolet Volt has a larger carbon footprint than the Toyota Prius, but a smaller one than the Mazda3 in a lot of urban counties in the US. The Prius and Prius Plug-In are relatively equal across the US. Having trouble keeping it straight? That's not surprising. The comparisons between plug-in and gasoline vehicles are much more nuanced than the loudest voices usually let on.