Find or Sell Used Cars, Trucks, and SUVs in USA

4dr Sdn Ls W/1ls New Sedan Automatic Gasoline 2.5l L4 Dir Dohc 16v Black Granite on 2040-cars

Year:2014 Mileage:0 Color: Black Granite Metallic
Location:

Jimmie Johnson's Kearny Mesa Chevrolet, 7978 Balboa Avenue, San Diego, CA 92111

Jimmie Johnson's Kearny Mesa Chevrolet, 7978 Balboa Avenue, San Diego, CA 92111
Advertising:

Auto blog

Diesel details: Comparing Ram 1500 EcoDiesel, Chevy Silverado Duramax, Ford F-150 Powerstroke

Thu, Jun 13 2019

With specifications for the 2019 Ford F-150 Power Stroke diesel already out, and the details on the 2020 Ram 1500 EcoDiesel and Chevy Silverado Duramax (and its GMC Sierra twin) trickling out, we felt it was a good time to start comparing the full-size trucks' light-duty diesels. Bear in mind, we've only driven one of these new diesel trucks, so we'll be sticking to numbers for now. Some numbers haven't been announced yet, either, but stay tuned, because we'll be updating this post with additional specifications as they become available. And if you want to compare any other versions of these trucks with other vehicles, be sure to check out our comparison tool. Now let's start comparing, starting with our big chart of numbers below. As we can plainly see, these trucks are quite closely matched. Each one has six cylinders, a displacement of 3.0 liters and a turbocharger to boost it. The output of each is somewhat close, too. The Ram 1500 EcoDiesel is the torque king at 480 pound-feet, 20 more than the GM trucks and 40 more than the Ford. The GM trucks win on power, though, with 277 ponies, 17 more than the Ram, and 27 more than the Ford. GM does report that you get their trucks' peak 460 pound-feet of torque from 1,500 rpm to 3,000 rpm, whereas the others only report peak torque at a particular point in the rev band, but all of these trucks should have wide, flat torque curves as you would expect from modern turbodiesels. 2020 Ram 1500 EcoDiesel View 8 Photos Engine output is only one part of the truck performance equation. We also have towing and payload capacity, as well as fuel economy. With towing, the Ram 1500 is the current leader with a maximum capacity of 12,560 pounds. That tops the Ford F-150's 11,400-pound tow rating by well over 1,000 pounds. The F-150 can carry 2,020 pounds in its bed, but we don't know yet whether that's better or worse than the Ram or the GM trucks. We also don't have numbers for the GM trucks' towing capacities. View 9 Photos As for fuel economy, the Ford F-150 manages a thoroughly impressive 22 mpg in the city and 30 on the highway with two-wheel drive. Choosing four-wheel drive drops those numbers to 20 and 25 respectively. The fuel economy numbers for the Ram, Chevy and GMC haven't been revealed yet, but for some comparison, we can look at the old Ram EcoDiesel. That truck's best fuel economy was 20 in the city and 27 on the highway with two-wheel drive.

Driving Granatelli's turbine-powered 1978 Chevy Corvette [w/video]

Thu, Jan 8 2015

With its curvy snout and feminine haunches, the third-gen Chevrolet Corvette looks like a dreamy – if dated – exemplar of Sports Car Fantasy 101 when viewed through modern eyes. This particular specimen circa '78, clad in silver and black paint with red pinstripes, appears to be a well-preserved example from the era. Apart from its low-profile Pirellis, slightly raised and slotted hood, spacious stance and a certain hand-painted descriptor alongside its crossed flag logos, you'd never guess there's a Space-Age propulsion unit powering this Coke bottle-bodied ride. Climb inside, and you're presented with aircraft gauges and big, colorful square buttons in the center panel. It takes a push of the "Ignitor" button, a tap of the starter button, and a slide of a T-handle for this nearly 40-year-old sports car to start sounding like Gulfstream G650 ready for takeoff. Yep, you're sitting in an 880-horsepower, turbine-powered Corvette, the only one of its kind in the world. Welcome to the whoosh. What The...? Built by Vince Granatelli, son of Indy 500 guru Andy Granatelli, this curious Corvette came into being by cramming a Pratt & Whitney ST6N-74 gas turbine engine into the donor car's lengthy front end. The same type of Jet A-burning mill powered Granatelli Senior's STP-sponsored racecar at the 1967 Indianapolis 500, where it famously led most of the 198 of 200 laps until a $6 transmission bearing failed, knocking it out of the race. The idea of turbine power usurping internal combustion was so threatening that Indy's governing body restricted turbine performance into obsolescence thereafter. A turbine-powered Corvette sounds excessive because it is. But there are also things about this 880-horsepower, 1,161-pound-feet monster that might surprise you. While it smacks of futurist exoticism and cost a then-dizzying $37,000 in 1967, the Canadian-built powerplant uses 80 percent fewer parts than an internal combustion V8 and will run on virtually anything combustible – whiskey, diesel, even Chanel No. 5. Though it's triple the length of a V8, the Pratt & Whitney beast weighs only 285 pounds. It's also one hell of a robust workhorse, typically serving as an auxiliary power unit for commercial aircraft or a generator in oil fields, where it can run for tens of thousands of consecutive hours before needing an overhaul. To adapt the Chevrolet for jet duty, the nose section was gutted and a sub-frame was built to compensate for the loosey-goosey front end.

Chevy Bolt-based prototype may be a Buick EV for China

Thu, Jan 9 2020

Late last spring, we got a look at a GM prototype that was clearly based on the Chevy Bolt EV, but with updated styling. It seemed like it could be a more crossover-styled Bolt, given the recently trademarked name of EUV. Now we get another look at the prototype, but the bodywork seems less suggestive of a Chevy, and more of a Buick. This vehicle definitely still appears to be based on the Bolt, rather than on another small GM platform. In the photos of it next to the current model, the size, wheelbase and profile are extremely similar. There are differences, though. The nose isn't as sloped or as rounded, and the rear window kicks up a little earlier. The biggest changes are in the front and rear fascias, and it's here that we see hints of Buick. There are prominent air inlets on each side of the front bumper that give the car a more aggressive look. The headlights still have a fairly rounded, organic look, but with little extensions like fangs underneath. The styled running-light section, rounded shape and the smoked lenses seem very Buick-like. The grille features a large badge that doesn't fit the shape of a bow-tie, and is more that of a round logo like Buick's. Around at the back, the full-width taillights stand out, and in the middle there is obviously a round badge, again like a Buick. The wide taillights would also be a natural evolution of Buick's current light design language that uses somewhat wide and thin lights. The rear bumper has been redesigned with new lower taillights. Now that we've established that this seems very much like a Buick, we don't think we'll see this particular version offered here with the badge. This is more likely a Buick version of the Bolt for the Chinese market, where the brand is associated with luxury and has been the spearhead for GM's electric and hybrid models. In fact, the Chevy Volt hybrid was sold there as the Buick Velite 5, which was part of a family of a electrified Velite models. This would probably also carry a Velite badge as well. While we might not see this specific Buick variant, we probably will see it offered as a Chevy in some form. With its more aggressive, crossover shape, it could be the rumored EUV model. Or it could be just a refresh of the current Bolt, since the model has been largely unchanged since its introduction for the 2017 model year. And extrapolating from this prototype, we can see how the headlights could be tweaked to tie into those air scoops as on the Suburban and Silverado.