Heated Leather, Sunroof, Bose Audio, Xm Radio, Bluetooth, Remote Start 12895 on 2040-cars

Auto blog

Chevy Bolt-based prototype may be a Buick EV for China

Late last spring, we got a look at a GM prototype that was clearly based on the Chevy Bolt EV, but with updated styling. It seemed like it could be a more crossover-styled Bolt, given the recently trademarked name of EUV. Now we get another look at the prototype, but the bodywork seems less suggestive of a Chevy, and more of a Buick. This vehicle definitely still appears to be based on the Bolt, rather than on another small GM platform. In the photos of it next to the current model, the size, wheelbase and profile are extremely similar. There are differences, though. The nose isn't as sloped or as rounded, and the rear window kicks up a little earlier. The biggest changes are in the front and rear fascias, and it's here that we see hints of Buick. There are prominent air inlets on each side of the front bumper that give the car a more aggressive look. The headlights still have a fairly rounded, organic look, but with little extensions like fangs underneath. The styled running-light section, rounded shape and the smoked lenses seem very Buick-like. The grille features a large badge that doesn't fit the shape of a bow-tie, and is more that of a round logo like Buick's. Around at the back, the full-width taillights stand out, and in the middle there is obviously a round badge, again like a Buick. The wide taillights would also be a natural evolution of Buick's current light design language that uses somewhat wide and thin lights. The rear bumper has been redesigned with new lower taillights. Now that we've established that this seems very much like a Buick, we don't think we'll see this particular version offered here with the badge. This is more likely a Buick version of the Bolt for the Chinese market, where the brand is associated with luxury and has been the spearhead for GM's electric and hybrid models. In fact, the Chevy Volt hybrid was sold there as the Buick Velite 5, which was part of a family of a electrified Velite models. This would probably also carry a Velite badge as well. While we might not see this specific Buick variant, we probably will see it offered as a Chevy in some form. With its more aggressive, crossover shape, it could be the rumored EUV model. Or it could be just a refresh of the current Bolt, since the model has been largely unchanged since its introduction for the 2017 model year. And extrapolating from this prototype, we can see how the headlights could be tweaked to tie into those air scoops as on the Suburban and Silverado.

GM trucks get hybrid versions, but you'll probably never see one

A few years ago, General Motors sold hybrid versions of its Chevy Silverado and GMC Sierra pickups. They weren't very good, using GM's old two-mode hybrid system that resulted in only negligible fuel economy gains. But GM's trying again, launching eAssist models of the 2016 Silverado and Sierra that are said to offer 2-mpg improvements in city, highway, and combined fuel economy ratings. Problem is, you probably won't be able to get one. Only 700 eAssist trucks will be made for the 2016 model year – 500 Silverados and 200 Sierras. When you consider that GM moved 824,683 examples of its light-duty pickups in 2015, this small run represents 0.08-percent of all Silverado/Sierra production, and GM says it "will monitor the market closely ... and adjust as appropriate moving forward." But that's not the only limitation. The eAssist trucks will only be sold through California dealers. For the Silverado, eAssist can only be optioned on the 1500 Crew Cab 1LT 2WD model, and for the Sierra, the fuel-saving technology is solely available on the 1500 SLT Crew Cab 2WD model with the SLT Premium Plus package. Granted, in terms of the Sierra, that means you get niceties like LED headlights and taillights, Apple CarPlay and Android Auto, Bose premium audio, heated seats and steering wheel, lane keep assist, and more. In the trucks, eAssist combines a small electric motor and 0.45-kWh battery pack with the pickups' 5.3-liter V8. GM estimates total output of 355 horsepower and 383 pound-feet of torque – no more horsepower than the non-eAssist trucks, but three more pound-feet of torque. GM says the eAssist trucks can tow up to 9,400 pounds, and the battery only adds 100 pounds to the trucks' weight. The electric motor provides 13 hp and 44 lb-ft of torque for a boost of acceleration off the line, or during passing. It also allows the engine to run in four-cylinder mode for longer periods of time. eAssist uses regenerative braking to help power onboard electrical systems, and adds start/stop to the powertrain. Finally, the so-equipped trucks have a six-percent improvement in aerodynamics, thanks to a soft tonneau cover and active grille shutters in the front fascia. Great news is, the eAssist option is relatively inexpensive, only costing $500. But good luck getting your hands on one.

We really want to use an eCrate to restomod an old GM car. Here's what we'd build

You hopefully saw the news today of GM's introduction of its Connect and Cruise eCrate motor and battery package, which effectively makes the Bolt's electric motor, battery pack and myriad other elements available to, ah, bolt into a different vehicle. It's the same concept as installing a gasoline-powered crate motor into a classic car, but with electricity and stuff.  This, of course, got us thinking about what we'd stuff the eCrate into. Before we got too ahead of ourselves, however, we discovered that the eCrate battery pack is literally the Bolt EV pack in not only capacity but size and shape. In other words, you need to have enough space in the vehicle to place and/or stuff roughly 60% of a Chevy Bolt's length. It's not a big car, but that's still an awful lot of real estate. There's a reason GM chose to simply plop the pack into the bed and cargo area of old full-size SUVs. Well that, and having a rear suspension beefy enough to handle about 1,000 pounds of batteries.  So after that buzz kill, we still wanted to peruse the GM back catalog for classics we'd love to see transformed into an electric restomod that might be able to swallow all that battery ... maybe ... possibly ... whatever, saws and blow torches exist for a reason.  1971 Buick Riviera Consumer Editor Jeremy Korzeniewski: If you’re going to build an electric conversion, why not do it with style? ThatÂ’s why IÂ’m choosing a 1971-1973 Buick Riviera. You know, the one with the big glass boat-tail rear end that ends in a pointy V. Being a rather large vehicle with a big sloping fastback shape, IÂ’m hoping thereÂ’s enough room in the trunk and back seat to pack in the requisite battery pack. That would likely require cutting away some of the metal bulkhead that supports the rear seatback, but not so much that a wee bit of structural bracing couldnÂ’t shore things up. The big 455-cubic-inch Buick V8 up front will obviously have to go. Remember, this was the 1970s, so despite all that displacement, the Riviera only had around 250 horsepower (depending on the year and the trim level). So the electric motorÂ’s 200 horsepower and 266 pound-feet of torque ought to work as an acceptable replacement.   1982 Chevrolet S10 Associate Editor Byron Hurd: OK, so the name "E-10" is already taken by a completely different truck, but let's not let labels get in the way of a fun idea.