2014 Chevrolet Impala Lt on 2040-cars

Auto blog

Next-gen Chevy Silverado and GMC Sierra may use carbon fiber

It's been generally accepted that the next generation of full-size GM trucks will use some sort of strong, lightweight material for the beds while retaining steel for the cab. While aluminum seems like the most obvious choice, according to Automotive News, the Chevy Silverado and GMC Sierra will incorporate both aluminum and carbon fiber in their beds. The publication cites sources from within GM, though it seems the introduction of this comparatively exotic material mix is still a few years off. While carbon fiber is both stronger and lighter than steel and aluminum, it takes significantly more time and money to produce, essentially relegating the material to small-volume cars. The main benefit for trucks is the resulting reduction in weight to improve fuel economy without sacrificing the tough, rugged capabilities truck buyers expect. The Ford F-150 made the switch to aluminum for the 2015 model year and it's proved highly successful. It seemed like it was only a matter of time before the competition followed suit. Automotive News says that the next-gen trucks will launch with aluminum beds and that it will take a couple of years before we'll see any carbon fiber incorporated into the design. Even then, only look for the composite material on higher-trim models, with a trickle down to lower-spec trucks possible further in the future. In 2011, GM announced it was working with Japan-based Teijin Limited on a carbon fiber reinforced thermoplastic. There's a good chance that material's introduction will be on trucks. Related Video: News Source: Automotive News Plants/Manufacturing Rumormill Chevrolet GM GMC Truck

Junkyard Gem: 1988 Chevrolet Spectrum Sport Coupe

Before General Motors created the Geo brand for cars built or designed by its overseas partners, the Chevrolet Division put its badges on U.S.-market versions of the Toyota Corolla Sprinter, the Suzuki Cultus and the Isuzu Gemini. Those cars were known as the Nova, the Sprint and the Spectrum, and all became Geos starting with the 1989 model year. Today's Junkyard Gem is one of the last Chevy Spectrums ever sold, found in a Denver self-service yard a few months ago. Midway through 1988, the Chevrolet Spectrum abruptly became the Geo Spectrum and was assigned to the 1989 model year. This car was built in May 1988, making it one of the very last of the pre-Geo Spectrums. The Chevrolet/Geo Spectrum was available as a four-door sedan and as a three-door hatchback, from the 1985 through 1989 model years. For 1988 only, a Spectrum Sport Coupe package, featuring some trim upgrades and these rad decals, could be had on the hatchback. This car was essentially identical to its Isuzu-badged counterpart, the I-Mark. In 1988, the MSRP for the cheapest possible Chevy Spectrum hatchback (the stripped-down Spectrum Express) was $6,495, while its somewhat better-equipped I-Mark twin started at $7,439 (that's $17,128 and $19,617 in 2023 dollars). Meanwhile, the base Hyundai Excel hatchback listed at $5,295 and the Yugo GV cost a hilarious $4,199 ($13,963 and $10,941 in today's money). Power came from this 1.5-liter SOHC four-cylinder, rated at 70 horsepower. A turbocharged version with 110 horsepower was available as well. You could get an automatic transmission in the Spectrum, but this car has the base five-speed manual. This car didn't get the optional air conditioning, but at least it has the traditional Isuzu HVAC control icons featuring blow-dried hair and high-heeled dominatrix boots. Just over 170,000 miles on the odometer. Someone installed a pretty good (for the 1980s) Blaupunkt Charlotte CR148 cassette deck in the dash. This was a necessity if you wanted to enjoy full appreciation of the music of the era. The Spectrum is special! It's as slick as city rain. "I didn't spend a lot of money but with my Spectrum it looks like I did." Joe Isuzu mocked Toyota salesmen when pitching the I-Mark. As was nearly always the case during the 1980s, the JDM ads for the same car were much more fun. They should have recreated this commercial with Spectrums.

Former Fisker CEO has some advice for Tesla Motors

Former Fisker Automotive CEO and ex-Chevrolet Volt vehicle-line director Tony Posawatz has some words of caution for Tesla Motors. The long-time automaker executive questions the California automaker's long-term viability – and gives some praise – in a talk with Benzinga, which you can listen to below. While the all-wheel-drive D that Tesla unveiled earlier this month in Southern California wowed a packed crowd, Posawatz (starting at around minute 4:45 in the interview) says Tesla would've been better off taking the resources it expended toward that Model S upgrade and directed them towards speeding up the development of a more affordable plug-in. Perhaps a number of investors agreed, since the company's stock fell the day after the D was announced. Posawatz says Tesla has been over-reliant on the sale of ZEV credits. Posawatz also says that Tesla has been over-reliant on the sale of zero-emissions vehicle credits in California for its earnings and questions whether the automaker will ever work at a large enough scale to sufficiently drive down costs and make consistent profits. Tesla CEO Elon Musk would take issue with this characterization. Posawatz first made his mark in the plug-in vehicle world when he was the vehicle-line director at General Motors for the Volt extended-range plug-in from 2006 to 2012. Later that year, he joined extended-range plug-in maker Fisker Automotive as its CEO, though quit that job during the summer of 2013 as the company was descending into insolvency. He joined the Electrification Coalition this past March. News Source: Benzinga Green Chevrolet Fisker Tesla Electric PHEV Tony Posawatz